•
Dial the phone number.
STEP 3 Battery installation
STEP 1 Check package contents (mi6866)
-OR-
•
•
Dial the phone number.
Press
1. Align the two holes in the plug with the socket pins,
then snap the plug into place. Place the battery in the
compartment with the wires in the upper right corner.
2. Replace cover by sliding it upwards until it clicks into
place.
Make sure your phone’s packaging includes the following:
.
Quick Start Guide
Receiving a call
mi6896/6895/6870/6866
Press
OFF.
, SPEAKERPHONE, or any dialing key except
STEP 1 Check package contents (mi6896/6895)
Make sure your phone’s packaging includes the following:
Hanging up
Press OFF or place the
handset in its base.
Handset
Belt clip
Charger power adaptors (3)
Base unit
STEP 7 Set the Clock
STEP 4 Charge the battery
Handsets (4)
Chargers (3)
Base unit
1. Press TIME/SET to listen to the current setting.
2. Press TIME/SET again to indicate changes needed.
3. Press CHANGE to change the day, hour, minute, or year.
1. Place the handset in the base unit/chargers.
2. Charge the battery for at least 16 hours before first use.
Telephone line cord
Battery
Quick start guide
4. When you hear the correct setting, press TIME/SET to
advance to the next setting.
Batteries (4)
Belt clips (4)
Telephone line cord
Quick start guide
NOTE:
If you have caller ID service, the time will automatically
be updated with the first incoming call after you
program the year into the system.
User’s manual
Base power adaptor
Wall mount bracket
User’s manual
Base power adaptor
Wall mount bracket
STEP 1 Check package contents (mi6870)
STEP 2 Connect power to telephone base/
chargers
STEP 8 Record your outgoing announcement
STEP 5 Connect to phone line
Plug one end of the telephone line cord into the telephone line
jack at the bottom of the telephone base. Then plug the other
end of the cord into the wall telephone outlet.
Make sure your phone’s packaging includes the following:
1. Press SETUP, the system announces “Announcement.
Press PLAY or press RECORD. To continue setup, press
SETUP.”
2. Press REC/MEMO and speak toward the MIC on the base
to record an announcement for up to 90 seconds.
Plug the power adaptor into an electrical outlet not controlled
by a wall switch, and the connector into the power jack on
bottom of the telephone base/chargers.
Telephone outlet
AC power outlet
Charger power adaptor
3. Press PLAY/STOP
/
( when finished recording).
AC power outlet
NOTE:
For complete feature instructions, please refer to your
user’s manual.
Handsets (2)
Charger
Base unit
IMPORTANT!
If your product is not working properly:
1. Refer to your user’s manual.
www vtechcanada.com.
3. Call our customer service at 1-800-595-9511 or 1-800-267
7377 in Canada.
STEP 6 Making and receiving calls
Making a call
Batteries (2)
Belt clips (2)
Telephone line cord
Quick start guide
•
Press
or SPEAKER and listen for dial tone.
NOTE:
User’s manual
Base power adaptor
Wall mount bracket
•
Use only the power adaptors supplied with your
VTech telephone.
96-006136-020-100
Download from Www.Somanuals.com. All Manuals Search And Download.
|