SET UP & USE
SPECIFICATIONS
BPACT14H
• Unit Dimensions (W x D x H): 17.1” x 13.8” x 28.1”
• Unit Weight: Approx. 68.3 lbs.
• Electric Requirements: 115V ~ 60Hz
• Performance Rating: 14,000 BTU Cool, 10,000 BTU Heat
INSTALLATION GUIDE
LOCATION
• The air conditioner should be placed on a firm floor to minimize noise and
vibration. For safe and secure positioning, place the unit on a smooth, level
floor strong enough to support the unit.
• The unit has casters to aid placement, but it should be rolled on smooth, flat
surfaces. Use caution when rolling on carpet surfaces. Do not attempt to roll
the unit over objects.
• The unit must be placed within reach of a properly rated grounded socket.
• Never place any obstacles around the air inlet or outlet of the unit.
• Allow 12 inches to 36 inches of space from the wall with window for efficient
air-conditioning.
SUGGESTED TOOLS FOR WINDOW KIT INSTALLATION
• Screwdrivers (medium size Phillips)
• Tape measure or ruler
• Knife or scissors
• Saw (In the event that the window kit needs to be cutdown in size because the
window is too narrow for direct installation)
Page 9
SET UP & USE
EXHAUST HOSE INSTALLATION
The air exhaust hose and hose inlet must be installed or removed from the portable
air conditioner in accordance with the way it is being used:
COOL, AUTO: Air exhaust hose and hose inlet should be connected to the portable
air conditioner.
DEHUMIDIFY, FAN: Air exhaust hose and hose inlet should be disconnected from the
portable air conditioner.
To install:
1. Connect hose inlet to one end of air exhaust hose. Push hose inlet over the end
of the hose, push in slightly and then start threading it on in a counter clockwise
direction. (see Fig 1)
2. Connect hose outlet to other end of air exhaust hose. Push hose outlet over the
end of the hose, push in slightly and then start threading it on in a counter
clockwise direction. (see Fig 2)
3. Align window bracket/air intake hose connector with hose outlet and push in until
it locks into place. You will hear a clicking sound when it does. (see Fig 3)
4. Place the hose inlet against the air outlet opening hook on the back of the portable
air conditioner and firmly push and rotate counter clockwise to lock it into place.
(see Fig 4)
5. After connecting the hose inlet to the unit, insert the window bracket/air intake
hose connector into the opening of the window bracket. Align connector with the
opening on the inside (side with the channels) of the window bracket and push in
until it locks into place. You will hear a clicking sound when it does.
(see Fig 5).
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Hook
NOTE: The exhaust hose can be compressed or extended
moderately, but it is desirable to keep the length to a
minimum. Also make sure that the hose does not
have any sharp bends.
Page 11
|