Weber Gas Grill Gas Go Anywhere User Manual

®
Gas Go Anywhere  
ENGLISH  
80045 1299  
Download from Www.Somanuals.com. All Manuals Search And Download.  
1 - Leg Lock  
2 - 1/4-20 wing nuts  
6 - 5/16” Washers  
1 - 1/4-20 x 1/2 bolt  
1 - Igniter assembly includes:  
2 - 10-24 screws  
1 - 10-24 wing nut  
1 - Flat washer  
1 - Igniter  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
Install Legs  
Place washers on leg ends and insert ends into holes in bottom unit. Be  
careful not to scratch the porcelain finish while installing the legs. Repeat  
with other leg.  
Install Leg Lock  
Position curved end of leg lock at corner of the straight portion of the leg, as  
shown. Push until it snaps on.  
2
1
3
Position legs and secure leg lock  
Swing legs around so that the rounded part sets on the ground and the bottom  
of the cooking box rests on the straight part of the legs.  
To lock the legs in place turn the leg lock around clipping it over the opposite  
leg. (Unlock the legs by unlatching this clip in the reverse direction.)  
2
1
3
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
Install Burner Tube  
From the inside, insert burner tube through the large hole in the side of the  
bottom unit. Line up the other end of the tube with the hole. Insert the 1/2  
inch bolt. Add the washer and wing nut. Tighten.  
Install Regulator  
Remove the retaining clip from the regulator. Attach regulator assembly by  
inserting the brass fitting into the end of the burner tube. Secure regulator  
assembly by installing the retaining clip in the square openings on both  
sides of the burner tube.  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
Install Igniter  
Insert the igniter electrode and two 10-24 screws through the igniter bracket  
and the holes in the bottom unit on the side opposite the regulator.  
Add washers and wing nuts, making sure that the wing nuts are secured in  
a vertical position.  
The igniter electrode has been pre-bent. It may need to be adjusted so the  
tip is approximately 1/8 inch from the holes in the burner tube.  
ƽDANGER  
Make sure the tip of the igniter wire is adjusted to the holes in the  
burner tube. If it is not adjusted properly, gas can accumulate in the  
barbecue while igniting the barbecue. Delayed ignition of the  
accumulated gas may occur. This will result in a fire or explosion  
which can cause serious bodily injury or death, and damage to  
property.  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
Install Flavorizer® Bar  
Place the Flavorizer Bar in bottom unit, covering the burner.  
Install Cooking Grate  
Set the cooking grate onto the recessed edge of the bottom unit.  
To Secure for Transport  
Put the lid on the bottom unit unlock legs and pivot them into the locked  
position up over the projections on the lid.  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
To Use  
Pivot legs under grill and lock legs. The hooks on the inside of the lid allow it  
to rest on the edge of the bottom unit.  
®
Read important DANGERS, WARNINGS and CAUTIONS in Owner’s  
Guide before operating this barbecue.  
Connecting the Cylinder  
WARNING: Use the correct fuel cylinder for the regulator supplied with  
the barbecue.  
Note: in your region the regulator supplied with your barbecue will only fit  
camping Gas fuel cylinders numbers 901 and 904.  
1. Make sure the burner control valve is in the LOCK/OFF position before  
attaching the propane cylinder. Valve closes by turning the knob  
clockwise to the LOCK/OFF position.  
2. Attach the propane cylinder to the grill by pushing the cylinder slightly  
while turning clockwise into the regulator. Turn until a snug fit is  
obtained.  
8
Download from Www.Somanuals.com. All Manuals Search And Download.  
Check for Gas Leaks  
ƽDANGER  
Do not use an open flame to check for gas leaks. Be sure there are  
no sparks or open flames in the area while you check for leaks.This  
will result in a fire or explosion which can cause serious bodily  
injury or death, and damage to property.  
1. Check the connection between the tank and the regulator for gas  
leaks. Mix a couple of tablespoons of liquid detergent with an equal  
amount of water.  
2. Be sure to leave the burner control valve in the LOCK/OFF position. Wet  
the connection with the soap solution and watch for bubbles. If bubbles  
form or if a bubble grows, there is a leak.  
3. If there is a leak, check the fitting, make sure it is tight, recheck  
the connections.  
4. Check for gas leaks each time you disconnect or connect the gas supply.  
Lighting Your Gas Grill  
ƽWARNING: Always remove the lid before lighting your grill.  
ƽCAUTION: Clearance from combustible material 6 inches from sides,  
24 inches from top.  
1. Push down the burner control valve and turn anti-clockwise to HIGH.  
2. Hold the handle of the bottom unit while pushing the igniter button 2  
or 3 times.  
3. Check to see if the burner is lit by looking through the viewing hole in the  
Flavorizer® Bar.  
ƽWARNING: If burner does not light, turn burner control valve OFF,  
wait 5 minutes for the gas to clear, then try again.  
9
Download from Www.Somanuals.com. All Manuals Search And Download.  
Manual Lighting  
1. Light a match and hold it in one of the four holes in the bottom of the grill.  
2. Push down burner control valve and turn antr-clockwise to HIGH.  
3. Check to see if the burner is lit by looking through the viewing hole in  
the Flavorizer® Bar.  
ƽWARNING: If burner does not light, turn burner control valve OFF,  
wait 5 minutes for the gas to clear, then try again.  
Gas Grill Care  
While lid is warm, wipe inside with paper towels to prevent grease build-up.  
After cooking, burn grease residues off by turning burner control valve to  
HIGH for several minutes with the lid in place.  
It is not necessary to wash cooking grate after each use. Simply loosen  
residue with a brass bristle brush or crumpled aluminium foil. Then wipe  
with paper towels.  
Thoroughly clean your gas grill at least once a year.  
1. Remove cooking grate and FlavorizerBar.  
2. Remove tubular burner before cleaning (refer to assembly instructions)  
To remove: Take out retaining clip and remove regulator assembly.  
Remove wing nut, washer and bolt (on opposite end inside unit). Lift  
tubular burner up and slide out of grill.  
3. Wipe out with paper towels and wash with a mild detergent and water.  
Rinse well. Wash FlavorizerBar and cooking grate with warm soapy  
water. Rinse, then wipe dry with a paper towel.  
4. Reinstall tubular burner, FlavorizerBar, and cooking grate.  
5. Check for gas leaks before operating.  
10  
Download from Www.Somanuals.com. All Manuals Search And Download.  
1
2
3
8
9
10  
11  
12  
13  
14  
4
5
15  
16  
17  
18  
19  
6
7
1-3. Handle  
12. 5/16” Flat Washer  
13. 1/4-20 Wing Nut  
14. Machine Screw  
15. Burner Tube  
16. Igniter  
4. 10-24 Wing Nuts  
5. Retaining Clip  
6. Regulator Assembly  
7. Leg Lock  
8. Lid  
17. Legs  
9. Cooking Grate  
10. Flavorizer® Bar  
11. Bolt  
18. Flat Washer  
19. Bottom unit  
11  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Weber-Stephen Products Co. hereby warrants to  
the ORIGINAL RETAIL PURCHASER of this Weber®  
Gas Go-Anywhere® Grill, that the cooking grate, burner  
tube, and Flavorizer® Bar shall be free from defects in  
material and workmanship for a period of one (1) year.  
All other parts of the Weber Grill shall be free from  
defects in material and workmanship for a period of ten  
(10) years. Weber requires reasonable proof of your  
date of purchase.  
This Limited Warranty does not cover any failures or  
operating difficulties due to accident, abuse, misuse,  
alteration, misapplication, vandalism, improper  
installation or improper maintenance or service, or  
failure to perform normal and routine maintenance.  
Deterioration or damage due to storms, and  
discoloration due to exposure of chemicals and acid  
rain is also not covered by this limited warranty.  
®
© 1999 Weber-Stephen Products Co., Weber, the  
silhouette, and the kettle configuration are registered trademarks of Weber-  
Stephen Products Co., 200 East Daniels Road, Palatine, IL, 60067-6266, U.S.A. This product is covered by one or more United  
States patents and patents in other nations globally. Printed in the U.S.A.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Targus Mouse slim internet multimedia USB keyboard User Manual
TDK Network Card blu2i User Manual
Technicolor Thomson Universal Remote RCR311B User Manual
Toastmaster Toaster TMT4 User Manual
Tokina Camcorder Accessories MVH 2D User Manual
Toshiba DVD Player SD K625 User Manual
Tripp Lite TV Cables N820 03M User Manual
Troy Bilt Snow Blower 5024 User Manual
Uniden Cordless Telephone EXI 8966 User Manual
Vizio Flat Panel Television VX240M User Manual