Gas Barbecue Rotisserie
Fits Summit 450 & 475 and 650 & 675 Gas Grills
Instructions
ƽWARNINGS
• Read all instructions before using your rotisserie.
• This rotisserie is for outdoor use only.
• Remove motor and store in a dry place when
not in use.
• Do not touch hot surfaces. Use barbecue mitts.
• This rotisserie is not for use by children.
• To protect against electrical hazards do not immerse
cord, plugs, or motor in water or other liquids.
• Unplug the motor from outlet when not in use, or
before cleaning
• Do not use rotisserie for other than intended use.
• Make sure motor is off before placing it on the
motor bracket.
Summit 450 & 475 Rotisserie
• Do not operate the rotisserie motor with a damaged
cord or plug.
• Do not operate the rotisserie motor if it
should malfunction.
• The rotisserie motor is equipped with a three prong
(grounding) power cord for your protection against
shock hazard.
• The power cord should be plugged directly into a
properly grounded three prong receptacle. If use of an
extension cord is required, be sure that it is a minimum
16 AWG, 3 wire well insulated cord, marked for
OUTDOOR USE ONLY and properly grounded.
• When using an extension cord, make sure it is not in
contact with hot or sharp surface.
• Outdoor extension cords should be marked with the
letters “W-A” and a tag stating “Suitable for use with
outdoor appliances”.
• Do not cut or remove the grounding prong from the
rotisserie motor power cord.
Summit 650 & 675 Rotisserie
• Do not let cord hang over any sharp edge or
hot surface.
• Use only outdoors, do not expose to rain.
• To reduce the risk of electric shock, keep extension
cord connection dry and off the ground.
• A short power cord is supplied to reduce the risk of
tripping over the cord. Extension cords may be used,
but caution must be taken to prevent tripping over the
cord.
YOU MUST READ THIS OWNERS GUIDE
BEFORE OPERATING YOUR ROTISSERIE
50415 11/00
Download from Www.Somanuals.com. All Manuals Search And Download.
You will need:
Rotisserie Shaft - 1
Adjustable wrench
Thumb Screw - 8 (Summit 450 & 475)
12 (Summit 650 & 675)
Handle - 1
Handle Shaft - 1
1/4 x 20 Keps nut - 2
Lock On Clamp - 4 (Summit 450 & 475)
6 (Summit 650 & 675)
1/4 x 20 x 5/8” Fastener - 2
Meat Clamp - 4 (Summit 450 & 475)
6 (Summit 650 & 675)
Motor - 1
Rotisserie Basket- 1
Download from Www.Somanuals.com. All Manuals Search And Download.
Summit 450 & 475 Rotisserie
1
2
3
1.
2.
3.
4.
5.
6.
Motor (1)
7.
8.
9.
1/4 x 20 x 5/8” inch Fastener (2)
1/4 x 20 Keps Nut (2)
Rotisserie Basket (1)
Motor Bracket (1)
Rotisserie Shaft (1)
Lock Arm (4)
Meat Clamp (4)
Thumb Screw (8)
10. Handle Shaft (1)
11. Handle (1)
®
© 2000 Weber-Stephen Product Co., Weber, the
silhouette, and the kettle configuration are registered trademarks of Weber-
Stephen Products Co., 200 East Daniels Road, Palatine, IL, 60067-6266, U.S.A. This product is covered by one or more United
States patents and patents in other nations globally. Printed in the Taiwan.
Download from Www.Somanuals.com. All Manuals Search And Download.
Summit 650 & 675 Rotisserie
1
2
3
1.
2.
3.
4.
5.
6.
Motor (1)
7.
8.
9.
1/4 x 20 x 5/8” inch Fastener (2)
1/4 x 20 Keps Nut (2)
Rotisserie Basket (1)
Motor Bracket (1)
Rotisserie Shaft (1)
Lock Arm (6)
Meat Clamp (6)
Thumb Screw (12)
10. Handle Shaft (1)
11. Handle (1)
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly Instructions
5. Assembly of Meat Clamp
1. Wash All Components Before Assembly
Insert both Thumb Screws into the holes on the Lock
Arm. NOTE: Do not tighten Thumb Screws fully.
2. Install the Motor Bracket
Attach the stainless steel Motor Bracket to the left side of
the Cooking Box, using the 1/4 x 20 x 5/8” fasteners and
the 1/4-20 Keps nuts.
Screw
Holes
Lock
Arm
Thumb
Screw
Insert middle Meat Clamp Arm into top of the Lock Arm
as shown. Tighten top Thumb Screw to lock Meat Clamp
into shaft.
3. Attach the Motor
Slide the Motor onto the stainless steel Motor Bracket.
Repeat all of step 5 for remaining Meat Clamps.
Middle
Meat
Clamp
Arm
4. Attach Rotisserie Shaft to the Rottisserie
Basket
Screw Handle Shaft and Handle together.
Top of
Lock Arm
6. Attach Meat Clamps to Rotisserie Basket
Face prongs of Meat Clamp toward the inside of the
Rotisserie Basket. Slide bottom of Lock Arm onto
tapered portion of the rail of Rotisserie Basket. Slide
Lock Arm along rail to desired position. Tighten Thumb
Screw at bottom of Lock Arm to fix its position on
Rotisserie Basket.
Screw Rotisserie Shaft to Rotisserie Basket and tighten
shaft with adjustable wrench. Screw Handle
Shaft/Handle to Rotisserie Basket. NOTE: All threads
are counter-clockwise, or tighten to the left.
Tighten
Shaft
Here
Bottom of
Lock Arm
Rotisserie
Shaft
Rotisserie
Basket
Tapered
Rail
Handle
Handle Shaft
Download from Www.Somanuals.com. All Manuals Search And Download.
Operating Instructions
1. Remove Warm-Up basket and cooking grates from grill. Large cuts of food may require removal of warming basket to allow
full rotation of the rotisserie.
Securing Flat Food and 1/2 Chicken/Fowl
Straight end
of Meat
Clamp
Bent end of
Meat Clamp
1/2
Chicken/Fowl
Placement
Flat Food
(Ribs)
Placement
2. Insert the BENT end of Meat Clamp into the lock arm and finger tighten the thumb screws.
3. Place flat food such as a slab of ribs across the set of cradle bars as shown. (Split chicken is placed with the rounded
side towards the rotisserie bars and split/flat side of food towards the Meat Clamp.)
4. Press Meat Clamp, applying good pressure,down on food, adjusting for best grip on food. Finger tighten Thumb Screw
closest to Meat Clamp first then Thumb Screw closest to Rotisserie Basket.
ƽWARNING: When not using all Meat Clamps, remove extra clamps from Rotisserie Basket when not in use.
OR
Summit 650 & 675
Summit 450 & 475
5. Once meat is secure, test stability by rotating rotisserie by hand.
OR
Summit 450 & 475
Summit 650 & 675
If the food becomes loose or unsecure, repeat Steps 4 through 5 until food is secure in Rotisserie Basket.
Download from Www.Somanuals.com. All Manuals Search And Download.
Securing Rounded Meat
Bent end of
Meat Clamp
Straight end
of Meat
Clamp
Round Food,
Chickens or
Roasts
Placement
2. Insert STRAIGHT end of Meat Clamp into the Lock Arm and finger tighten the Thumb Screws.
3. Due to the unique design of the basket; roasts, whole chickens, leg of lamb, etc., DO NOT need to be centered or
balanced in the Rotisserie Basket and can be placed in the Rotisserie Basket at the same time.
4. Press Meat Clamp, applying good pressure,down on food, adjusting for best grip on food. Finger tighten Thumb Screw
closest to Meat Clamp first then Thumb Screw closest to Rotisserie Basket.
ƽWARNING: When not using all Meat Clamps, remove extra clamps from Rotisserie Basket when not in use.
OR
Summit 650 & 675
Summit 450 & 475
5. Once meat is secure, test stability by rotating rotisserie by hand.
OR
Summit 650 & 675
Summit 450 & 475
If the food becomes loose or unsecure, repeat Steps 4 through 5 until food is secure in Rotisserie Basket.
Download from Www.Somanuals.com. All Manuals Search And Download.
Securing Whole Chicken/Fowl Meat
Bent end of
Meat Clamp
Straight end
of Meat
Clamp
Whole Chicken
or Fowl
Placement
2. Insert STRAIGHT end of Meat Clamp into the Lock Arm and finger tighten the Thumb Screws.
3. Due to the unique design of the basket; roasts, whole chickens, leg of lamb, etc., DO NOT need to be centered or
balanced in the Rotisserie Basket and can be placed in the Rotisserie Basket at the same time.
4. When cooking chicken/fowl, the wings should be folded under its body and positioned in the Rotisserie Basket with
breast side up. Then press Meat Clamp, applying good pressure,down on food, adjusting for best grip on food. Finger
tighten Thumb Screw closest to Meat Clamp first then Thumb Screw closest to Rotisserie Basket.
ƽWARNING: When not using all Meat Clamps, remove extra clamps from Rotisserie Basket when not in use.
OR
Summit 450 & 475
Summit 650 & 675
5. Once meat is secure, test stability by rotating rotisserie by hand.
OR
Summit 450 & 475
Summit 650 & 675
If the food becomes loose or unsecure, repeat Steps 4 through 5 until food is secure in Rotisserie Basket.
Download from Www.Somanuals.com. All Manuals Search And Download.
6. Set the Rotisserie Shaft on the cooking box. Slide the
•
Food preparation steps are the same for rotisserie
cooking as for regular cooking. Indicated timing in
cookbook will be the same.
squared end of the Rotisserie Shaft into the Motor.
•
•
•
•
Preheat barbecue for 10 minutes with the lid down.
All cooking is done with the lid down.
Cook by Indirect Method as indicated in recipe.
If foods are too heavy or are irregular shapes, they
may not rotate well and should be cooked by the
Indirect Cooking Method without using
the rotisserie.
7. Set the Handle Shaft on the cooking box. The Handle
Shaft groove should rest in the cut-out of the cooking
box for the Summit 450 & 475 and Summit 650 &
675 gas grill.
•
When meat is done, we recommend that you shut
your grill off and let food rest for a few minutes
before removing from the Rotisserie Basket.
8. Place Rotisserie in grill and allow to rotate a few
turns. If food shrinks and/or becomes unsecure, re-
adjust Meat Clamp as required to secure food in
Rotisserie basket.
ƽWARNING: Rotisserie is metal and will be hot.
Wear oven mits to protect hands during Meat
Clamp adjustment and movement of the
rotisserie.
9. Remove Rotisserie with food from cooking box before
preheating. Preheat barbecue for 10 minutes with lid
down. Follow cooking instructions in your Weber Gas
Barbecue cookbook and adjust the burners as
needed.
•
Carefully open Meat Clamps and remove food with
a fork and/or tongs from Rotisserie Basket and
place food onto plate or plater.
•
Remove Rotisserie Basket from cooking box once
you are completed with cooking and clean
thoroughly.
10. Return rotisserie to the cooking box.
11. Turn the motor on and begin cooking.
12. Check on Meat Clamps periodically making sure
clamps are securely holding food in place.
Tips for Safe Cooking
•
•
•
ALWAYS wear protective gloves when handling your
rotisserie or handle.
ƽCAUTION: Re-adjustment of Meat Clamp may be
required more than once during cooking due to
food shrinkage.
SECURELY tighten thumb screws before starting your
rotisserie.
ƽWARNING: Rotisserie is metal and will be hot.
Wear oven mits to protect hands during Meat
Clamp adjustment and movement of the
rotisserie.
It is normal for meat to shrink during cooking. This can
cause the meat to move around in the Rotisserie
Basket or fall from the basket. It may be necessary to
STOP the rotisserie and secure the Meat Clamp(s),
making sure to once again tighten the Thumb Screws.
Cooking Instructions
•
•
When cooking more than one variety of meat (chicken
and roast), there is no need to balance the difference
in weights, as the basket is designed to carry the
weights evenly.
Cleaning Notes
•
•
Always wash all components before assembly.
The rotisserie basket disassembles for easy cleaning in
a dish washer. Steel wool pads and/or grill brush may
be used for cleaning stubborn areas.
Can hold up to 2 ten pound whole chickens, whole
pork loin, boneless rump roast, prime rib, split chicken
breasts, ribs, 2 cornish hens, Italian or Polish
sausage, leg of lamb, turkey breasts, or turkey legs.
You can also cook a whole fish depending on its size.
•
Meats or poultry should be brought to room
temperature before cooking. (30 to 60 minutes should
be adequate for most foods. If frozen, defrost
completely before cooking.)
•
•
•
Tie meat or poultry with a string to make the shape
as uniform as possible before placing in basket.
Remove cooking grates and warming rack to allow
food to turn freely.
If you wish to save drippings for gravy, place a drip
pan in the center on top of the Flavorizer Bars before
positioning the rotisserie and food in
the barbecue.
Download from Www.Somanuals.com. All Manuals Search And Download.
|