UVPS Welding System B003 001 User Manual

Lamp Voltage Interface™  
Installation and Operation Instructions  
Model No. B003-001  
SAFETY  
2. Loosen and remove the nut that secures the lamp  
lead to the ballast terminal. Do not remove the  
lead from the terminal.  
1. To ensure safe installation and use of your Lamp  
Volt Interface™ (LVI™), please direct all users  
to read this technical sheet.  
3. Slip the round, closed-end LVI™ connector lead  
over the ballast terminal and secure.  
2. Turn off the power supply at its source before  
installing this unit, or before performing any  
maintenance work.  
4. Locate the first capacitor that is wired directly to  
the first mercury relay. Plug the stab-on  
3. ALLOW TIME FOR CAPACITORS TO  
DISCHARGE BEFORE WORKING ON  
ANY POWER SUPPLY.  
connector onto an available tab on the capacitor.  
5. Mount the LVI™ junction box to the inner side-  
wall of the power supply cabinet. This unit can  
be mounted by drilling two holes in the side of  
the cabinet, and securing the junction box with  
two #6, #8 or #10 screws. Proper mounting will  
prevent excessive vibration and ensure  
4. DO NOT TOUCH EXPOSED POSITIVE OR  
NEGATIVE INTERFACE LEADS WHEN  
INSTALLING THIS DEVICE.  
5. Keep flammable materials a minimum of three  
feet from any operating equipment.  
consistent, long-term performance.  
6. Connect the interface leads into appropriate +/-  
screw receptacles on a high impedance, panel-  
mount volt meter (must be a true RMS volt  
meter; available directly from UVPS).  
6. Do not alter the wiring of this unit prior to,  
during or following installation.  
7. The LVI™ permits volt reading by a high  
impedance meter by reducing the actual reading  
to 1/100th of actual power. Therefore, an actual  
voltage of 2000V would be displayed as “20.00.”  
7. Close the power supply cabinet when assembly  
is complete. Turn power on at its source.  
OPERATION  
INSTALLATION  
1. Turn your curing system or machinery on.  
The Lamp Volt Interface™ must be installed parallel  
with the curing system’s UV lamp wiring. Therefore,  
connector leads are to be installed directly over  
respective lamp leads connected to ballast and  
capacitor terminals.  
2. With the LVI™ integrated directly between your  
curing system’s incoming power source and the  
capacitor, the panel-mount voltmeter will  
indicate (via its LCD or LED display) volt levels  
at .01 of actual power. Therefore, for units  
operating at 2450v, the voltmeter will display a  
reading of “24.50v”.  
1. With electrical power shut off at the source, open  
the power supply cabinet to expose your curing  
equipment’s electrical components. Allow  
enough time for capacitors to discharge all  
electrical energy before beginning any work.  
1
Download from Www.Somanuals.com. All Manuals Search And Download.  

Toro Lawn Mower 91764SL User Manual
Toshiba Label Maker B EX User Manual
Tricity Bendix Cooktop L55M2 User Manual
Tricity Bendix Cooktop SIE554 User Manual
Uniflame Outdoor Fireplace WAD996SP User Manual
Universal Smoke Alarm CD 9585 User Manual
ViewEra Computer Monitor V195MV User Manual
ViewSonic Flat Panel Television VS11439 3M User Manual
ViewSonic Flat Panel Television VS12512 User Manual
Vivitar Digital Camera VX025 BLACK User Manual