Winegard TV Antenna DS 3118 User Manual

®
WINEGARD  
HOME DIGITAL SATELLITE ANTENNA  
Model DS-4248, DS-3118  
SAFETY INFORMATION  
WARNING:  
WHEN INSTALLING THIS ANTENNA, AVOID  
CONTACT WITH OVERHEAD POWER LINES,  
LIGHTS AND POWER CIRCUITS. CONTACT  
WITHPOWERLINES, LIGHTS,ANDCIRCUITS  
MAY BE FATAL.  
ANTENNA GROUNDING  
PARTS LIST  
Theantennaandcoaxcablethatconnectstothereceiver  
are required to comply with local installation codes and  
the appropriate sections of the National Electrical Code  
(NEC), especially article 820.  
CODE QTY PART #  
DESCRIPTION  
A
B
C
D
E
1
1
2745265  
2745441  
18" (46 cm) Reflector  
Back-up/Feed Support Assy.  
RG-6 Coaxial Cable  
Mount Pipe/Roof Bracket  
Single LNBF Models Only  
Dual LNBF Models Only  
Hardware Package  
not supplied  
1
1
1
1
2745404  
2780197  
2780185  
2762417  
MOUNT DISCLAIMER  
To insure maximum safety, Winegard recommends  
no roof or wall installations be attempted without a  
professionalengineer'sstructuralanalysis. Localzoning  
and/or building codes and insurance companies may  
requirearchitectorstructuralengineeringapprovalprior  
toinstallation. Itisthepurchaser'sresponsibilitytoverify  
that the above steps are taken.  
HARDWARE PACKAGE PART #3762449  
CODE QTY PART #  
DESCRIPTION  
1/4-20 Hex Nut  
1/4-20 x 5/8" Carriage Bolt  
10-32 Flange Hex Nut  
10-32 x 1-1/4" Carriage Bolt  
[1]  
[2]  
[3]  
[4]  
4
4
1
1
2160228  
2160340  
2160217  
2160346  
Inspectthepackageandconfirmthatallpartsarepresent.  
If any parts are missing, please contact Winegard  
Company at 1-800-288-8094.  
Printed in U.S.A. Winegard Co. • 3000 Kirkwood St. • Burlington, IA 52601-2000 • 319/754-0600 • FAX 319/754-0787 ©Winegard Co. 2002, 2005 2451687 Rev2, 2/12  
Download from Www.Somanuals.com. All Manuals Search And Download.  
STEP 3. Adjustmountpipesothatitisplumbvertically.  
See Figure 5.  
ANTENNA ASSEMBLY  
INSTALLATION  
FIGURE 2  
STEP 1. After confirming that you have a clear line-of-  
sight from where you wish to mount the antenna, you  
mustdeterminehowyouaregoingtomounttheantenna  
and run your coax downlead to your receiver. Figure 3  
shows a typical home installation. As indicated in the  
figure, you must ground both the antenna and the coax  
downlead before it enters your home. You can order all  
the accessories through Winegard or they can be found  
at most hardware stores.  
STEP 1. Assemble antenna as shown in Figure 1,  
except for LNBF and base/tube assembly.  
FIGURE 5  
90o VERTICAL  
STEP 2. Feed coaxial cable(s) through feed arm as  
shown in Figure 1.  
STEP 3. Attach LNBF to feed arm. See Figure 1.  
SITE SELECTION  
STEP 1. Using the digital satellite receiver determine  
yourazimuth(direction)andelevation. Refertoreceiver  
manual to perform this step.  
FIGURE 3  
STEP 2. After you have determined your azimuth and  
elevation step outside to find the best location for the  
antenna. You will need a compass and a protractor or  
another means of determining elevation. Remember  
that the antenna must have a clear line-of-sight to the  
satellites. See Figure 2. The satellite signal will NOT  
travel through buildings, heavy tree cover and other  
obstructions.  
Antenna  
STEP 4. Set antenna onto mount pipe. See Figure 1.  
STEP 5. Feed coaxial cable(s) up through the mount  
pipe and through the LNBF feed. See Figure 1.  
SW-0030  
STEP 6. Attach coaxial cable(s) to LNBF. See Fig. 1.  
STEP 7. Attach LNBF to antenna. See Figure 1.  
Cable Clips  
Receiver  
GB-8100 (single)  
GB-8200 (dual)  
Ground Block  
TV  
FIGURE 1  
STEP 8. Set elevation on antenna; align colored edge  
of clamp with degree marking. See Figure 6.  
GK-4025  
Ground Wire  
STEP 9. Run coax cable to point where you plan to  
enter the house. Be sure to secure the cable so that  
it will not flap in the wind (Cable Clips Model SW-0030  
are ideal for this task).  
A
GR-0004  
Ground Rod  
B
[2]  
[1]  
STEP 2. Attachthemountfoottowall(roof,mast,etc.,)  
making sure that the mount foot is vertical (90o). See  
Figure 4. Attach ground wire to mount foot (wrap wire  
between bolt/lag screw and mount foot).  
FIGURE 6  
Azimuth  
Angle  
Bolts  
E
Elevation  
Bolts  
[2]  
[3]  
FIGURE 4  
C
90o Vertical  
6" Level  
[4]  
NOTE: The DS-4248/DS-3118 satellite dish and LNB are  
compatiblewiththeDISH® DISH300systemandDIRECTV®  
satellite systems.  
D
This unit may be used with:  
DISH Satellites: 61.5o, 110o, 119o, 129o, 148o  
DIRECTV Satellites: 101o, 119o  
Bell TV™ Satellites: 82o, 92o  
Align locating edge  
with look angle value  
(38° shown)  
NOT GOOD  
CORRECT  
NOT GOOD  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Western Digital Computer Drive Studio Edition II User Manual
Westinghouse Landscape Lighting WH08 User Manual
Westinghouse Saw ACB 640R User Manual
Wharfedale Portable Speaker EM 9 User Manual
Whirlpool Air Conditioner BHAC1000XS0 User Manual
Whirlpool Washer 8527278B User Manual
Woods Equipment Lawn Mower CZ1736K User Manual
Woodstock Dust Collector W1816 User Manual
Yamaha Network Router CVP 505 User Manual
Yamaha Stereo Receiver HTR 5630RDS User Manual