XD5125
INSTALLATION/OWNER'SꢀMANUAL
AM/FM/CDꢀReceiver
XD5125ꢀINSTALLATION
Installation
TYPICALꢀMOUNTINGꢀMETHOD
3
XD5125ꢀINSTALLATION
WiringꢀDiagram
5 AMP
FUSES
When replacing fuses,
make sure new fuse is the
correct type and amperage.
Using an incorrect fuse
could damage the radio.
The XD5125 uses one 5
amp AGC fuse (Battery)
and one 0.5 amp AGC fuse
(Ignition) located in-line.
* Caution - Do not attach any speaker leads to ground as severe damage will occur.
4
XD5125ꢀOPERATION
ControlꢀLocations
1
5
3
2
4
6
7
19
17
15
18
16
14
13
12
11
10
9
8
1
10
11
12
13
14
15
Release
Tuning
Volume Up
Mode
EQ
2
3
4
5
6
7
Display
Track Up
Track Down
Mono/Stereo/CD Intro
Mute
Audio
Local/Distance/CD Repeat
Loudness/CD Random
Play/Pause
Eject
16
Auxiliary Input
Band
8
9
17
18
Volume Down
19
Power
5
XD5125ꢀOPERATION
GeneralꢀOperation
FaceplateꢀRemoval
PowerꢀOn/Off
Mode
Press RELEASE and pull away from the left side to
remove. To re-install, insert right side of faceplate first
then push left side to secure.
Press POWER to turn the unit on. Inserting a CD will
turn the unit on automatically. Press POWER to turn the
unit off.
Press MODE to select between AM/FM, CD player or
auxiliary input. Modes of operation are indicated in the
display.
Note:ꢀCD only appears when a CD is inserted.
Loudness
Press LOUD to activate and deactivate bass boost
curve. Activating this feature will enhance the bass
frequencies when listening to music at all volumes.
Note: The instructions above apply to Tuner and
Auxiliary input modes. The activate/deactivate the
Loudness feature while in CD mode, press and hold
LOUD for more than 2 seconds.
Volume
Mute
Press VOLUMEꢀ+ or VOLUMEꢀ-ꢀto adjust volume (0-63).
Press MUTE to silence the audio.
Press MUTE again to cancel.
Display
Press DISP to display the clock for five seconds. The
radio frequency (tuner mode) or CD elapsed time/track
(CD player mode) show by default.
AuxiliaryꢀInput
Insert 3.5 mm plug to connect your portable audio
device.
6
XD5125ꢀOPERATION
GeneralꢀOperation
SetꢀtheꢀClock
PresetꢀEQꢀCurves
Audio
Press and hold DISP until the clock begins to flash,
then release. Press TRACKꢀꢀꢀꢀꢀꢀꢀꢀ to adjust the hours
and TRACKꢀꢀꢀꢀꢀꢀꢀ to adjust the minutes. Press DISP
momentarily to save the selected time.
Press EQꢀto select between POP, CLASSIC, ROCK
and OFF (default) equalization curves. The Bass and
Treble settings are not adjustable when an EQ curve
is selected.
Press AUDIO to select between Volume (default), Bass,
Treble, Balance & Fader.
VOLUME
BASS TREBLE
BALANCE
FADER
ꢀ
Bass
Press AUDIO until BAS appears.
Press VOLꢀ- or + to adjust.
(-7 minimum / 7 maximum)
Treble
Balance
Fader
Press AUDIO until TRE appears.
Press VOLꢀ- or + to adjust.
(-7 minimum / 7 maximum)
Press AUDIOꢀuntil BAL appears.
Press VOLꢀ-ꢀ(LEFT)ꢀor + (RIGHT) to adjust.
(BA.L 10/BA.R 10) BAL 0 represents equal balance.
Press AUDIO until FAD appears.
Press VOLꢀ- (FRONT)ꢀor +ꢀ(REAR)ꢀto adjust.
(FA.F 10/FA.R 10) FAD 0 represents equal fader.
7
XD5125ꢀOPERATION
TunerꢀOperation
Tuning
FMꢀMono/Stereo
Local/Distance
Turn the rotary encoder to tune the unit up or down
and select the desired station.
Press MONO during FM tuner operation to select mono
or stereo (default) reception of the broadcast signal.
Press LOC during FM tuner operation to activate local
tuning for strong station reception only. Press LOC
again to cancel and resume Distance tuning (default).
Bandꢀ Press BAND to select between FM and AM bands.
8
XD5125ꢀOPERATION
CDꢀPlayerꢀOperation
InsertꢀCD
EjectꢀCD
With the label facing up, insert a disc into the CD slot.
The CD will automatically begin playback.
Press the EJECT button to stop and eject CD. The unit
will change to tuner mode. If the disc is not removed
within 10 seconds, the unit will reload the disc.
TrackꢀSelect
Press TRACK
track. Press TRACK
to skip to the beginning of the next
to return to the beginning of
the current track. Pressing TRACK
again skips to
the beginning of the previous track.
FastꢀForwardꢀ Press and hold TRACK
or TRACK
to fast
andꢀReverse
forward or reverse a track.
Pause
Press
Press
/
/
II to temporarily stop CD playback.
l
l
II again to resume playback.
Intro
Repeat
Press INT to play the first 10 seconds of each track.
Press INT to cancel.
Press RPT to continuously repeat selected track.
Press RPT to cancel.
Random
Loudness
Press RDM to play all tracks in random order. Press
RDM again to cancel.
Press LOUD for more than two seconds to activate/
deactivate the Loudness feature during CD play.
CD-R/CD-RWꢀ Some CD-Rs and CD-RWs may be incompatible with
Compatibility
this unit, depending on media type and recording
method.
9
XD5125ꢀWARRANTY
LimitedꢀOneꢀYearꢀWarranty
This warranty gives you specific legal rights.
You may also have other rights which vary from
state to state.
What to do?
1. Before you call for service, check the
troubleshooting guide in your owner’s
manual. A slight adjustment of any custom
controls may save you a service call.
Dual Electronics Corp. warrants this product to
the original purchaser to be free from defects in
material and workmanship for a period of one
year from the date of the original purchase.
2. If you require service during the warranty
period, you must carefully pack the product
(preferably in the original package) and ship
it by prepaid transportation with a copy of the
original receipt from the retailer to an
authorized service center.
Dual Electronics Corp. agrees, at our option,
during the warranty period, to repair any defect
in material or workmanship or to furnish an
equal new, renewed or comparable product
(whichever is deemed necessary) in exchange
without charges, subject to verification of the
defect or malfunction and proof of the date of
purchase. Subsequent replacement products
are warranted for the balance of the original
warranty period.
3. Please describe your problem in writing and
include your name, a return UPS shipping
address (P.O. Box not acceptable), and a
daytime phone number with your shipment.
4. For more information and for the location of
the nearest authorized service center please
contact us by one of the following methods:
Who is covered? This warranty is extended to
the original retail purchaser for products
purchased and used in the U.S.A.
• Call us toll-free at 1-866-382-5476
• E-mail us at [email protected]
What is covered? This warranty covers all
defects in material and workmanship in this
product. The following are not covered:
installation/removal costs, damage resulting
from accident, misuse, abuse, neglect, product
modification, improper installation, incorrect
line voltage, unauthorized repair or failure to
follow instructions supplied with the product,
or damage occurring during return shipment
of the product.
Exclusion of Certain Damages: This warranty
is exclusive and in lieu of any and all other
warranties, expressed or implied, including
without limitation the implied warranties of
merchantability and fitness for a particular
purpose and any obligation, liability, right,
claim or remedy in contract or tort, whether
or not arising from the company’s negligence,
actual or imputed. No person or representative
is authorized to assume for the company any
other liability in connection with the sale of
this product. In no event shall the company be
liable for indirect, incidental or consequential
damages.
10
XD5125ꢀOPERATION
Specifications
CDꢀPlayer
FMꢀTuner
Frequency response: 20Hz-20kHz
Channel separation @ 1kHz: >50dB
D/A converter: 1ꢀBit
Tuning range: 87.5MHz-107.9MHz
Usable sensitivity: 15dBf
50dB quieting sensitivity: 23dBf
Stereo separation @ 1kHz: 25dB
Frequency response: 80Hz-10kHz
AMꢀTuner
General
Tuning range: 530kHz-1720kHz
AM sensitivity: 30uV
Frequency response: 80Hz-1.8kHz
Operating voltage: 11-16ꢀVDC,ꢀnegativeꢀground
Speaker output impedance: 4~8ꢀohms
Fuses: 0.5ꢀampꢀfastꢀblowꢀAGC,ꢀ5ꢀampꢀfastꢀblowꢀAGC
Dimensions: 7"ꢀxꢀ7"ꢀxꢀ2"ꢀ(178ꢀxꢀ178ꢀxꢀ51ꢀmm)
Design and specifications subject to change without notice.
CEA-2006 Power Standard Specifications
(reference: 14.4VDC +/- 0.2V, 20Hz~20kHz)
Power Output: 5 Watts RMS x 4 channels at 4 ohms and < 1% THD+N
Signal to Noise Ratio: 80dBA (reference: 1 watt into 4 ohms)
11
XD5125ꢀOPERATION
Troubleshooting
Problem
Cause
Action
Unitꢀwillꢀnotꢀ Yellow or red wire not connected or Check connections for proper
turnꢀon
(noꢀpower)
incorrect voltage
Black wire not connected
Fuse blown
voltage (11~16VDC)
Check connection to ground
Replace fuse
Unitꢀhasꢀpowerꢀ Speaker wires not connected
Check connections at speakers
(butꢀnoꢀsound)
One or more speaker wires touching Insulate all bare speaker wires
each other or touching chassis
ground
from each other and chassis
ground
Unitꢀblowsꢀ
fuses
Yellow or red wire touching chassis Check for pinched wire
ground
Speaker wires touching chassis
ground
Check for pinched wire
Incorrect fuse rating
Use fuse with correct rating
Excessiveꢀ
skipping
Unit is not mounted correctly or
backstrap is not secure
Check mounting sleeve and
backstrap support
Physical defect in media
(CD, CD-R or CD-RW)
Check media for scratches
Errꢀappearsꢀonꢀ Load/Eject operation error or disc is Press eject
display
in upside down
Dual Electronics Corp.
Toll Free: 1-866-382-5476
©2007 Dual Electronics Corp. All rights reserved.
NSA1107-V01
|