Aurora,Ohio 44202
1275 Danner Drive
VIDEO
PRODUCTS
INCORPORATED
Tel: 330-562-7070 Fax: 330-562-1999
VPI
INSTALLATION GUIDE FOR THE
SE-SV-2-LC
INTRODUCTION
The SE-SV-2-LC S-Video Switch allows two S-Video sources to be switched between a single S-video display. The S-video may come from
sources such as a PC, DVD player, satellite receiver, or VCR to name a few. With 150 MHz bandwidth, the SE-SV-2-LC supports standard S-
video resolution–up to 800 x 600.
INSTALLATION
1. Turn OFF power to sources and display.
2. Connect the SVEXT-3-MM S-video cable (supplied) from the display to the female connector labeled "S-VIDEO OUT" on the SE-SV-2-LC.
3. Install one male end of another SVEXT-x-MM cable (not supplied) into a source’s S-video output connector.
4. Install the other male end of the same SVEXT-x-MM cable into the female connector labeled "S-VIDEO IN 1" on the SE-SV-2-LC.
5. An additional S-video source may be plugged into the remaining female connector labeled "S-VIDEO IN 2" as required.
6. Plug in the AC adapter and connect it to the SE-SV-2-LC.
7. Turn ON power to the sources and display.
Note: Additional S-video cable lengths (SVEXT-xx-MM where xx is the length of the cable in feet) may be ordered from Video Products
AC Adapter
(supplied)
PC, DVD, Satellite,
or VCR
S-Video Cable
(not supplied)
R
S-Video Cable
(not supplied)
VPI
Video Products Inc
SVEXT-3-MM
(supplied)
SE-SV-2-LC
PC, DVD, Satellite,
or VCR
Top View of SE-SV-2-LC
Right End View of SE-SV-2-LC
Left End View of SE-SV-2-LC
OPERATION
Press the select button to switch between connected S-video sources.
Download from Www.Somanuals.com. All Manuals Search And Download.
|