200409159 B114-008 Video Splitter Owners Manual.qxd 10/1/2004 1:28 PM Page 1
User's Manual
Video Splitter (8-Port)
Model #: B114-008
NOTE: Follow these installation and operating
Tripp Lite World Headquarters
procedures to ensure correct performance and
to prevent damage to this unit or to its
connected devices.
1111 W. 35th Street,
Chicago, IL 60609 USA
Introduction:
The Video Splitter is a signal booster and splitter that takes video input from a single source and directs it to
multiple video outputs for monitors using analog signals. It extends the distance a signal is sent to about 210 ft.
Features:
•
•
•
•
•
One video input to multiple video outputs
Transmission distance of up to 210 feet
Suitable for SVGA, VGA, and Multisync monitors
Daisy-chain multiple units to increase the number of outputs
Power-save mode, when the computer is off the power indicator LED's flash
IMPORTANT NOTE: This unit is not designed for CGA, EGA or MONOCHROME type monitors or
any monitor using a digital video signal.
Specifications:
Power Consumption
Maximum Cable Length
Signal Type
DC 9V, 250mA(max)
210 feet
VGA, SVGA, Multisync Monitor
Video Signal Gain Control
Slide Switch
Installation:
Stand-Alone Installation:
1. Connect the PC's video output port to the Video Splitter's “Video In” port using an HDDB15 Male/Female
Monitor Extension Cable (Tripp Lite # P500-006, P510-006, P510-010 or P510-015).
2. Connect the Video Splitter's “Video Out” ports to the input of your monitors either by using the existing
cable on the monitor or by using an HDDB15 Male/Male Monitor Cable (Tripp Lite # P502-006, P512-006
or P512-010).
3. Connect the provided power supply to the Video Splitter and turn on the unit. Your Video Splitter is ready to go.
NOTE: A slide switch located under the Splitter is used to control the Signal Gain (also known as Power
Boost). For short distances, set the switch to “Normal” Gain by sliding the switch toward the front panel of
the unit. As the distance between Splitter and monitor increases, you may need to increase the unit's Gain by
sliding the switch towards the back.
WARNING!
Use ONLY 9V DC in the operation of these devices.
Copyright © 2004 Tripp Lite. All rights reserved. All trademarks are the property of their respective owners.
Technical specifications are subject to change without notice.
Download from Www.Somanuals.com. All Manuals Search And Download.
|