INSTALLATION INSTRUCTIONS
Product No.
33049
TOYOTA TUNDRA
75105
SMALL PARTS
PLYMOUTH, MI
PACKAGE K75105
IMPORTANT NOTES
USE ONLY TOWING PRODUCTS SUPPLIED OR APPROVED BOLTS,
LOCKNUTS, AND WASHERS TO INSTALL THIS HITCH
WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY
OCCUR DUE TO OVER TIGHTENING.
WARNING: DO NOT DRILL OR WELD TO THIS HITCH.
TOOLS REQUIRED
3/4” SOCKET
18mm SOCKET
TORQUE WRENCH
1/2” SERRATED WASHER
12mm HEX BOLT
TO WELD NUTS IN THE FRAME
1/2” CARRIAGE BOLT
BOLT PLATE
1/2” SERRATED WASHER
1/2” LOCK NUT
1. Lift the receiver up to the frame of the vehicle. Locate the large holes in the receiver brackets over the rivet heads in the
frame.
2. Install four (4) 1/2” serrated washers over four (4) 12mm hex bolts and insert the bolts up through the receiver brackets
and into the weld nuts in the frame. See the diagram above.
3. Install two (2) bolt plates over two (2) 1/2” carriage bolts and insert the bolts down through the frame and the receiver
brackets. Install 1/2” serrated washers and 1/2” lock nuts on the bolts. See the diagram above.
4. Torque the 12mm bolts to 75 LB-FT.
Torque the 1/2” nuts to 75 LB-FT.
(OVER)
For Installation Assistance or Technical Help, Call 1-574-537-6339
Download from Www.Somanuals.com. All Manuals Search And Download.
N75105-12-9-02 EWO3289 © 2002 TOWING PRODUCTS
Litho in USA
|