Uniden Telephone Elite 8805 User Manual

ELITE 8805  
ELITE SERIES  
EXPANSION HANDSET  
OWNER'S  
MANUAL  
OWNER'S MANUAL  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Installing Your Expansion Handset  
Follow these three easy steps to get your new handset ready to use:  
1 Install the battery pack.  
2 Connect the charger and charge your new handset for 15 - 20 hours.  
3 Register your new handset to the main base.  
Step 1: Install the Battery Pack  
1 Press down on the handset battery case  
cover (use the finger indention for a better  
grip) and slide the cover downward to  
remove.  
2 Place the battery pack in the battery  
compartment with the connectors on the  
battery and on the compartment aligned.  
3 Place the battery case cover back on the  
handset and slide it upwards until it clicks  
into place.  
Use only the Uniden battery (BT-  
0003) supplied with your phone.  
Replacement batteries are available.  
Please see our website at  
Recharge your handset on a regular  
basis by returning the handset to  
the charger after each phone call.  
Rechargeable Ni-MH Batteries  
Must Be Recycled or Disposed of Properly  
(2)  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Step 2: Connect the Charger  
1 Connect the AC adapter to  
the DC IN 9V jack and to a  
standard 240V AC wall outlet.  
2 Set the charger on a desk or  
tabletop, and place the  
handset in the charger with  
the LCD screen facing  
forward.  
3 Make sure the charge LED  
illuminates. If the LED does not  
illuminate, check to see that the AC adapter is plugged in and that  
the handset makes good contact with the charger charging contacts.  
Use only the supplied AAD-600S AC adapter. Do not use  
any other AC adapter.  
Place the charger close to the AC outlet so that you can  
unplug the AC adapter easily.  
4 Charge the handset for 15 - 20 hours before using.  
Step 3: Register the Handset  
YOU NEED TO REGISTER THE ELITE8805 SERIES TO THE MAIN BASE  
BEFORE USE!  
For Backward Compatible Base Models - DSS7800 series [DSS7815,  
DSS7815+1, DSS7855 and DSS7855+1]  
1
2
Disconnect the AC adapter from the main base.  
While pressing down on the following key, reconnect the AC adaptor.  
DSS7815/DSS7815+1 models - find handset key  
DSS7855/DSS7855+1 models - flash/find hs key  
Keep pressing the key until the CHARGE LED starts to blink.  
3
On the handset, press and hold the # key until you hear a beep.  
(3)  
Download from Www.Somanuals.com. All Manuals Search And Download.  
For ELITE8815/ELITE8815+1  
1 Press and hold the Registration  
button at the underside of the base.  
2 Keep pressing the Registration  
button until the handset charge  
LED on main base starts to blink.  
3 On the handset, press and hold the  
# key until you hear a beep.  
Registration button  
For Main Base Models ELITE8855/ELITE8855+1  
1 With the main base in standby mode (i.e. not being used), press  
menu/select on the base.  
2 Use the up/down key to select System Setup.  
3 Use the up/down key to select Register Handset.  
4 The base LCD screen will display the following prompt:  
On handset, press and hold "#" key for 2 sec  
5 On the handset, press and hold the # key until you hear a beep.  
De-register the handset  
1 Press and hold end and # for more than 5 seconds. Select  
Deregister Hs.  
2 The phone will ask you to confirm the deregistration. Select Yes.  
Select Replacing Base at instruction 1 if handset has previously  
been registered to another base and you want to register to a new  
base.  
(4)  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Using Your Expansion Handset  
Now that your new handset is registered, it can perform all the same  
functions as the handsets originally included with your phone. With  
your new handset, you can;  
Transfer calls between handsets  
Use two handsets as 2-way radios in DirectLink mode  
Use two handsets or a handset and the base as a baby/room  
monitor  
Hold 3 to 4 way conference calls (depends on the model)  
Access the integrated answering device or voice mail using the  
handset  
Record Distinctive Ringer Tones  
See the owner's manual that came with your main base for complete  
instructions on operating your new expanded digital phone. You can  
(5)  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Using the joystick  
The joystick makes it easy  
to use your phone. The  
four most commonly used  
functions are accessible  
just by moving the  
joystick:  
To enter the menu, press the centre of  
the joystick inwards.  
Highlight the option you want by moving the  
joystick up, down, right, or left on the  
handset. This will move the cursor; the  
option currently highlighted appears in  
reversed out text.  
Select the highlighted option by pressing in  
on the center of the joystick.  
To exit the MENU and return to standby, press the end key on the  
handset.  
To go back a level in the menu, press the  
back/hold/int'com .  
(6)  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Setting Advanced Features  
When using your handset with the backward-compatible  
DSS7800 Series (DSS7815, DSS7815+1, DSS7855 and  
DSS7855+1), some advanced features (such as  
Reminders) may not be compatible.  
Please refer to your respective (DSS7815, DSS7815+1,  
DSS7855 and DSS7855+1) Owner's Manual.  
Record Ringer Tones  
1) Connect the audio recording cable to the handset and sound source  
(e.g. stereo or CD player). Insert one end of the audio recording  
cable into the handset's headset jack and the other end into the  
sound source. You can also simply use the handset's microphone by  
holding the handset close to the sound source.  
2) Select menu option  
3) Go to Rec/Edit Rings.  
.
4) Select a location from 1-5, and press the OPTIONS soft key.  
5) Select Record. To start recording, press the RECORD soft key. The  
message counter displays 20 and then begins to count down.  
6) When you are finished recording, press the STOP soft key. The  
phone will play the recorded ringer. To re-record the ringer, press  
the ReRec soft key.  
7) Enter the title of this ringer (up to 12 Characters) using the number  
keypad, the DELETE soft key, right, or left key.  
8) Press the center of the joystick, you will hear a confirmation tone,  
and Done! appears.  
Set Animation Type  
1) Select menu option  
.
2) Go to Animation Type and highlight the animation you want.  
3) Press the SELECT soft key to activate it.  
Set Themes (wallpaper)  
1) Select menu option  
.
2) Go to Wall Paper and highlight the wallpaper you want. Press the  
VIEW soft key to see the wallpaper or the center of the joystick to  
activate it.  
(7)  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Set Color Scheme (Color handsets Only)  
1) Select menu option  
2) Go to Color Scheme and select the color you want. As you scroll  
.
through the options, the phone displays the highlighted color for you.  
Creating and Editing Phonebook Entries  
Press the joystick to the left, and then press the STORE soft key for the  
1st entry. From the 2nd entry, press the OPTIONS soft key. Select New  
Entry to store, or Edit Selection to edit the location. Enter as  
much information as you want. Press the center of the joystick to enter  
each entry and confirm the selection. When you finish, press the DONE  
soft key to save this phonebook entry.  
Operational Restrictions  
Several of your handset's advanced settings such as Room Monitor,  
Unique ID and Call Privacy, will operate differently with the DSS7800  
Series Phones.  
Setting Privacy Mode  
Privacy mode prevents interruption from other registered handsets or  
the base. This works only when the phone is in use:  
While on a call, press the OPTIONS soft key. Use the joystick to select Call  
Privacy, Privacy Mode On appears in the display. To exit  
Privacy Mode, use the same procedure.  
OR  
1) Select menu option  
2) Go to Handset.  
3) Select Call Privacy.  
.
4) Use the joystick to select On.  
You will hear a confirmation tone.  
(8)  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Setting Unique ID  
You can assign special ringer tones to anyone in your phonebook. When  
your phone gets a call, it looks up the Caller ID information in your  
phonebook; if you have assigned a distinctive ringer and pictures to  
that number, the phone uses them to tell you who's calling.  
1) Select  
.
2) Go to Handset.  
3) Select Unique ID.  
4) Use the joystick to select On.  
A confirmation tone tells you that distinctive ringing is active.  
When viewing a Caller ID entry, the picture that  
corresponds to the Phonebook Unique ID setting appears.  
If the Unique ID is set to Off, the phone uses the default  
picture for viewing Caller ID entries.  
Setting Room Monitor On/Off  
To prevent the monitoring of a particular handset or the base, simply  
turn off the Room Monitor Feature.  
To turn off the Room Monitor:  
1) Select  
.
2) Go to Handset.  
3) Select Room Monitor.  
4) Use the joystick to select Off.  
You will hear a confirmation tone.  
(9)  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Battery Information  
Low battery alert  
When the battery pack is very low, the phone is programmed to  
eliminate functions in order to save power.  
The battery pack needs to be charged when:  
30/05 SUN 10:10A  
-
-
The empty battery icon appears.  
Low Battery appears in the display.  
If the phone is in standby mode, none of the  
keys will operate. If you are on a call,  
complete your conversation as quickly as  
possible, and return the handset to the  
cradle.  
Low Battery  
New CID: 10  
Cleaning the battery charging contacts  
To maintain a good charge, clean the charging contacts on the  
handset once a month. Dampen a cloth with plain water. Gently rub  
the damp cloth over the charging contacts until all visible dirt is  
removed. Dry the contacts thoroughly before returning the handset  
to the cradle.  
Caution: Do not use paint  
thinner, benzene, alcohol, or  
other chemical products. Doing  
so may discolor the surface of  
the telephone and damage the  
finish.  
(10)  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Warranty  
UNIDEN ELITE 8805 Handset  
Limited One Year Warranty  
Note: Please keep your sales docket as it provides evidence of warranty.  
Warrantor: Uniden Australia Pty Limited ABN 58 001 865 498  
Uniden New Zealand Limited  
Warranty only available in original country of purchase  
Elements of Warranty: Uniden warrants to the original retail owner for the duration of  
this warranty, its ELITE 8805 Handset (hereinafter referred to as the Product) to be free  
from defects in materials and craftsmanship with only the limitations or exclusions set  
out below.  
Warranty Duration: This warranty to the original retail owner only, shall terminate and  
be of no further effect ONE (1) Year after the date of original retail sale. This warranty  
will be deemed invalid if the product is; (A) Damaged or not maintained as reasonable  
and necessary, (B) Modified, altered or used as part of any conversion kits,  
subassemblies, or any configurations not sold by Uniden, (C) Improperly installed, (D)  
Repaired by someone other than an authorized Uniden Repair Agent for a defect or  
malfunction covered by this warranty, (E) Used in conjunction with any equipment or  
parts or as part of a system not manufactured by Uniden, (F) Installed, programmed or  
serviced by anyone other than an authorized Uniden Repair Agent, or (G) Where the  
Serial Number label of the product has been removed or damaged beyond recognition.  
Parts Covered: This warranty covers for 1 year, the Handset and Charge Unit only.  
Accessories: Batteries, AC adaptor etc are covered for 90 days.  
Statement of Remedy: In the event that the product does not conform to this warranty  
at any time while this warranty is in effect, the warrantor at its discretion, will repair the  
defect or replace the product and return it to you without charge for parts and service.  
THIS WARRANTY DOES NOT COVER OR PROVIDE FOR THE REIMBURSEMENT  
OR PAYMENT OF INCIDENTAL OR CONSEQUENTIAL DAMAGES. THIS  
GUARANTEE IS IN ADDITION TO AND DOES NOT AFFECT YOUR RIGHTS UNDER  
THE CONSUMER GUARANTEES ACT.  
Procedure for obtaining performance or warranty: In the event that the Product  
does not conform to this warranty, the Product should be shipped or delivered, freight  
prepaid, with evidence of original purchase, (e.g. a copy of the sales docket), to the  
warrantor at:  
UNIDEN AUSTRALIA PTY LTD  
Service Division  
UNIDEN NEW ZEALAND LTD  
Service Division  
345 Princes Highway,  
Rockdale, NSW 2216  
Fax (02) 9599 3278  
150 Harris Road, East Tamaki,  
Auckland  
Fax (09) 274 4253  
© 2005 Uniden Australia Pty Limited/Uniden New Zealand Limited  
Printed in China UUZZ01435BZ(0)  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Targus Mouse Palm m125 User Manual
Texas Instruments TV Converter Box DAC3482 User Manual
Thermador Oven PODC301 User Manual
Thule Bicycle Accessories 960 Freeway User Manual
Toastmaster Convection Oven RA 5T User Manual
Tote Vision Computer Monitor LCD 1048HD User Manual
Troy Bilt Lawn Mower 769 10459 User Manual
Villaware Hot Beverage Maker BVVLKTSL01 User Manual
Watlow Electric Water Heater Firerod Immersion User Manual
Weber Gas Grill 55052 0100 User Manual