Fusion Electronics Car Amplifier CP AW2120 User Manual

ACTIVE WEDGE  
CP-AW1120, CP-AW2120  
SPECIFICATIONS  
CP-AW1120  
CP-AW2120  
900  
Peak Power (Watts)  
Rated Power (Watts)  
Frequency Response  
Low Pass Filter (Variable)  
Tuning  
750  
250  
300  
32Hz - 250Hz  
40Hz - 250Hz  
Bass Reflex  
12”  
32Hz - 250Hz  
40Hz - 250Hz  
Bass Reflex  
Dual 12”  
Woofer Size  
Fuse  
25A  
30A  
Dimensions (mm)  
567(l) x 415(w) x 384(h)  
22-5/16 x 16-11/32 x 15-3/32” 32-29/32 x 16-11/32 x 15-3/32”  
836(l) x 415(w) x 384(h)  
DISCLAIMER  
Always ensure the Active Wedge is securely attached, to avoid movement. FUSION accepts no responsibility for damage or injury in relation  
to inappropriate securing of this product.  
CONTROL DESCRIPTIONS  
WIRING  
• Connect the ground wire to the vehicle first (clean dirt and paint  
to bare metal).  
• Connect the remote on (blue wire).  
• Connect the RCA cables if applicable, OR  
• Connect the speaker level wire by splicing into the headunits  
speaker wires. See Note 1 on reverse.  
LEVEL  
This allows the adjustment of the amplifier level of the subwoofer.  
Turn clockwise to increase the level. If the sound becomes distorted  
reduce the level.  
LOW PASS FILTER (LPF)  
• Connect the remote level controller with the supplied lead.  
• Connect the 12 volt (red wire) to the positive battery terminal.  
• Check all connections.  
This allows the adjustment of the highest frequency the Active  
Wedge will produce. This should be adjusted to blend with your main  
speakers. Typically, this will be set to around 100Hz (approximately  
the central position of the control knob).  
REMOTE LEVEL CONTROLLER  
When connected, this allows further control over the level from a  
remote location, using the supplied lead.  
INSTALLATION  
Make sure the Active Wedge is firmly fixed in your vehicle. Check  
before drilling or cutting holes. DO NOT work near gas tanks, fuel  
lines, hydraulic lines or electrical wiring.  
DO NOT mount the Active Wedge in such a way as to pinch or  
damage the wires.  
Make sure everything is firmly connected, before attaching the  
+12V wire. Ensure the +12V wire is fused as close as possible to the  
battery. Always use a fuse with the recommended rating.  

Adder Technology X100 User Manual
Alpine TDM 7580R User Manual
ARRI ULTRA 16 User Manual
Atlantis Land I See S 150 User Manual
Audiovox 128 5495E User Manual
Canon Hf R400 Flash Memory Camcorder 8155B004 User Manual
Canon Vixia Hf G20 Camcorder 8063B002 User Manual
Cary Audio Design CAD 300 SE User Manual
JBL GTO1020 User Manual
JVC GR DVL410 User Manual