Fusion Electronics Car Amplifier CP AW1120 User Manual

ACTIVE WEDGE  
CP-AW1120, CP-AW2120  
SPECIFICATIONS  
CP-AW1120  
CP-AW2120  
900  
Peak Power (Watts)  
Rated Power (Watts)  
Frequency Response  
Low Pass Filter (Variable)  
Tuning  
750  
250  
300  
32Hz - 250Hz  
40Hz - 250Hz  
Bass Reflex  
12”  
32Hz - 250Hz  
40Hz - 250Hz  
Bass Reflex  
Dual 12”  
Woofer Size  
Fuse  
25A  
30A  
Dimensions (mm)  
567(l) x 415(w) x 384(h)  
22-5/16 x 16-11/32 x 15-3/32” 32-29/32 x 16-11/32 x 15-3/32”  
836(l) x 415(w) x 384(h)  
DISCLAIMER  
Always ensure the Active Wedge is securely attached, to avoid movement. FUSION accepts no responsibility for damage or injury in relation  
to inappropriate securing of this product.  
CONTROL DESCRIPTIONS  
WIRING  
• Connect the ground wire to the vehicle first (clean dirt and paint  
to bare metal).  
• Connect the remote on (blue wire).  
• Connect the RCA cables if applicable, OR  
• Connect the speaker level wire by splicing into the headunits  
speaker wires. See Note 1 on reverse.  
LEVEL  
This allows the adjustment of the amplifier level of the subwoofer.  
Turn clockwise to increase the level. If the sound becomes distorted  
reduce the level.  
LOW PASS FILTER (LPF)  
• Connect the remote level controller with the supplied lead.  
• Connect the 12 volt (red wire) to the positive battery terminal.  
• Check all connections.  
This allows the adjustment of the highest frequency the Active  
Wedge will produce. This should be adjusted to blend with your main  
speakers. Typically, this will be set to around 100Hz (approximately  
the central position of the control knob).  
REMOTE LEVEL CONTROLLER  
When connected, this allows further control over the level from a  
remote location, using the supplied lead.  
INSTALLATION  
Make sure the Active Wedge is firmly fixed in your vehicle. Check  
before drilling or cutting holes. DO NOT work near gas tanks, fuel  
lines, hydraulic lines or electrical wiring.  
DO NOT mount the Active Wedge in such a way as to pinch or  
damage the wires.  
Make sure everything is firmly connected, before attaching the  
+12V wire. Ensure the +12V wire is fused as close as possible to the  
battery. Always use a fuse with the recommended rating.  

Alpine CDA 7969R User Manual
Baxi Potterton Performa 24 Eco HE User Manual
Bunn TDO 4 User Manual
Canon MV10I User Manual
Clarion VXZ758R User Manual
Fluke 9933 User Manual
Gitzo GT2540EX User Manual
Hypertec N16178PHY User Manual
Jabra AVAYA X ONE GN1215 User Manual
JVC GET0582 001A User Manual