Hobie V2 Drum User Manual

1
Assembling the new Mirage Drive drums and cables  
Caution: The new cables and drums are slotted for easier maintenance and  
tune ups. They are not interchangeable with the older parts.  
Warning: If cables are installed incorrectly, they may twist off the drums,  
causing the Drive to fail.  
Tip: DO NOT REUSE Nyloc nuts when installing new cables. The slotted cable  
threads have 40% less area -- worn Nylocs may back out causing Drive failure or  
adjustment problems.  
Tools and materials required:  
7/16 inch wrench  
needle nose pliers  
Marine grade axle grease  
Preparation:  
1. Remove old drums, cables and chains  
2. Wipe drum axle clean  
3. Pre-install crank arms to the drums, noting left and right crank arms  
Installation:  
1. Install new chains / cables on  
sprockets, taking care to press chain  
solidly into master cog (Plastic sprockets  
only). This may be accomplished with the  
masts and fins on or off. Verify that chain  
is properly centered. (Tip: mark center  
3
Vise method:  
3 B. Secure Drive to vise by rear  
portion as shown. Use a rag in  
vise to prevent marks (rag  
removed for illustration purposes,  
right).  
4 B. Mount both drum / crank arm  
assemblies to drum shaft, noting  
correct left and right side.  
5 B. Mount the rear sprocket cable. Note, the cable is first inserted from the  
side, with the help of needle nose pliers if necessary, then re-routed over the top  
lip of the drum. Hand thread Nyloc nuts enough to keep the cable from slipping  
out (below).  
6
B. Repeat procedure with the front sprocket cable.  
7 B. Insert idler cable into lower rear  
drum hole as shown. Note, the idler  
slot is divided -- use the outboard  
portion only (right).  
4
8. (both methods) Tighten and tune all cables. Make sure they are running  
properly on the drums (below). Align and center fins as necessary.  
Troubleshooting:  
1. Cable wanders off drum. Cable is twisted. Remount, removing twist or  
warping cable toward inboard side of drum.  
2. Cable appears to be uneven. Recheck center link of chain is mounted on  
center cog. Make sure chain is fully pressed in, particularly the center cog.  

Braun practica 130 User Manual
Bushnell Binoculars 260332 User Manual
Canon MD 215 User Manual
Cuisinart DLC 2007NC User Manual
GE 681131691192 User Manual
Genius Car Video System ISO XFR 100W User Manual
Hasselblad CF22 CF39 User Manual
HP (Hewlett Packard) Hewlett Packard Car Video System LA2205WL User Manual
JL Audio Slampak SB POL RGRRZR User Manual
JVC Everio Digital Camcorder GZMS120RUS User Manual