SETUP
INSTRUCTIONS
Setting Up XRay Vision with Multiple Cameras
Connect the Firecracker Computer Interface
The Computer Interface
(model CM17A) uses
wireless signals to transmit
X10 control commands from
the computer to the
transceiver module included in the kit.
Your X10 multi-camera system allows you to control X10
Connect the Interface directly to your
XCam2™ cameras from your PC and vieweach camera from
PC's serial port. If there is already a
the XRay Vision™ software. Follow these instructions to set
up the necessary hardware and software.
device connected to this port, unplug
it, connect the Computer Interface, and
then plug the other device into the connector on the
Installing the XRay Vision Software
CM17A. Important: Do not plug your mouse into the
Before you connect the Video to USB Converter
CM17A!
(model VA10A) you must first install the drivers
and XRay Vision Software. First, download the
Configure Your Cameras in XRay Vision
XRay Vision server software from X10.com at:
Run XRay Vision. Right click in the program
window and choose "Settings" then
"Preferences" from the pop-up menu. Click on
the "Cameras" tab in the configuration window.
Next, run the Server installation application. Select the directory
Click on the "Add" button to create an entry
where XRay Vision will be installed and decide how you want
for a camera. Click into the "Camera Code" box and enter
XRay Vision listed on your Windows Start menu. After that,
the House and Unit code for this camera. Make sure to
the XRay Vision installation program will automatically finish.
enter the letter and number without a space between
You are now ready to set up the Video to USB Adapter.
them. In the "Comment" box you can type a description
or name for this camera. Repeat these steps for all the
Connecting the USB Video Capture Adapter
cameras you set up earlier.
When the installation program instructs you to, plug
the Video to USB Converter connector into a USB
You are now ready to control your cameras from XRay
port on your computer. The computer will recognize
Vision. Right click in the XRV window and choose
that new hardware has been installed and complete
"Camera." You will be able to select from your different
the installation.
cameras, or tell XRV to automatically switch between all
of them.
Installing XRay Vision Remote Viewer
After you have installed the XRay Vision server,
you can use the XRay Vision remote viewer
look at your images from any PC connected
to the Internet. Once again you need to
download the software from:
Set Up the Transceiver Module
Make sure you have connected the Transceiver
(model TM751) to a nearby power outlet. The
This time choose the remote software. Run the file Remote
outlet you use should not be too close to the back
installation application and follow the installation
of your PC, as your PC may create some electrical
instructions. You are now ready to connect to your XRay
noise that could reduce the range of the transceiver.
Vision server and download images.
Set the House Code (letter dial) on the Transceiver to the
letter you will use for your cameras.
For more help, see:
Connect the Video Receiver to the Video
Capture Adapter
Plug the yellow video plug on
the supplied cable into the Video
Out jack on the VR30A. Connect
the other end of the cable to the
yellow Video In jack on the Video Capture
Adapter. Plug the PR30A power supply into
any 120V AC outlet. Plug the power output
of the PR30A into the DC 12V plug on the
VR30A. Make sure the Channel switch on
the underside of the VR30A should be set
to the same letter as that on the XCam2.
MODEL
NUMBER:
IN49A
© Copyright 2000 X10 Wireless Technology, Inc.
Download from Www.Somanuals.com. All Manuals Search And Download.
|