MODEL D3978
ACCU-SHARP® GRINDING JIG
INSTRUCTIONS
To reduce the risk of serious injury when using
this grinding jig, take the following precau-
tions:
1. GRINDER OWNER'S MANUAL. Read
and understand the owner's manual for your
grinder and always follow all of the safety
precautions and instructions for your grinder.
2. EYE/FACE PROTECTION. Always wear
safety glasses or a face shield to protect your-
self from flying material.
Figure 1. Using the Accu-Sharp Jig to grind the bevel
of a flat chisel.
3. HAND PLACEMENT. Always keep your
hands and fingers away from the spinning
grinding wheel, and protect yourself from the
sharp edges of the tool.
Inventory
After removing the contents of the shipping package,
lay them out and refer to Figure 2 to inventory the
components.
4. SECURE CLAMPING. Make sure the tool is
securely clamped in the jig and that the table is
firmly locked in the proper position.
Tool
Clamping
Jig
Introduction
The Model D3978 Accu-Sharp® Grinding Jig works
with the tool rest table of your grinder to properly posi-
tion chisels and plane irons up to 23⁄4" wide, as shown
in Figure 1. The tool clamping jig uses a special
plastic rod and pads to slide the tool from side-to-side
across the auxiliary table and the grinding wheel.
Auxiliary
Table
Mounting
Screws
If you need help with your new grinding jig, call
Woodstock Tech Support at: (360) 734-3482.
Figure 2. Model D3978 inventory.
COPYRIGHT © NOVEMBER, 2008 BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT
THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
#11386TS
Printed in China
Download from Www.Somanuals.com. All Manuals Search And Download.
|