I-drIve dIsconnect Handle
GARAGE DOORS & OPENERS
P.o. Box 67 Mt. Hope, oH 44660
supplemental insert
© 2009 Wayne-dalton corp. Part no. 342295 neW 5/29/2009
This supplemental installation instruction is to be used as a supplement to the main Installation Instruction and Owner’s Manual provided with the door. The instructions included in
this document are ONly those which deviate from the standard installation. All wARNINgs and cAuTIONs listed in the main manual are applicable to this supplemental instruction as
well.
1
Torquemaster®
Hole in right
end bracket
Routing Disconnect Cable
Thread the disconnect cable through the hole in the right hand
end bracket down through the long slot in the horizontal leg of
the horizontal angle. Remove all slack between opener and
right end bracket.
Tools Needed:
NONE
Disconnect
cable
2
Hole in
right
Routing Disconnect Cable
side of
end
bracket
Mark a location on the right Jamb, 6 feet above the floor to
mount disconnect handle bracket.
Tools Needed:
Pencil
Align top of the handle with the mark and mark location for
two lag screws.
Tape Measure
Power Drill
1/8” Bit
Pilot drill lag screw location using 1/8” drill bit. Fasten bracket
to the jamb with (2) 1/4” x 1-1/2” lag screws.
Torquemaster® Plus
Hole in right
end bracket
Disconnect
cable
7/16” socket
Driver
Hole in
right
side of
end
bracket
Disconnect
cable
slot in
horizontal angle
6ft
Disconnect
(2) 1/4” X
1-1/2”
lag screws
handle and
mounting
bracket
1
Download from Www.Somanuals.com. All Manuals Search And Download.
|