053-064 ISS 1
D E E P S E A E L E C T R O N I C S
DSE2510 / DSE2520 DISPLAY MODULE
INSTALLATION INSTRUCTIONS
The DSE2510 / DSE2520 Display Module is factory set to operate as DSENET® ID 0.
If you use multiple display modules with the same host controller, you must select a
unique ID for each display. This ID selection is performed in the ‘Running Editor’ of the
Display Module.
Customisation of the operation of the Display Module in the system is performed by
configuring the host controller using it’s respective PC Configuration Software.
ACCESSING THE ‘RUNNING’ CONFIGURATION EDITOR
•
•
The ‘running’ editor can be entered while the engine is running. All protections remain active if the
engine is running while the running editor is entered.
Press and hold the
button to enter the running editor.
EDITING A PARAMETER
•
•
Enter the editor as described above.
Press the up or down buttons to select the parameter you wish to view/change.
•
To edit the parameter, press
you are editing the value.
to enter edit mode. The parameter begins to flash to indicate that
•
•
•
Press the up or down buttons to change the parameter to the required value.
Press
to save the value. The parameter ceases flashing to indicate that it has been saved.
To exit the editor at any time, press and hold the
button.
ADJUSTABLE PARAMETERS
Section Parameter as shown on display
Factory Settings
53%
English
0
DISPLAY
Contrast
Language
DSENet® ID
Deep Sea Electronics Plc.
Tel:+44 (0)1723 890099
Fax: +44 (0)1723 893303
LO CALL (from UK BT landlines)
Telephone 0845 260 8933
Email: [email protected]
Deep Sea Electronics inc.
Phone: +1 (815) 316-8706
Fax: +1 (815) 316- 8708
TOLL FREE (USA only) :
Tel: 1 866 636 9703
Deep Sea Electronics Plc.
(Far East)
Tel:+66 2 670 6228
Fax: +66 2 678 3028
Email: [email protected]
Email: [email protected]
|