X10 Wireless Technology Home Security System VK45A User Manual |
In d o o r / O u t d o o r Co lo r Ca m e r a
w it h Bu ilt - in 2 . 4 G Hz W ir e le ss
Vid e o Se n d e r, a n d se p a r a t e
Vid e o Re ce iv e r
O W N ER'S MAN UAL
MO DEL VK4 5 A
(IN CLUDES XC1 0 A CAMERA, VR3 0 A VIDEO RECEIVER
AN D PLUG-IN PO W ER SUPPLIES)
Download from Www.Somanuals.com. All Manuals Search And Download.
11. Power Sources - This product should be operated only from the type of power
source indicated on the marking label. If you are not sure of the type or power
supply to your home, consult your product dealer or local power company. For
products intended to operate from battery power, or other sources, refer to the
operating instructions.
c)
d)
If the product has been exposed to rain or water,
If the product does not operate normally by following the operating instructions.
Adjust only those controls that are covered by the operating instructions as an
improper adjustment of other controls may result in damage and will often
require extensive work by a qualified technician to restore the product to its
normal operation,
12. Grounding or Polarization - This product is equipped with a polarized
alternating current line plug (a plug having one blade wider than the other).
This plug will fit into the power outlet only one way. This is a safety feature. If
you are unable to insert the plug fully into the cutlet, try reversing the plug. If the
plug should still fail to fit, contact your electrician to replace your obsolete
outlet. Do not defeat the safety purpose of the polarized plug.
e)
f)
If the product has been dropped or damaged in any way, and
When the product exhibits a distinct change in performance - this indicates a
need for service.
19. Heat - The product should be situated away from heat sources such as
radiators, heat registers, stoves, or other products including amplifiers) that
produce heat.
13. Power-Cord Protection - Power supply cords should be routed so that they are
not likely to be walked on or pinched by items placed upon or against them,
paying particular attention to cords at plugs, convenience receptacles, and the
point where they exit from the product.
FCC CAUTIO N
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1)THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
14. Lightning - For added protection for this product during a lightning storm, or
when it is left unattended and unused for long periods of time, unplug it from
the wall outlet and disconnect the antenna or cable system. This will prevent
damage to the product due to lightning and power-line surges.
(2)THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
This equipment generates and uses radio frequency energy, and if not installed and
used properly, that is, in strict accordance with the manufacturers instructions, it may
cause interference to radio and television reception. It has been type tested and
found to comply with the limits for remote control devices in accordance with the
specifications in Sub-Parts B and C of Part 15 of FCC Rules, which are designed to
provide reasonable protection against such interference in a residential installation.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause interference to radio or television reception,
which can be determined by unplugging the equipment, try to correct the interference
by one or more of the following measures.
15. Overloading - Do not overload wall outlets, extension cords, or integral
convenience receptacles as this can result in a risk of fire or electric shock.
16. Object and Liquid Entry - Never push objects of any kind into this product
through openings as they may touch dangerous voltage points or short-out parts
that could result in a fire or electric shock. Never spill liquid of any kind on the
product.
17. Servicing - Do not attempt to service this product yourself as opening or
removing covers may expose you to dangerous voltage or other hazards. Refer
all servicing to qualified service personnel.
• Reorient the antenna of the radio/ TV experiencing the interference.
• Relocate the equipment with respect to the radio/ TV.
• Move the equipment away from the radio/ TV.
18. Damage Requiring Service - Unplug this product from the wall outlet and refer
servicing to qualified service personnel under the following conditions:
• Plug the equipment into an outlet on a different electrical circuit from the radio/ TV
experiencing the interference.
a)
b)
When the power-supply cord or plug is damaged,
• If necessary, consult your local Dealer for additional suggestions.
N O TE: Modifications to this product will void the user's authority to operate this
equipment.
If liquid has been spilled, or objects have fallen into the product,
4
5
Download from Www.Somanuals.com. All Manuals Search And Download.
CO N TEN TS
CO N TRO LS AN D CO N N ECTIO N S
CO N TRO LS AN D CO N N ECTIO N S ........................................ 7
CAMERA/ VIDEO SEN DER, AN D VIDEO RECEIVER .................... 7
CAMERA/ VIDEO SEN DER .................................................. 8
VIDEO RECEIVER ............................................................. 9
CO N N ECTIN G UP ........................................................... 1 0
SETTIN G UP THE CAMERA/ VIDEO SEN DER ........................... 1 0
CAMERA/ VIDEO
SEN DER
VIDEO RECEIVER
(BO TTO M VIEW )
TV
Channel
Switch
2.4 GHz
Video
Antenna
SETTIN G UP THE VIDEO RECEIVER ...................................... 1 2
FIN E TUN IN G YO UR SYSTEM ........................................... 1 4
W ARRAN TY................................................................... 1 5
2.4 GHz
Channel
Switch
2.4 GHz
Channel
Switch
Power Supply
Socket
6
7
Download from Www.Somanuals.com. All Manuals Search And Download.
CO N TRO LS AN D CO N N ECTIO N S
CAMERA/ VIDEO SEN DER
VIDEO RECEIVER
2.4 GHz
Video
Antenna
2.4 GHz Video
Antenna
Set channel switch to
match setting on
Video Receiver.
TV Output
Connector
Mounting
plate
ON-OFF
Switch
(on side)
Power Supply
Jack
TV Channel
Switch
2.4 GHz Channel
A/ V Input
Jacks
Switch
Cable adapter.
(on bottom)
(on bottom)
8
9
Download from Www.Somanuals.com. All Manuals Search And Download.
CO N N ECTIN G UP
SETTIN G UP THE CAMERA/ VIDEO SEN DER
Referring to the diagram on the next page:
2.4 GHz Video
Antenna
Set channel switch to
match setting on
Video Receiver.
1. Attach the camera to a wall using the screws provided.
2. If you install the camera outdoors, make a small hole in your
exterior wall and pass the low voltage power jack through it.
3. Plug the power supply jack into the socket on the adapter cable
from the camera. Use the smaller of the two power supplies.
Attach camera to a
wall, indoors or
outdoors.
4. Plug the power supply into any 120V AC outlet.
5. Set the channel switch to any letter A, B, C, or D
6. Adjust the antenna if necessary to aim it in the direction of the TV
or monitor that you will view the camera on.
Outdoors
Indoors
Plug power
supply in here.
Plug into
any AC
outlet
Im p o rta n t: Unplug
power supply before
unplugging power jack.
1 0
1 1
Download from Www.Somanuals.com. All Manuals Search And Download.
HO O KIN G UP THE VIDEO RECEIVER
IF YO UR TV IS ALREADY HO O KED UP TO A DSS RECEIVER O R O THER
A/ V DEVICE
If a DSS Receiver or other A/ V
1. Connect a set of Audio/ Video cables
to the A/ V OUT jacks of your Video
Receiver. Connect the other end to
your TV.
component is connected to the TV using
A/ V cables, you can connect the Video
Receiver to the free LINE IN jacks on
the component. If there are no LINE IN
jacks, you will need to use a TV
2. Plug the Video Receiver's Power
Supply (the larger of the two power
supplies) into a 120 volt wall outlet
and plug its jack into the Video
Receiver.
antenna splitter as described earlier.
3. Turn the Video Receiver's power switch (on side of unit) on.
4. Set the channel switch to the same letter as you set on the
camera, A, B, C, or D.
5. Position the Video Receiver in a convenient location such as on
top of the TV and orient the antenna so that the flat side points in
the direction of the room where you set up the Video Sender.
IF YO UR TV DO ES N O T HAVE A/ V CO N N ECTO RS
You can use the supplied coaxial cable to connect the TV OUT socket
on the Video Receiver to the Antenna input on your TV. If you already
have an antenna connected
to your TV, you will need to
use a TV antenna splitter.
Set your TV and the TV
Channel switch on the
Video Receiver (on bottom)
to the same channel (3 or
4).
1 2
1 3
Download from Www.Somanuals.com. All Manuals Search And Download.
FIN E TUN IN G YO UR SYSTEM
WARRAN TY
1 2 MO N TH LIMITED WARRAN TY
The Wireless Video Sender usually works best with the flat faces of
the antennas on the Sender and Receiver unit facing each other (i.e.
in “Line of sight” - see diagram below). Sometimes, however,
reflections and other effects in the home may affect the signal so that
some adjustment of either the Sender or Receiver antenna may be
necessary to get the best the signal.
X10 (USA) INC. (X10) WARRANTS ITS PRODUCTS TO BE FREE FROM
DEFECTIVE MATERIAL AND W ORKMANSHIP FOR A PERIOD OF ONE (1)
YEAR FROM THE ORIGINAL DATE OF PURCHASE AT RETAIL. X10 AGREES
TO REPAIR OR REPLACE, AT ITS SOLE DISCRETION, A DEFECTIVE X10
PRODUCT IF RETURNED TO X10 W ITHIN THE WARRANTY PERIOD AND
W ITH PROOF OF PURCHASE.
IF SERVICE IS REQUIRED UNDER THIS WARRANTY:
1. RETURN THE DEFECTIVE UNIT POSTAGE PREPAID TO THE ADDRESS
ON BACK COVER.
2. ENCLOSE A CHECK FOR $4.00 TO COVER HANDLING AND RETURN
POSTAGE.
3. ENCLOSE A DATED PROOF OF PURCHASE.
4. X10 IS NOT RESPONSIBLE FOR SHIPPING DAMAGE. UNITS TO BE
RETURNED SHOULD BE PACKED CAREFULLY.
THIS WARRANTY DOES NOT EXTEND TO ANY X10 PRODUCTS W HICH
HAVE BEEN SUBJECT TO MISUSE, NEGLECT, ACCIDENT, INCORRECT
W IRING OR TO USE IN VIOLATION OF OPERATING INSTRUCTIONS
FURNISHED BY US, NOR EXTEND TO ANY UNITS ALTERED OR REPAIRED
FOR WARRANTY DEFECT BY ANYONE OTHER THAN X10. THIS
WARRANTY DOES NOT COVER ANY INCIDENTAL OR CONSEQUENTIAL
DAMAGES AND IS IN LIEU OF ALL OTHER WARRANTIES EXPRESSED OR
IMPLIED AND NO REPRESENTATIVE OR PERSON IS AUTHORIZED TO
ASSUME FOR US ANY OTHER LIABILITY IN CONNECTION W ITH THE
SALE OF OUR PRODUCTS.
IF YO U ARE N O T GETTIN G AN Y SIGN AL AT ALL
Check that the CHANNEL slide switch (labeled A, B, C, D) on both
units (on bottom) is set to the same letter.
SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN
IMPLIED WARRANTY LASTS, AND/ OR THE EXCLUSION OR LIMITATION
OF INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE
LIMITATIONS AND EXCLUSIONS MAY NOT APPLY TO THE ORIGINAL
CUSTOMER. THIS WARRANTY GIVES YOU SPECIFIC RIGHTS AND YOU
MAY ALSO HAVE OTHER RIGHTS W HICH VARY FROM STATE TO STATE.
If you are using coaxial TV connections from the Video Receiver,
check that the TV is tuned to the same channel as the TV Channel
switch on the bottom of the Video Receiver (3 or 4).
IF THE SIGN AL IS PO O R, O R THERE IS IN TERFEREN CE
Try changing the channel on both units. Do this by adjusting the
CHANNEL slide switch on each unit to any position (A, B, C, or D).
Make sure both units are set to the same letter.
1 4
1 5
Download from Www.Somanuals.com. All Manuals Search And Download.
X10 (USA) Inc.
3824 North 5th St.,
Suite C, North Las Vegas, NV 89030
We b Site : w w w .x 1 0 .co m
VK45A-11/ 99
1 6
Download from Www.Somanuals.com. All Manuals Search And Download.
|