Wireless Travel Mouse with Stow-Away Receiver
User Manual
Product Features
1. Radio frequency 27MHz wireless transmission
2. Use of 256 ID codes to prevent interference between several wireless mice being used
simultaneously
3. Automatic power sleep function to extend battery life
4. Storage area for receiver in the mouse
System Compatibility
Win 95/98/Me/2000/XP
Macintosh 9.x, 10.x
Initial Set up
1. Turn the computer power on and log in
2. Connect wireless mouse receiver to USB port
3. Ensure batteries are installed in the mouse and mouse power is turned on (See
instructions below).
4. Hold mouse close to the receiver
5. Using a pen or other pointed device click the ID button on the receiver once, (See Figure
1 below). The red light will start to flash
6. Next, click the ID button on the underside of the mouse as indicated in Figure 1
Figure 1
7. The red light on the receiver will flash rapidly for a few seconds then stop flashing
Download from Www.Somanuals.com. All Manuals Search And Download.
Figure 4
Note:
1. Please remove the batteries if the mouse will not be used for an extended period of time
2. If the mouse has entered power sleep mode please press any mouse button or move the
mouse to make it active again
3. To turn the mouse power off click on the ID button on the underside of the mouse for
over 3 seconds until the light turns off
4. Optical mouse will not operate correctly on any reflecting surface such as glass or 3D
mouse pads
Caution
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. Note: This equipment has been
tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
*ꢀ Reorient or relocate the receiving antenna.
*ꢀ Increase the separation between the equipment and receiver.
*ꢀ Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
*ꢀ Consult the dealer or an experienced radio/TV technician for help.
Download from Www.Somanuals.com. All Manuals Search And Download.
|