Winegard Satellite TV System RP SK95 User Manual

Automatic Multi-Satellite TV Antenna  
Replacement Back-up and Feed Arm  
Assembly with LNB and Coax Cable  
Instruction Manual  
for Model RP-SK95  
For help, email [email protected] or call 1-800-788-4417  
2452290  
Download from Www.Somanuals.com. All Manuals Search And Download.  
4
5
If there is not already a line marking the top of the stiffener plate, draw  
a line on the stiffener plate to mark the top of the plate.  
Raising the Antenna  
1 Press and hold “POWER” for two seconds to turn on the interface  
box. Wait until the interface box finishes “connecting to antenna.” The  
TRAV’LER® antenna may enter the search routine after ten seconds.  
Using a ½wrench, loosen and remove the four bolts holding the  
reflector bracket and stiffener plate to the skew housing. At the same  
time, carefully remove the stiffener plate and LNB arm assembly. Set  
aside the stiffener plate and four bolts; you will need these later.  
Pay attention to the pinch points as the antenna raises!  
2 Wait until the antenna has at least raised to a position in which the  
LNB arm is parallel to the roof. Then, press “POWER” and “SELECT” at  
the same time. The antenna should stop moving.  
Reflector bracket  
Stiffener plate  
Unplug the interface box.  
3
Removing the LNB Assembly  
Remove the four reflector nuts and bolts with a ½wrench, and  
remove the reflector. Set the reflector, reflector nuts, and reflector  
bolts aside; you will need these later.  
Cable harness  
Bolts holding reflector bracket and  
stiffener plate to skew housing  
(one not shown)  
1
Installing the Replacement LNB Assembly  
Identify the fourth outer hole in the adapter plate. The fourth hole  
marks the bottom of the adapter plate.  
2 Disconnect the coaxial cable from port C on the top of the turret.  
1
7
Adapter plate  
8
6
5
1
Turret  
Coax cable disconnected  
from port C of turret  
2
4
3
Numbered outer holes  
in adapter plate  
3 Using a 5/16wrench, remove the screw holding the p-clamp to the lift  
arm, and detach the p-clamp from the lift arm. Set the screw aside;  
you will need this later.  
Note: as the antenna raises and turns, the adapter plate may become  
skewed, and the fourth hole may not be directly at the bottom of the  
plate. If unsure of the fourth hole, remove the four screws from the center  
of the adapter plate; a small post is located directly above the fourth hole.  
8
7
1
3
6
2
Cable harness  
5
Approximate location of  
post on back side of plate  
Hole in lift arm for  
cable harness  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  

Weider Fitness Equipment 831,150,741 User Manual
West Bend Slow Cooker WBSCRD6QT User Manual
Westinghouse Kitchen Utensil WST2008ZE User Manual
Westinghouse Landscape Lighting W 224 091305 User Manual
Whirlpool Trash Compactor GC900QPPB1 User Manual
Whirlwind Indoor Furnishings Patent Pending Recessed Wall Frames User Manual
Wibur Curtis Company Coffeemaker D500GTH User Manual
Wolf Indoor Furnishings H 4DC User Manual
Zanussi Washer ZWG 5120 P User Manual
Zebra Technologies Printer 3ULQWHUV User Manual