Instruction Sheet
Model D3276
Spray Gun
INTRODUCTION
The SHOP FOX® Spray Gun features a 1.5mm nozzle
and 750cc paint canister that offers consistent spray
patterns and fast coverage.
Fluid
Control
SETUP
The Model D3276 accepts 1⁄4" NPT connectors. Mount an
air regulator as close as possible to the spray gun.
Use the adjustment knob on the regulator to set
your working air pressure between 65-85 PSI.
Nozzle
Control
ADJUSTMENTS
See Figure 1 to identify the location of the spray
gun controls and adjust in the following order:
Pattern
Control
1. Nozzle Control—Adjusts the spray pattern
from vertical to horizontal.
Figure 1. Model D3276.
2. Pattern Control—Variably adjusts the spray
pattern from round to a wide fan.
3. Fluid Control—Adjusts how far back the
trigger can be pulled, which affects the
volume of paint released.
EXPLOSION HAZARD! Do not
spray flammable fluids near
an open flame or ignition
source.
OPERATIONS
Hold the sprayer 8"–10" from the workpiece, and
keep the spray gun perpendicular to the workpiece
during strokes. DO NOT pivot your wrist when
spraying!
EYE
INJURY
AND
MAINTENANCE
RESPIRATORY HAZARD!
Always use safety glasses
and respirator rated for
paint and solvent vapors
while using sprayer.
1. Clean the spray gun by flushing it with thinner.
DO NOT immerse the gun in the thinner!
2. To avoid internal damage, clean the air cap
with the supplied brush.
CUSTOMER SERVICE
For questions contact Woodstock International
Technical Support at (360) 734-3482, or send e-
mail to: [email protected].
COPYRIGHT © BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS DOCUMENT MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
SEPTEMBER 2003, PRINTED IN CHINA.
Download from Www.Somanuals.com. All Manuals Search And Download.
|