XD1215
INSTALLATION/OWNER'SꢀMANUAL
AM/FM/CD Receiver with Detach Face
XD1215ꢀINSTALLATION
WiringꢀDiagram
FUSE
When replacing the fuse,
make sure new fuse is the
correct type and amperage.
Using an incorrect fuse
could damage the radio.
The XD1215 uses one 5 amp
AGC fuse located in-line.
* Caution - Do not attach any speaker leads to ground as severe damage will occur.
3
XD1215ꢀOPERATION
ControlꢀLocations
1
2
3
4
5
6
7
8
19
16
21
20
18
17
15
14
13
12 11
10
9
Volume Down
Release
EQ
1
2
12
Bass Boost/Mono/Stereo
Preset 6
13
14
15
16
17
18
19
20
21
Volume Up
Display
3
Preset 5
4
Mode
Preset 4
5
Tune/Track Down
Eject
Preset 3/CD Intro
Preset 2/CD Random
Preset 1/CD Repeat
Select
6
7
Tune/Track Up
8
Auto Store/Preset Scan
Auxiliary Input (3.5mm)
Play/Pause/Band
9
Power
10
11
4
XD1215ꢀOPERATION
GeneralꢀOperation
FaceplateꢀRemoval Press RELEASE and pull away from the left side to remove.
To re-install, insert right side of faceplate first then push left
side to secure.
Semi-permanentꢀFaceplateꢀ Remove trim ring and install supplied #1 x 7/32” Phillips head
Installation screw through left side of mounting frame into faceplate.
PowerꢀOn/Off Press PWR or any other button (except eject) to turn the unit
on. Inserting a CD will turn the unit on automatically. Press
PWR to turn the unit off.
Mode Press MODE to select between tuner, CD player and auxiliary
input. Modes of operation are indicated in the display.
AuxiliaryꢀInput Insert a standard 3.5mm connector into the AUX input (not
ꢀ
included). Connect the other end to headphone or line output
of audio device, MP3 player, etc. Press MODE to select AUX
input mode.
BassꢀBoostꢀ Press BASS to activate and deactivate bass boost curve.
Activating this feature will enhance the bass frequencies
when listening to music at low volumes.
Volume Adjust volume using VOL t or VOL s (00-46).
PresetꢀEQꢀCurves Press EQꢀto select between CLASSIC, POP, ROCK and OFF
(default) equalization curves. Any adjustment to the Bass or
Treble settings automatically cancels the current EQ curve (if
one is selected).
Display Press DISP to display the clock. The radio frequency (tuner
mode), CD elapsed time/track (CD player mode) or AUX
(Auxiliary mode) show by default.
SetꢀtheꢀClock Press DISP to display the clock, then release. Press and hold
DISP for 2 seconds, the clock will begin to flash. Press TUNE
<<
>>
to adjust the hours and TUNEꢀ
Clock settings will be saved after 5 seconds.
to adjust the minutes.
5
XD1215ꢀOPERATION
GeneralꢀOperation
12/24-hourꢀClockꢀ
ꢀ
The clock will display 12-hour AM/PM time in USA
frequency spacing mode (PM 10:00). In European frequency
spacing mode, the clock will display 24-hour time (22:00).
Reset
Press the RESET button to reset the unit upon initial
installation or if abnormal operation occurs. The RESET
button is located behind the faceplate.
SelectꢀAudio
Press SEL to select between Volume (default), Bass, Treble,
Balance & Fader.
VOLUME
BASS TREBLE
BALANCE
FADER
ꢀ
Bass
Press SEL until BA appears
Press VOL t or VOL s to adjust
(-7 minimum / 7 maximum)
Treble
Balance
Fader
Press SEL until TR appears
Press VOL t or VOL s to adjust
(-7 minimum / 7 maximum)
Press SEL until B appears
Press VOL t (LEFT) or VOL s (RIGHT) to adjust
(BL 15/BR 15) B 00 represents equal balance.
Press SEL until F appears
Press VOL t (FRONT) or VOL s (REAR) to adjust
(FF 15/FR 15) F 00 represents equal balance.
6
XD1215ꢀOPERATION
TunerꢀOperation
SeekꢀTuning
<< >>
Press TUNEꢀ ꢀorꢀ
station.
momentarily to seek the next strong
<< >>
for more than 2 seconds, then
ManualꢀTuning
Press TUNEꢀ ꢀorꢀ
release. “MANU” will momentarily appear in the display.
<< >>
Press TUNEꢀ ꢀorꢀ
momentarily to move radio frequency
up or down one step at a time. Press and hold to advance
quickly. If tuning is not adjusted for 5 seconds, the unit
will return to seek tuning mode (default). “AUTO” will
momentarily appear in the display.
FMꢀMono/Stereo
Press MO/ST for more than 2 seconds during FM tuner
operation to select mono or stereo (default) reception of the
broadcast signal.
Band
Press BAND to select between FM1, FM2, FM3 and AM1, AM2
bands.
FrequencyꢀSpacing
<<
to select
Press and hold BAND then press TUNEꢀ
European frequency spacing. Press and hold BAND then
>>
press TUNEꢀ
to select USA frequency spacing (default).
Anytime frequency spacing is changed, all station presets
are erased.
ꢀ
StoringꢀandꢀRecallingꢀ
StationꢀPresets
Up to 18 FM stations and 12 AM stations can be stored.
To store a station, select the desired band and station.
Press and hold the desired preset button for more than 2
seconds. When stored, the preset number will appear in the
display. The station can be recalled anytime by pressing the
corresponding preset button.
AutomaticallyꢀStoreꢀ
Stations
Press AS/PS for more than 2 seconds to automatically store
the six strongest stations in the current band.
PresetꢀScan
Press AS/PS for less than 2 seconds to scan presets
1-6 on the current band, pausing for 5 seconds at each.
Press AS/PS again to cancel.
7
XD1215ꢀOPERATION
CDꢀPlayerꢀOperation
InsertꢀCD With the label facing up, insert a standard size CD into the
CD slot. The CD will automatically begin playback.
EjectꢀCD Press the EJECT button to stop and eject the CD. The unit
will change to previous mode of operation (AM, FM, or
auxiliary input). If the disc is not removed within 10 seconds,
the unit will reload the disc. The unit does not have to be
turned on to eject CD.
>>
<<
TrackꢀSelect Press TRACKꢀ
to skip to the beginning of the next track.
to return to the beginning of the current
Press TRACKꢀ
<<
track. Pressing TRACKꢀ
again skips to the beginning of
the previous track.
>>
<<
to fast forward or
FastꢀForwardꢀandꢀReverse Press and hold TRACKꢀ
or TRACKꢀ
reverse a track.
Pause Press
/
/
II to temporarily stop CD playback.
II again to resume playback.
l
l
Press
Intro Press INT to play the first 10 seconds of each track.
Press INT again to cancel.
Repeat Press RPT to continuously repeat selected track.
Press RPT again to cancel.
Random Press RDM to play all tracks in random order. Press RDM
again to cancel. Random mode is retained in memory when
selecting between tuner, CD player and auxiliary input
modes and when the unit is turned on/off.
CD-R/CD-RWꢀ Some CD-Rs and CD-RWs may be incompatible with this
Compatibility unit, depending on media type and recording method.
CD-R recording sessions must be closed (finalized) for
playback.
8
XD1215ꢀOPERATION
Troubleshooting
Problem
Cause
Action
Unit will not turn on
Yellow wire not connected or incorrect voltage
Red wire not connected or incorrect voltage
Check connections for proper voltage
(11~16VDC)
(no power)
Black wire not connected
Fuse blown
Check connection to ground
Replace fuse
Unit has power
(but no sound)
Speaker wires not connected
Check connections at speakers
One or more speaker wires touching each
other or touching chassis ground
Insulate all bare speaker wires from
each other and chassis ground
Unit blows fuses
Yellow or red wire touching chassis ground
Speaker wires touching chassis ground
Incorrect fuse rating
Check for pinched wire
Check for pinched wire
Use fuse with correct rating
Excessive skipping
Unit is not mounted correctly or backstrap is Check mounting sleeve and backstrap
not secure
support
Physical defect in media (CD, CD-R or CD-RW)
CD mechanism position out of alignment
Check media for scratches
Unit will not accept
Press EJECTꢀfor 3 seconds to reset
a disc
CD mechanism position
CD transit screws still in place
Remove 2 transit screws located on top
of the unit.
ErrorꢀCodes
Error Code
ER-1 appears on display
ER-2 appears on display
ER-3 appears on display
Cause
Disc error
Action
Press eject or RESET
Press eject or RESET
Press eject or RESET
Mechanism error
Servo error or disc is in upside down
NOTE:
If you should require additional information or have any performance related questions,
Call us toll-free at 1-866-382-5476
E-mail us at [email protected]
Do not return the unit to the retailer.
9
XD1215ꢀWARRANTY
LimitedꢀOne-YearꢀWarrantyꢀ
This warranty gives you specific legal rights.
You may also have other rights which vary from
state to state.
Whatꢀtoꢀdo?
1. Before you call for service, check the
troubleshooting guide in your owner’s
manual. A slight adjustment of any custom
controls may save you a service call.
Dual Electronics Corp. warrants this product to
the original purchaser to be free from defects in
material and workmanship for a period of one
year from the date of the original purchase.
2. If you require service during the warranty
period, you must carefully pack the product
(preferably in the original package) and ship
it by prepaid transportation with a copy of the
original receipt from the retailer to an
authorized service center.
Dual Electronics Corp. agrees, at our option,
during the warranty period, to repair any defect
in material or workmanship or to furnish an
equal new, renewed or comparable product
(whichever is deemed necessary) in exchange
without charges, subject to verification of the
defect or malfunction and proof of the date of
purchase. Subsequent replacement products
are warranted for the balance of the original
warranty period.
3. Please describe your problem in writing and
include your name, a return UPS shipping
address (P.O. Box not acceptable), and a
daytime phone number with your shipment.
4. For more information and for the location of
the nearest authorized service center please
contact us by one of the following methods:
Whoꢀisꢀcovered?ꢀThis warranty is extended to
the original retail purchaser for products
purchased and used in the U.S.A.
• Call us toll-free at 1-866-382-5476
• E-mail us at [email protected]
Whatꢀisꢀcovered?ꢀThis warranty covers all
defects in material and workmanship in this
product. The following are not covered:
installation/removal costs, damage resulting
from accident, misuse, abuse, neglect, product
modification, improper installation, incorrect
line voltage, unauthorized repair or failure to
follow instructions supplied with the product,
or damage occurring during return shipment of
the product.
Exclusion of Certain Damages: This warranty
is exclusive and in lieu of any and all other
warranties, expressed or implied, including
without limitation the implied warranties of
merchantability and fitness for a particular
purpose and any obligation, liability, right,
claim or remedy in contract or tort, whether
or not arising from the company’s negligence,
actual or imputed. No person or representative
is authorized to assume for the company any
other liability in connection with the sale of
this product. In no event shall the company be
liable for indirect, incidental or consequential
damages.
10
XD1215ꢀOPERATION
Notesꢀ
11
XD1215ꢀSPECIFICATIONS
Specifications
CD Player Frequency response: 20Hz-20kHz
Channel separation @ 1kHz: >65dB
D/A converter: 1 Bit
FM Tuner Tuning range: 87.5MHz-107.9MHz
Usable sensitivity: 12dBf
50dB quieting sensitivity: 16dBf
Stereo separation @ 1kHz: 40dB
Frequency response: 30Hz-13kHz
AM Tuner Tuning range: 530kHz-1710kHz
Usable sensitivity: 30uV
Frequency response: 80Hz-2kHz
General Operating voltage: 11-16 VDC, negative ground
Speaker output impedance: 4~8 ohms
Fuse: 5 amp AGC
Dimensions: 7" x 7" x 2" (178 x 178 x 51 mm)
Design and specifications subject to change without notice.
CEA-2006ꢀPowerꢀStandardꢀSpecifications
(reference: 14.4VDC +/- 0.2V, 20Hz~20kHz)
Power Output: 5 Watts RMS x 4 channels at 4 ohms and < 1% THD+N
Signal to noise ratio: 75dBA (reference: 1 watt into 4 ohms)
Dual Electronics Corp.
Toll Free: 1-866-382-5476
©2008 Dual Electronics Corp. All rights reserved.
NSA0908-V01
|