R
ALPHASONIK
Owner's Manual
10” Amplified Vented Bass
Enclosure
PBAT10E
T
A
B
L
E
Introduction.................................................................................3
Features and Specifications........................................................4
Choosing a location.....................................................................5
Installation..............................................................................6 - 7
Troubleshooting..........................................................................8
Warning / Disclaimer...................................................................9
Warranty............................................................................10 - 11
Notes..................................................................................12 - 14
O
F
C
O
N
T
E
N
T
S
I
N
T
R
O
D
U
C
T
I
Thank you for purchasing this Alphasonik product. Al-
phasonik products are specifically engineered and designed for
the mobile audio environment. This manual contains important
information about installation, set-up procedures and integrating
your new Alphasonik product into your vehicle. With proper care
and installation, your new product will provide you with many
years of high performance listening enjoyment. We recommend
having an Authorized Alphasonik Dealer install your new prod-
uct for optimal performance and to take advantage of our war-
ranty program. Before installing your new product, please read
through the manual to fully understand the application.
O
N
Before making any electrical connections, make sure
that you disconnect the battery’s ground cable to prevent the
possibility of short circuits or damage to your electronic equip-
ment. If your vehicle’s stereo (head unit) comes with an Anti-
theft code, DO NOT disconnect the battery. If you have the ac-
cess code for the stereo (head unit), please refer to the vehicle’s
owner’s manual.
3
F
E
A
T
U
R
E
S
PBAT10E: 10” Amplified Vented Bass Enclosure
High Quality Constructiion
Rear Facing Tuned Port
&
Black leather Cover
S
P
E
C
I
MOSFET Amplifier
Remote Bass Control Knob
F
I
Low Level and High Level Inputs
Adjustable Low Pass Filter: 40Hz - 250Hz
Adjustable Bass Boost 0 - 18dB
10” Woofer w/ Mineral - Filled Composite Cone
100 Watts RMS
C
A
T
I
O
N
S
Frequency Response of 31Hz - 150Hz
Bumped Back Plate
Extended & Vented Pole Piece
Complete Mounting Hardware & Amp Installation Kit
Dimensions:
Lengh: 26“
Width: 15 3/8”
Height: 14 1/4”
4
C
H
O
O
S
I
It is always best to plan the complete installation prior to attempt-
ing to install any product. The routing of wires, power connections and
mounting locations should be planned first. As with any car stereo instal-
lation, all work performed should be checked thoroughly and carefully
prior to the operation of the system.
N
G
A
The placement of your Alphasonik enclosure within your vehicle
will greatly affect the overall performance of your audio system. Avoid
areas that do not provide a flat, sturdy mounting surface.
L
O
C
A
T
I
NOTE: Alphasonik strongly recommends that you operate your system at
low volumes prior to the completed installation of your Alphasonik enclo-
sure. This will allow a test of the speaker before securing it to its perma-
nent location.
O
N
CAUTION: Make sure that all wiring is fully protected from cuts, tears
and possible wear. Any short circuit developing as a result could severely
damage the source unit or possibly the amplifier. Make sure all wires eas-
ily reach the amplifiers terminal with no stress on the wires or connectors.
MOUNTING:
1.
2.
Confirm the mounting location by inspecting the area where the
enclosure will be mounted.
Before screwing anything double check where all wires are located
and ran. Check underneith the vehicle for gas lines, brake lines,
and gas tank. If there is anything like that we suggest to find an
other location to mount the enclosure.
5
I
N
S
T
A
L
L
A
T
I
Before starting your installation we recommend to disconnect
the battery so there can be no damage done to the electrical system
of the vehicle. Before disconnecting the battery make sure that the
vehicles source unit does not have a password and if so you have the
password in hand to disable the security feature of the source unit.
Make sure your source unit (Cassette, CD, DAT, DVD, etc) is turned off
while connecting the terminals. Turn on the various components and
slowly advance the volume. Remember to check and recheck all con-
nections to insure proper use.
O
N
1.
Alphasonik recommends using the wires that were supplied with
the the kit. Thinner gauge wire may easily be severed and can
cause damage to your system should any bare wire come in
contact with the vehicle’s chassis.
2.
Make sure that your audio system is off while installing and con
necting your new Alphasonik enclosure. Failure to do so could
result in damaging the speaker beyond repair.
3.
4.
Be sure to route the wires to the amplifier where it will be free
from sharp objects.
To insure long-term reliability, all bare wires and wire-to-wire
connections should be soldered and insulated with heat shrink
or electrician’s tape. Under no circumstances should you leave
any bare wires uncovered, as this can and will lead to the dam
age of your speakers.
5.
Once you have tested your system and have confirmed that it is
operating properly, turn off your system and prepare for the final
mounting.
6
I
N
S
T
A
L
L
A
T
I
PROT
PWR
HI-IN
REM
L
REM
PWR
L
R
GAIN
L.P.F
BASS
+12
GND
R
LOW-IN
MIN MAX 40Hz 250Hz
0dB 18dB
Connect to
chassis ground of
vehicle
Splice into source
unit's speaker wires
Connect to positive
lead / (Blue) wire.
O
N
(R+) Gray/White
(R-) Gray
C
O
N
T
I
Negative
Positive
Connect to source unit's
accessory lead or switched
12 volt source
Vehicle Battery
N
U
E
D
HI-IN
REM
L
REM
BASS
L
R
GAIN
+12
GND
R
PWR
0dB 18dB
LOW-IN
PWR
Connect to
chassis ground of
vehicle
Connect to positive
lead / (Blue) wire.
RCA's to
source unit
Positive
Connect to source unit's
accessory lead or switched
12 volt source
Vehicle Battery
BASS BOOST
MIN
MAX
To Bass Boost Knob
7
To Amplified Tube
In the event that your Alphasonik speakers appear to require ser-
vice, we ask that you first do a little troubleshooting
to determine if the problem is actually the speaker or a problem locat-
ed in a different part of the vehicle such as the amplifier, wiring, fusing
or possibly the source unit.
T
R
O
U
B
L
E
If your Alphasonik speakers have been installed professionally by an
Authorized Alphasonik Dealer, we recommend that you return to the
Dealer and demonstrate the problem to a qualified installer or repair
technician. If you installed the speakers yourself, use the following
guidelines to help find the problem:
S
H
O
O
T
I
1. No Sound
N
G
*Check the source unit or amplifier for power and be sure
they are operating properly.
*Check all signal connections.
*Check for any wiring that may be shorting together or
touching the metal chassis.
*Check all ground connections.
2. Distorted Sound At All Volumes
*Check for bad speaker connections.
*Check wiring for correct polarity.
3. Distorted Sound At High Volumes Only
*Check for loose mounting of the speaker.
*Inspect the speaker for debris in the cone or other
obstructions.
4. Poor Bass Response
*Check wiring for correct polarity.
*Check for unstable or loose mounting surface.
*Check Bass and Treble controls at the source unit or
amplifiers.
5. Poor High Frequency Response
*Check wiring for correct polarity.
*Check Treble controls or EQ settings.
*Check the Tweeter for possible damage.
8
Investigate the layout of your vehicle thoroughly before drilling or
cutting. Take care when you work near the gas tank, gas lines, hydraulic
lines, electrical components and electrical wiring. Do not use the equipment
unmounted. Attach this system securely to prevent damage, particularly in
the event of an accident or aggressive driving. Do not mount the system so
that wire connections are unprotected or are subjected to pinching or damage
from nearby objects. Before connecting or disconnecting power connections
at the system power terminals, disconnect the +12V DC wire at the battery
end. Confirm that your source unit and other equipment are turned off while
connecting the input terminals. If you need to replace the power fuse, replace
it only with a fuse identical to the provided fuse. Using a fuse of different type
or rating may result in damage to the system, which is not covered by the
manufacturer’s warranty. Do not install any product where it may be subject-
ed to excessive heat, moisture and dust or where it may be repeatedly kicked,
brushed or bumped. Make absolutely sure that the terminals for the products
are connected to the proper inputs and outputs from the music source. Never
run the wiring on the outside of the vehicle or under it where it can be dam-
aged by road hazards or any moving parts of the vehicle. Use existing wire
channels, sills, panels and molding strips inside the vehicle to hide the wiring
I
N
S
T
A
L
L
A
T
I
O
N
C
O
N
T
I
N
U
E
D
for safety and a neat appearance.
DISCLAIMER
IMPORTANT: Never cut any metal that is an integral part of the
vehicle’s safety or structural support system. If you are unsure, it is best to
have the product professionally installed by an Authorized Alphasonik Dealer.
Never sacrifice your safety for sound.
9
W
A
R
R
A
N
T
Alphasonik, Inc. warrants this product against all defects in material and
workmanship for a period of one (1) year from the date of original purchase
provided it was purchased from an Authorized Alphasonik, Inc. Dealer.
The conditions of this warranty and the extent of the responsibility of Alpha-
sonik, Inc. under this warranty are as follows:
Y
1. DATED PROOF OF PURCHASE IS REQUIRED FOR WAR-
RANTY SERVICE OF THIS PRODUCT. Information about Alphasonik, Inc.
or by contacting or writing Alphasonik, Inc. at the address listed on the back
of this booklet.
2. This warranty will become void if service is performed by any
one other than an approved Alphasonik, Inc. Warranty Service Center.
3. This warranty does not apply to any product which has been
subjected to misuse, neglect or accident, or which has had the warranty
seal broken, serial number altered, defaced or removed, or which has been
connected, installed adjusted or repaired other than in accordance with the
instructions furnished by Alphasonik, Inc.
4. This warranty does not cover car static, electrical interference,
adjustments or labor costs for the removal or reinstallation of the unit for
repair.
5. The sole responsibility of Alphasonik, Inc. under this warranty
shall be limited to the repair or replacement thereof, at the sole discretion of
Alphasonik, Inc.
6. If it becomes necessary to send the product or any defective
part to Alphasonik, Inc. or an authorized service station, the product must
be shipped in its original or equivalent carton, fully insured, with shipping
charges prepaid. Alphasonik, Inc. will not assume any responsibility for any
loss or damage incurred in shipping.
10
7. This warranty is not transferable and protects the original pur-
chaser provided they reside and made their purchase in the United States.
International consumers may contact their local retailer or distributor for war-
ranty information.
W
A
R
R
A
N
T
8. ALL IMPLIED WARRANTIES, EXCEPT TO THE EXTENT PRO-
HIBITED BY APPLICABLE LAW, SHALL HAVE NO GREATER DURATION
THAN THE WARRANTY PERIOD SET FORTH ABOVE. UNDER NO
CIRCUMSTANCES SHALL ALPHASONIK INC. BE LIABLE FOR ANY LOSS
OR DAMAGE, DIRECT OR CONSEQUENTIAL, ARISING OUT OF THE
USE OR INABILITY TO USE THE PRODUCT. BECAUSE SOME STATES
DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY
LASTS OR EXCLUSIONS OR LIMITATIONS OF INCIDENTAL OR CONSE-
QUENTIAL DAMAGES, THE ABOVE LIMITATIONS OR EXCLUSIONS MAY
NOT APPLY TO YOU.
9. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND
YOU MAY ALSO HAVE OTHER RIGHTS THAT VARY FROM STATE TO
STATE.
10. Should you have any difficulties with the performance of this
product during warranty or with any Alphasonik, Inc. authorized service
center, you may contact the Alphasonik, Inc. National Service Manager at
the address listed on the back of the booklet card or call 714.670.8950 for a
listing of Authorized Warranty Service Centers in your area.
Y
C
O
N
T
I
N
U
E
D
INSTALLED WARRANTY
(When purchased from and installed by an Authorized Alphasonik, Inc.
Dealer)
Speaker and Accessories: 1-year over-the-counter defective exchange plus
1-year repair or replacement at the sole discretion of Alphasonik, Inc.
Electronics: 1-year over-the-counter defective exchange, plus 1-year repair
or replacements at the sole discretion of Alphasonik, Inc.
An Alphasonik Extended Warranty Registration Card must be submitted to
Alphasonik, Inc. within 30 days of purchase. To process any warranty claim,
Alphasonik, Inc. will require the dated proof of purchase, which must specifi-
cally show the model and serial number and that installation was provided
for the product in question. All other terms per Alphasonik, Inc.’s standard
one-year warranty apply.
11
N
O
T
E
S
12
N
O
T
E
S
13
N
O
T
E
S
14
ALPHASONIK INC.
7050 VILLAGE DR. BLDG. G
BUENA PARK, CA. 90621
TEL: (714)670-8950 FAX: (714)670-8959
|