Specifications:
Case size dimensions:
AUI Port:
3.5" x 3.75" x 1.25" (89 mm x 95 mm x 32 mm)
Male DB-15 with locking posts.
Minneapolis, MN 55344 USA
AUI Connection:
Use only an IEEE 802.3 equivalent AUI
cable.
Connector Legend:
1
2
3
4
5
6
7
8
Logic Ref.
Collision+
Transmit+
Logic Ref.
Receive+
Power Return
N/C
9
Collision-
Ethernet Coaxial Transceiver
10 Transmit-
11 Logic Ref.
12 Receive-
13 Power
14 Logic Ref.
15 N/C
E-CX-MC02, E-CX-MC03, E-CX-MC04, E-CX-MC05
USER’S GUIDE
The TRANSITION Networks Ethernet™ Coaxial Transceiver (E-CX-MC02, E-CX-MC03,
E-CX-MC04, or E-CX-MC05) is designed to provide connection between the Thick
(10Base5) or Thin (10Base2) coaxial Ethernet environment and a PC or hub with an
AUI connector.
Logic Ref.
AUI Drop Cable Maximum Distance: 50 meters (165 feet)
10Base5 Cable Maximum Distance:
10Base2 Cable Maximum Distance:
Environment:
500 meters (1640 feet)
185 meters (610 feet)
0–50 degrees C,
10–90% humidity, non-condensing,
0–10,000 foot altitude
Warranty:
Five years
Power
FCC Regulations:
SQE Enabled
Ethernet™
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the interference at his own cost.
Coaxial
Transceiver
T R A N S In T Iw O rN
e
t
o
k
s
Mpls, MN 55344
NOTE:
This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out
on the radio interference regulations of the Canadian Department of Communications.
The TRANSITION Networks Ethernet™ Coaxial Transceiver part numbers indicate
the AMP tap that is shipped with the Coaxial Transceiver:
NOTE:
This equipment has been tested and found to comply with VDE Class B requirements.
For selling in the Federal Republic of Germany:
Hiermit wird bescheinigt, das der E-FRL-MC01 oder E-FRL-MC01(SMA) in Ubereinstimmung mit den
E-CX-MC02:
E-CX-MC03:
E-CX-MC04:
E-CX-MC05:
with AMP non-intrusive tap
with AMP N-Series intrusive tap,
with AMP BNC-T connector
with AMP BNC vertical adapter
228752-1
221914-1
221918-1
222455-1
Bestimmungen der Vfg. 243/1991 funk-entstoert ist. Der Deutschen Bundespost wurde das
Inverkehgringen dieses Geraetes angezeigt und die Berechtigung zur Ueberpruefung der Serie auf
Einhaltung der Bestimmungen eingeraumt. TRANSITION Networks, Inc.
Canadian Regulations:
Note: This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on the
radio interference regulations of the Canadian Department of Communications.
All Ethernet™ Coaxial Transceivers provide a male AUI connector.
Status LEDs on the Ethernet Coaxial Transceiver provide the following
information:
Copyright Restrictions
© 1995 Transition Networks, Inc.
All rights reserved. No part of this work may be reproduced or used in any form or by any means - graphic,
electronic, or mechanical - without written permission from Transition Networks, Inc.
Power:
Illuminated green LED indicates power through the
AUI connector.
Trademarks:
Ethernet is a registered trademark of the Xerox Corporation, Inc.
ST is a trademark of AT&T.
SQE Enabled
Illuminated green LED indicates the SQE jumper is set
to ON.
Download from Www.Somanuals.com. All Manuals Search And Download.
|