Single Seat Trailer
Owner’s manual
and
safety instructions
ASSEMBLY INSTRUCTIONS
1A
1B
1A.
1B.
Remove all of the contents from inside the carton and place them on a clean flat surface. Check all the
contents against the parts list on page1. Check the contents also for damage.
Set the wheels to the side and remove the black plastic protective caps from the ends of the axles.
Remove the rain canopy and flag pole assembly from inside the trailer.
STEP 2 Assemble the canopy frame
2A
2B
2C
Q/R safety pin
Q/R safety pin
2A.
Lift the left side panel with the frame joiner housing upward so that the right side panel is visible.
Lift the right side panel to expose the crossbar and slide the crossbar through the sling seat.
Locate the end of the crossbar into the joiner housing on the left panel.
2B.
2C.
Insert the quick release safety pin through the end of the cross bar & joiner housing and snap closed.
Insert the quick release safety pins through the front and rear of each panel at the base and snap closed to
secure the sides.
WARNING Ensure all 5 quick release safety pins are securely locked before continuing!
STEP 3 Adjust the sling seat
3A
3B
Area of
detail in
photo 3B
3A.
3B.
Front view of the trailer with the crossbar secured in place.
To provide more comfort, the sling seat can be adjusted by pulling on one or both sets of straps that run
underneath the bottom of the seat. Loosen the straps to allow the trailer to fold flat.
STEP 4 Attach the 2-in-1 canopy
4
4.
Lay the canopy over the top of the trailer frame with the large window toward the front.
Fold back the top edge of the canopy and attach the two rear snaps.
Seal the canopy to the rear flap with the hook & loop tape.
STEP 5 Complete the 2-in-1 canopy attachment
5A 5B
5C
5A.
5B.
5C.
Attach the two snaps at the front corners of the canopy, and join the front flaps.
The rain shield may be rolled down by undoing the elastic loops.
Secure the rain shield along the bottom edge of the 2-in-1 canopy.
STEP 6 Attach the wheels to the quick-release brackets and make sure they are secure
6A
6B
6C
6A.
6B.
6C.
Locate the rear wheel brackets on each side of the trailer and read the warnings carefully.
Push one wheel axle completely through the bracket hole until you hear the axle click into place.
IMPORTANT! Pull firmly on each wheel to ensure the lock mechanisms are securely engaged!
STEP 7 Extend and secure the tow bar
7A
7B
7C
7D
Bracket
7A.
7B.
7C.
7D.
Lay the trailer on its side with the tow bar at the top and undo the lock pin from the bracket.
Pivot the tow bar all the way forward until the shaft comes to rest in the front part of the bracket.
Insert the lock pin shaft all the way through the forward holes in the bracket and tow bar.
Hook the loop over the end of the shaft and make sure the pin is secure.
STEP 8 Coupler attachment for bikes with rear hub nuts.
(Note: If your bicycle rear wheel has a quick-release rear axle please proceed to Steps 10 & 11)
8A
8B
8C
8D
8A.
8B.
Loosen the rear bike hub nut with a wrench.
Remove the hub nut and washer from the bike.
8C. Position the coupler plate over the axle. Replace the bike hub nut and washer and tighten by hand.
8D. Tighten the bike hub nut securely with a wrench.
STEP 9 Attach trailer tow bar to bike
9A
9B
9C
9D
9A.
9B.
Tighten the bike hub nut securely with a wrench.
Locate the front end of the tow bar around the coupler.
9C. Push the quick release pin through the holes in the tow bar and the coupler and fasten securely.
9D. Loop safety strap around bike frame and clip the end into the “D” ring at the end of the tow bar.
WARNING Safety strap must be attached to the bike frame when using this product in trailer mode.
STEP 10 Coupler attachment for bikes with quick-release rear axles.
10A
10B
10C
10D
10A.
10B.
Flip open the quick-release lever, and remove the nut and spring from the opposite side.
Hold the lever and pull the axle skewer with spring out.
10C. Completely remove the skewer but leave the wheel in place.
10D. Slide the coupler plate and tab washer onto the skewer. IMPORTANT! The larger diameter end of the conical
face outwards, towards the QR lever.
spring should
STEP 11 Attach trailer tow bar to bike
11A
11B
11C
11D
11A.
11B.
Insert end of skewer back through wheel hub.
Replace the spring (wide end out) over the end of the skewer, followed by the nut. Tighten the nut by hand
and clamp the lever down (F).
11C. Insert the end of the trailer tow bar into the large hole and fasten the Q/R pin.
11D. IMPORTANT! Loop the safety strap around the bike frame and clip the end into the “D” ring at the end of the
tow bar (H).
WARNING Safety strap must attach to the bike frame when using this product in trailer mode.
STEP 12 Install the safety flag
12A
12B
12C
Flag pole
Sleeve
12A.
12B.
Connect the flagpole sections and find the small opening near the top left edge of the canopy.
Slide the end of the flagpole through the opening in the canopy.
12C. Slide the pole all the way down into the flag pole sleeve near the rear corner.
WARNING Always use the safety flag when pulling this trailer!
STEP 1 Proper use of the 5-point safety harness for one child
WARNING To avoid serious injury, the child should always wear the seat belt and shoulder straps!
Proper seating position for child
Undo the lap belt buckle and seat the child in the centre of the trailer/stroller.
Buckle the lap belt over the child’s lap, and pull the strap until the belt is snug.
Place the two centre shoulder straps over the child’s shoulders, and clip both straps into the “D” ring of the
centre crotch strap.
Adjust the shoulder strap height according to the height of the child, then pull the straps until they are snug.
IMPORTANT! Adjust the straps so that the crotch strap and shoulder straps meet at the child’s
stomach level, not at chest level!
Clip the outer shoulder strap on either side into the “D” ring of the outer crotch strap directly below. This will
keep the straps that are not in use out of the way.
Entering and exiting the passenger compartment
1. Unclip the front panel clasps near the front corners of the trailer/stroller.
2. Fold the front flap down and underneath the trailer/stroller so that it is out of the way.
3. Assist children as they enter and exit the passenger compartment.
REMOVAL, DISASSEMBLY, AND STORAGE INSTRUCTIONS
Removal of the trailer from the bike
1. Remove children from inside the passenger compartment.
2. Unclip the tow bar safety strap from the “D” ring.
3. Loop the strap back around the bike frame tube so that the strap is free of the bike frame.
4. Clip the end of the strap back on to the tow bar “D” ring.
5. Remove the quick-release pin from the tow bar coupler.
6. Slide the tow bar out of the tow bar coupler plate and re-insert the quick-release pin into the holes at the
end of the tow bar. The coupler plate may remain attached to the bike.
7. Set the front end of the trailer on the ground.
Storage
1. Remove the flag and pole and separate the pole sections.
2. Remove the rear wheels and set them to the side.
Release lever
The release levers are located between the wheel bracket plates below the frame near the rear of the trailer. There is
one lever on each bracket. They can be accessed from the rear.
Release the axle by pulling the release lever straight out and holding it in place.
Slide the wheel out of the bracket, then let go of the lever. Repeat for the other wheel.
3. Remove the quick-release pin from the tow bar bracket at the front corner of the trailer.
4. Fold the tow bar back underneath the trailer, and replace the quick-release pin through the tow bar and
bracket.
5. Place all loose items inside the passenger compartment, and close the rain cover.
6. Release the quick release safety pins on the canopy sides and top and carefully fold the trailer
compartment flat. Use caution to avoid getting pinched!
7. Store the trailer in a dry place. If the storage area will get hot, release some of the air from the tyre inner
tubes to prevent excessive expansion or popping.
WARNING Do not use cleaning solvents! Clean only with mild soap and water!
Prior to each use
WARNING Ensure you bicycle is in good working order before use and certainly before attaching this trailer.
Pay particular attention to the brakes, wheels and steering.
Make sure that all parts are in good working order, and that no parts are missing. Do not use this product if
any parts are broken or missing!
Check all components and aspects of this trailer before each use. Pay particular attention to the connecting
devices; frame; safety harness; tyres and wheels for safe condition.
Check that all fasteners and bolts are securely tightened.
If you have any questions concerning the proper use of this product after it has been stored, please contact a
qualified technician.
SAFE TOWING TIPS
WARNING Use a foot pump or hand pump to inflate tyres! Pressurized air hoses can cause over-inflation!
WARNING Accessories or parcels placed in trailer/stroller may cause it to become unstable!
WARNING Never use this trailer/stroller if it becomes damaged!
WARNING To avoid serious injury, children should always wear the seat belt and the shoulder straps!
WARNING Never leave children unattended in or around this trailer!
WARNING Make sure your bike brakes work properly! Braking distance is increased when pulling a trailer!
WARNING This trailer is wide! Allow extra clearance near kerbs, signs, parked cars, and other obstacles!
WARNING A bicycle with trailer attached requires a wide turning radius! Do not turn sharply!
WARNING Each child must wear an approved safety helmet when riding in this product in trailer mode!
WARNING Never remove protective canopy when children are in the trailer!
WARNING Always use the safety flag when pulling this trailer!
WARNING When pulling one child in the trailer, seat him/her in the centre!
WARNING Do not ride over kerbs! Avoid bumps and holes! Always signal your turns!
WARNING Use extra caution when turning on uneven road surface, and going downhill!
WARNING Not for use at high speeds! Do not exceed 10 MPH!
WARNING Never ride a bike or pull this trailer at night!
WARNING Be aware of exposure hazards such as wind-chill and heat exhaustion by less-active trailer passengers
in prolonged exposure in colder temperatures, or by extended periods in warmer temperatures without adequate
ventilation and hydration.
If you have any questions about the safe use or assembly of this product, please contact one of our Customer Service
Representatives on 01332 274242
|