Viking Installation Guide
Viking Range Corporation
111 Front Street
Greenwood, Mississippi 38930 USA
(662) 455-1200
For product information,
call 1-888-VIKING1 (845-4641)
or visit the Viking Web site at
vikingrange.com
Professional & Designer Freestanding
Refrigeration Side Trim, Side Panel,
Top Panel & Grille Installation
F20713 EN
(012010)
Download from Www.Somanuals.com. All Manuals Search And Download.
Installation - Side Panel, Top Panel and Grille
(Wrapped Installation)
Installation - Side Trim and Grille
(Built-In Installation) (cont.)
B
6
7
1
Top Panel
Front Grille
Screws
”
2
7
Caps
Left Panel Right Panel
A
B
C
Raise the unit up until the measurement from the floor
to the top of the grille assembly is 72 inches or 6 feet.
Required Components
Remove and discard screw and hinge cover, if
applicable. (Repeat if two hinges are used.)
Secure the grille brackets to the holes in the hinge
plate with two B screws.
8
9
3
2
1
1
2
2
2
2
A
A - Designer Series
B - Pro Series
With top panel and grille upside down, position grille
assembly in front of top panel. Secure top panel to grille
assembly via four outer holes and three inner holes.
Shim trim has adhesive backing on both sides. Remove adhesive
backing on refrigerator side only. Fit the shim trim to the front of the
unit first. Locate the top of the shim trim with the top of the
refrigerator cabinet.
Remove adhesive backing for the side trim. Locate the
top of the side trim with the top of the grille assembly.
Press the side trim into the refrigerator cabinet at the
center location.
Remove edge of corner cover.
5
4
1
2
Remove adhesive backing from the side panel. Fit the
side panel to the front of the unit first.
Attach rear of side panels with screws.
NOTE: The holes on the side panel are clearance holes.
4
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Installation - Side Panel, Top Panel and Grille
(Wrapped Installation) (cont.)
6
7
1
2
2
Attach rear of side panels with screws.
NOTE: The holes on the side panel are clearance holes.
Remove adhesive backing from other side panel. Fit the
side panel to the front of the unit first. Spacer on top of
side panel needs to sit on top of refrigerator cabinet.
C
9
8
Align top panel and grille assembly to front door and
position top panel and grille on top of unit.
Insert screws through holes of top panel into side
panel.
10
Insert cap covers into holes.
6
7
Download from Www.Somanuals.com. All Manuals Search And Download.
|