Thank You for purchasing the
OVR-090BL
9” WIDESCREEN OVERHEAD LCD
USER MANUAL
V1.1
Bravo View Technology
20153 aseo Del rado
Walnut, CA 91789
United States of America
909-869-0699
THANK YOU FOR YOUR URCHASE!
LEASE TAKE A MOMENT TO GET FAMILIAR WITH THE ACKAGE CONTENTS
RODUCT S ECIFICATIONS
RESOLUTION
800 (H) x 480 (V) / PIXELS = 1,152,000
9.0” TFT
LCD SCREEN SIZE
BRIGHTNESS
200 cd/m2 or 200 NIT
RES ONSE TIME
VIEWING ANGLE
AUDIO/VIDEO IN UT
OWER
Rising 30msec /
Falling 50msec
o
o
Top & Bottom = 50 / Left & Right =65
2 Composite Audio/Video (RCA)
DC 12-25vlt, Consumption > 3 amp / 8 Watt Max
O ERATING
o
o
32 – 140 F
TEM ERATURE
UNIT WEIGHT
2 lbs
IM ORTANT INFORMATION
Before operating/installing your LCD Monitor, please read these instructions carefully.
1. Do not remove the Serial Number Label on this unit.
2. Do not use any chemical solvent, cleaning agent or corrosive detergent to clean
away dirt or fingerprints on the surface of the screen. Doing so may cause
irreversible damage to the surface of the LCD Screen. To clean off dirt or
fingerprints, it is recommended that a soft, damp lens cleaning cloth be used
while the unit is off.
3. Avoid installing the monitor screen in a position that is exposed to direct
sunlight and any air vents.
4. Install the unit in a dry location and avoid any area where build up of
condensation is possible. (Ex. Sunroof).
5. Avoid touching or pressing on the LCD screen.
6. Ensure that no foreign objects are in the unit when closing the LCD screen.
7. If the unit overheats, or malfunctions, turn off the power. After the unit has
had adequate time to cool down, turn it on again. If the problem persists,
contact the dealer you purchased the unit from.
8. Keep this owners manual for future reference.
INTRODUCTION
The Bravo View overhead monitors are engineered with advanced technological
designs and components to combine flexibility with reliability, and expandability for
the best picture quality and ease-of-use.
Flexibility
Designed primarily for rear seat entertainment, the audio from your overhead video
system can be enjoyed privately through wireless headphones and/or incorporated
into any car stereo that has an FM radio.
Reliability
High-grade electronic components and heightened electronic connections provide
years of service in extremely harsh, mobile environments.
Expandability
This overhead system has built-in audio/video (A/V) connectors allow you to add up
TWO A/V sources.
INSTALLATION
PROFESSIONAL INSTALLATION RECOMMENDED!
Note: Read the entire instruction manual before beginning installation!
Step A: (Mounting the Bracket to the Headliner)
The enclosed metal bracket (See Figure “A”) needs to be placed between the headliner of the
vehicle and roof. Prior to placement, ensure that there are not any obstructing items (Sunroof,
dome light, any screws etc.) Once you have identified a clear area for the metal bracket and
monitor, drill holes that will accommodate the screws between the monitor and metal plate
through the headliner (See Figure “B”). Prior to any drilling, ensure screws will fit into the metal
bracket securely.
Front of
HOLE PATTERN
SUGGESTIONS
INDICATED BY
ARROWS
Match the metal brace to the overhead LCD
screen to identify the key areas for drilling into
(Top View)
the headliner.
See Below For Illustration of rofile Of Vehicle
INSTALLATION
PROFESSIONAL INSTALLATION RECOMMENDED!
Step B: (Wiring and Final Installation)
With the Metal Bracket securely placed, drill a small hole to accommodate the wiring cable so that
the “Din Cable”, male end is at the area where the monitor will be installed. Ideally, the hole for the
cable should be drilled in the middle of the mounting bracket. The other end of the cable should run
to the area in which you will have your source unit installed (ex. DVD Player).
Connect your SOURCE UNIT to one of the 2 sets of RCA cables (Yellow-Video Signal, Red Audio).
The Red fused wire should be attached to the “Accessory” wire of the vehicle. You can usually
find the “Accessory” lead at the fuse box. Take a voltage meter and test for +12 volt positive
power when the “Accessory” position of the key is turned on at the ignition switch. ALWAYS ENSURE
THAT YOUR ACCESSORY WIRE IS FUSED AT THE SOURCE! Attach the Black wire to any metal part of
the vehicle that is ground.
NOTE:
For Wireless Headphones to
work properly, the White &
Red RCA output must be
Step C: (Mounting)
With the vehicle powered off, mount the monitor into place using the pre-drilled holes (Prior to
installation, always check the clearance of the screw lengths to ensure that you do not puncture the
roof).
REMOTE CONTROL
Remote Control Operating instructions / Battery info
Push Side button of battery cover
and pull out battery.
Replacement Batter = CR 2025
Limited Warranty
Bravo View Technology warrants this product (including any accessory and/or cable) against defects in material or
workmanship as follows:
1. Labor. For a period of 1 Year from original date of purchase, if the product is determined to be defective, Bravo
View will repair or replace the product at no charge.
2. Parts. For a period of 1 Year from original date of purchase, Bravo View will at no charge, replace with new or
rebuilt parts in exchange for defective parts. The warranty will either continue from date of original purchase or
90 days from repair (Whichever is longer).
This warranty does not cover customer misuse, improper installation, poor signal (including any “noise”), cosmetic
damage, damage due by accident, abuse, negligence, commercial use, and improper operation.
Proof of Purchase in the form of a copy of a bill of sale or copy of receipted invoice, which shows clearly the sale of the
unit, is required.
Repair or Replacement as provided under this warranty is the exclusive remedy of the consumer. Bravo View
Technology shall not be liable for any incidental or consequential damage for breach of any express or implied
warranty on this product. In no event shall Bravo View Technology be liable for any incidental or consequential
damage whatsoever arising out of the use or inability to use the product. Under no circumstance shall Bravo View
Technology’s liability exceed the purchase price paid for the product. Except to the extent prohibited by applicable
law, any implied warranty or merchantability or fitness for a particular purpose on this product is limited in duration
to the duration of this warranty.
ROCESS:
1. Contact Bravo View and describe the problem with the unit. Please have your model number, date of
purchase and where it was purchased ready. If requesting on-line, please include your name, address and
telephone number.
2. If determined that the item is warrantable, Bravo View will issue a RA# and provide an address to mail the unit
back to.
3. Bravo View is not responsible for articles lost or stolen during shipping. IT IS ADVISABLE TO SHIP THE UNIT IN
A METHOD IN WHICH YOU CAN TRACK THE PACKAGE, AND POSSIBLY INSURE THE PACKAGE. Bravo View does
not cover the expense of mailing the unit back to us.
4. Once Bravo View receives and validates the unit to ensure it is within warranty, Bravo View will replace the unit,
fix the unit, or offer a substitute of the unit if a replacement is not available. Bravo View may send a
refurbished unit back.
5. Bravo View will mail the unit back to you. To obtain warranty service, you must contact Bravo View
Technologies for a Return Authorization Number (RA#). 866-40-BRAVO or visit www.bravoview.com.
|