D2485
Hot Melt
Glue Gun – Large
Manufactured in China
for Woodstock International, Inc.
SHOP FOX® IS A REGISTERED TRADEMARK OF
1-800-840-8420
FAX: 360-671-3053
Visit our website @ woodstockinternational.com
HOW TO USE THE GLUE GUN:
1: Plug in gun. Load the glue sticks into the back of the gun.
2: Press trigger several times until the glue stick is firmly set into the inner tube.
3: Allow the glue gun to warm up for approximately 5 minutes.
4: Squeeze trigger until glue flows from the nozzle.
5: Glue need not be spread. Press surfaces together within 15 seconds. Use of clamps or other holding devices is not necessary. Clean surfaces for best bonding.
6: Unplug glue gun when finished. No clean up required. Never pull the glue stick out the back of the gun.
Use 7⁄16" glue sticks only.
CAUTION:
Hot melt glue gets hot! Nozzle area temperature reaches 380°. If accidental contact should occur, do not try to remove the glue. Put in cold water immediately.
Download from Www.Somanuals.com. All Manuals Search And Download.
|