R
+
SOOGM-19L
OnStar Radio Replacement Interface with Steering Wheel
Control Retention for GM LAN v2 (LIN) Bus Vehicles 2014 - 2018
RADIO REPLACEMENT
SWC RETENTION
INTERFACING SOLUTIONS
PRODUCT FEATURES:
- Retains factory features in select GM LAN V2 (LIN) Bus vehicles while functioning with an aftermarket radio.
- Retains OnStar functionality.
- Retains all chime functions.
- Retains OEM Auxiliary Input.
- Retains Factory Bluetooth in Vehicles 2008-upwards if equipped with the new OnStar device.
- Retains factory Steering Wheel Controls via built-in, preprogrammed interface.
- Retains RAP (Retained Accessory Power).
- Includes factory backup camera connection for the IO3 system. (vehicles with IO4, IO5 & IO6 systems can be hard
wired to retain the OEM camera. See page 3)
PARTS INCLUDED:
SOOGM-19L MODULE
SOOGM-19L HARNESS
SWC CABLE
ANTENNA ADAPTER
INSTALLATION DIAGRAM:
Antenna Adapter
(Included)
Reverse
Illumina�on (+)
+12V Constant
+12V ACC
Red/White
Orange
Yellow
AFTERMARKET
RADIO
Red
Black
Ground
Entertainment Turn On
Parking Brake
Vehicle Speed Sense
Right Front (+)
Right Front (-)
Le� Front (+)
Blue/White
Yellow/Black
Purple/White
Gray
Gray/Black
White
White/Black
Violet
Violet/Black
Green
Le� Front (-)
Right Rear (+)
Right Rear (-)
Audio Input
Rear Camera (IO3)
Le� Rear (+)
Le� Rear (-)
Green/Black
16-Pin Green
Connector
ON
VR Activation
for OnStar (set DIP#1 to ON)
1
2
3
24-Pin
Connector
TO FACTORY
HARNESS
8-Pin
Connector
10-Pin
Connector
20-Pin Gray
Connector
SWC DIP SWC
ON
Chime Volume
Adjustment
1
2
3
4
Cap or insulate if
not being used
4-Pin
Connector
3.5MM SWC CABLE
Plug in the 3.5MM SWC cable to the 4-pin port
on the module. See “DIP SWITCH SETTINGS”section.
LIN BUS (Green/Black)
JVC/Kenwood (Blue / Yellow)
1 of 4
rev.082018
Crux Interfacing Solutions • 6860 Canby Ave., Suite 116, Reseda, CA 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
R
+
SOOGM-19L
OnStar Radio Replacement Interface with Steering Wheel
Control Retention for GM LAN v2 (LIN) Bus Vehicles 2014 - 2018
RADIO REPLACEMENT
SWC RETENTION
INTERFACING SOLUTIONS
INSTALLATION INSTRUCTIONS:
1. Connect the aſtermarket radio’s
power/speaker harness to the SOOGM-
19L T-Harness using the Installaꢀon
Diagram on page 1. Use good quality
crimp caps or buꢁ splice for a secure
connecꢀon. Solder and heat shrinking
the connecꢀons is highly recommended.
2. Carefully remove the radio trim with a plasꢀc 3. Remove the radio bezel by removing the
pry tool and pull outward. 4 screws on the corners.
4. Unplug the GREEN and GRAY
connectors from the headunit.
5. Plug the GREEN and GRAY connectors to the 6. Use the supplied antenna adapter to plug
SOOGM-19L T-Harness.
between the OE antenna connector and
aſtermarket radio antenna port.
7. Remove plasꢀc trim under the
steering wheel column and locate a
GREEN/BLACK wire in the bundle. Tap
the GREEN/BLACK from the SWC Cable.
We recommend soldering the wires
together for a reliable connecꢀon.
8. Use a dash kit (not included) for a clean
install. Test the radio for funcꢀonality. Test
the chime and Retained Accessory Power
(RAP) funcꢀons. Reverse the process to
install the new aſtermarket radio.
OEM CAMERA RETENTION:
The SOOGM-19L is prewired with an RCA connector to retain the OEM camera on vehicles
with a IO3 system. To retain the OEM camera on IO4, IO5 and IO6 systems, you will need
connect an RCA cable to the 12-pin connector on the HMI module found either by the
passenger kick panel or behind the glove box. Connect the RCA as follows:
HMI Connector
PIN 5 = Gray/Yellow to RCA posiꢀve
PIN 6 = White/Blue to RCA shield
We recommend soldering and heat shrinking these wires for a secure connecꢀon.
Pin 6
Pin 5
White/Blue
Gray/Yellow
3 of 4
rev.082018
Crux Interfacing Solutions • 6860 Canby Ave., Suite 116, Reseda, CA 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
R
+
SOOGM-19L
OnStar Radio Replacement Interface with Steering Wheel
Control Retention for GM LAN v2 (LIN) Bus Vehicles 2014 - 2018
RADIO REPLACEMENT
SWC RETENTION
INTERFACING SOLUTIONS
DIP SWITCH SETTINGS:
AFTERMARKET RADIO DIP SWITCH SETTINGS:
RADIO BRAND:
DIP:
1
2
3
4
Dual, Fahrenheit, Jensen, Pioneer OFF
OFF
OFF
OFF
ON
ON
ON
ON
ON
OFF OFF
ON
ON
OFF
OFF OFF
ON OFF
ON
ON
SWC MODULE
DIP SWITCH
Power Acoustik, Soundstream
OFF
OFF
OFF
OFF
OFF
OFF
OFF
Alpine
Clarion
OFF
ON
ON
ON
Kenwood
JVC
Boss, Old Sony
New Sony
ON
OFF
1 2 3 4
3.5MM SWC CABLE
Plug in the 3.5MM to 4-Pin SWC cable to the SWC module.
NOTE: Insulate the Blue/Yellow wire if not being used.
SWC 3.5MM PLUG ADAPTER:
Use the supplied 3.5MM SWC Plug adapter for aſtermarket radios that do not have a 3.5mm SWC jack.
RED to SWC Key 1
WHITE to SWC Key 2
SHIELD to SWC Ground
(included in kit)
VEHICLE APPLICATIONS:
BUICK
2015-2016
2017
2016
2014-2015
CHEVROLET
GMC
2017
2017
2015-2016
2014-2016
2017
2017-2018
2015-2017
2015-2018
2015-2017
ENCORE
ENVISION
LACROSSE
REGAL
2016-2018
CAMARO (with 8” Screen (IO5/IO6)
ACADIA (with 7” Screen (IOB)
ACADIA (with 8” Screen (IO5/IO6)
CANYON
2018
CAMARO (with 7” Screen (IOB)
2015-2016 COLORADO
2016
2018
CRUZE
CRUZE (with 7” Screen (IOB)
SIERRA
SIERRA (with 7” Screen (IOB)
SIERRA (with 8” Screen (IO5/IO6)
SIERRA HD
YUKON
YUKON XL
2014-2016 IMPALA
CADILLAC
2015-2016
2014-2015
2015
2016
2018
2018
MALIBU
MALIBU (with 7” Screen (IOB)
MALIBU (with 8” Screen (IO5/IO6)
ATS
CTS
ESCALADE
SRX
2014-2017 SILVERADO
2015-2016
2018
2018
SILVERADO (with 7” Screen (IOB)
SILVERADO (with 8” Screen (IO5/IO6)
2017
XT5
2015-2017 SILVERADO HD
2016 SONIC
2015, 2018 SPARK
2015-2018 SUBURBAN
2015-2018 TAHOE
4 of 4
rev.082018
Crux Interfacing Solutions • 6860 Canby Ave., Suite 116, Reseda, CA 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
|