Woodstock Saw D3614 User Manual

Model D3614  
ZERO CLEARANCE  
TABLE SAW INSERT  
WARNINGS  
Disconnect the saw from the power source before fitting or removing the insert.  
Always wear eye protection.  
Ensure that the blade is NOT in contact with the insert before turning the saw ON.  
Do not attempt to tilt the arbor while the blade is in the insert! The blade will bind, causing severe  
damage and possible injury! For beveled cuts, a separate, dedicated insert must be prepared. Pre-set  
the angle and then proceed as instructed below.  
The insert must be covered by a board that is securely clamped down before plunging the blade up.  
If you are using blade stabilizers, check the clearance before raising the blade.  
INSTALLING AND FITTING YOUR INSERT  
1. Lower the blade completely.  
2. Place the insert in the throat opening so the blade starter pocket is directly over the blade.  
3. Using a medium grit sanding block, LIGHTLY sand all four fitting bumps. Also, lightly bevel the  
bottom edges of the FRONT bumps to ease entry. Sand, test, and repeat to achieve a TIGHT,  
WEDGE fit.  
4. Adjust the four leveling screws until the insert is flush with the table top.  
5. SPLITTER: If the insert is to be used with a splitter, you will need to finish cutting out the pre-  
routed optional splitter slot, using a saw or router, then smooth over the sharp edges with fine  
sandpaper.  
CUTTING THE BLADE SLOT (KERF)  
1. Check that the insert is fitted properly and that there is clearance between the blade and the insert.  
(Using a stick, reach under the table and rotate the blade manually to check for blade clearance.)  
2. Fully cover the insert with a board, and clamp the board at each end to the table saw top.  
3. Re-connect power to the saw. Turn the saw ON, then slowly and cautiously raise the blade up to cut  
through the insert. KEEP HANDS OFF OF TABLE TOP, STAY CLEAR AND WEAR EYE PROTECTION. Raise  
the blade to the maximum height.  
4. Lower the blade, turn the saw OFF, and remove the board. Your insert is now ready for use!  
IMPORTANT TIPS FOR USE  
Only recommended for use with carbide tipped cutters.  
DADO BLADE: Use same procedures outlined above, but use additional caution due to excessive mate-  
rial being machined from the insert during the slotting procedure.  
Under certain conditions, an undesirable scraping noise may be generated by your saw blade. Planer  
type blades, excessive arbor run-out, and/or blade distortion may intermittently cause blade/insert  
contact. To remedy this, remove the insert and slightly widen the slot using a file or sanding paddle.  
Ideally, a separate insert should be used with each blade, dado stack, or angle set-up. This will ensure  
a true “zero-clearance” effect and give you maximum benefit from your inserts.  
COPYRIGHT © JANUARY, 2006 BY WOODSTOCK INTERNATIONAL, INC.  
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT  
#7879TR  
Printed in USA  
THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Westcott Camera Accessories 1866 User Manual
White Rodgers Thermostat 24A07A 1 User Manual
Winegard TV Antenna RP SK01 User Manual
Xerox Printer N17 User Manual
Yamaha Guitar BB 604 User Manual
Yamaha Motorcycle FJR1300ATC User Manual
Yamaha Stereo Receiver HTR 5830 User Manual
Zadro Products Fitness Electronics TRANQUIL SOUNDS OXYGEN BAR User Manual
Zanussi Dishwasher 864512 User Manual
Zanussi Freezer ZRB 7725 W User Manual