Tiger Lily Products
TLP, Blinder, Bel, Escort, Valentine
PO Box 549
Tel
303-678-9101
303-678-9103
Cel: 720-635-3931
Cel: 720-298-0557
Niwot, CO, USA 80544
Fax
Email [email protected]
High Performance
Radar, Laser & Photo
Countermeasures
PRS1-V-360, PRS2-V, PRS3-V, PRS4-V Installation Instructions, 2 Parts
Part 1 of 2: Blinder™ M25 (Dual) & M45 (Quad) Laser Jammer Installation Instructions
We recommend the customer hire a qualified technician to install the Blinder M25 and M45 Laser Jammer.
INSTALLATION: The Blinder™ M25 should be mounted on the front of the vehicle, centered between the license plate and center of
each headlight The M45 adds two additional modules, permitting 3 laser modules in front and 1 rear, or 2 in front and 2 rear on either side
of the rear license plate. Do not look directly/indirectly into the lens of the Blinder™ at close range, as it emits a bright beam of light
invisible to the human eye and will cause eye damage with prolonged exposure. Install the Blinders level and horizontal with the level
device provided in the kit. A block diagram for the M25 and M45 installation are shown below.
MOUNTING:
1) Locate the ideal horizontal location for the Blinder Module (see drawing below for 2/3/4 install in front). Locate the modules
behind the grille for best, hidden view, but do not allow any physical object in front of the lens.
2) Make sure the vehicle is parked on a level surface. Install the laser modules level and pointing straight out from the vehicle. If the
grille is rounded, ensure the laser modules are pointing straight out and level. See Diagram left.
3) Use provided hardware to fix the Blinder into position. Recheck the level of each laser module before and after tightening to
position, using the yellow LEVEL device provided. Remove level device after correct install, snap the inserts provided into the
level hole of each laser module to achieve a clean, smooth look on each module.
4) Each of the Blinder Jammer modules is connected to the single interface via telephone plug in jacks. The installer will need to find
a suitable thru hole in the firewall to route the M25 (2) cables or M45 (4) cables through the firewall. Each cable has a firewall
grommet, permitting you to replace the present firewall grommet with the Blinder Grommet. You may need to drill a 7/16”
(11mm) diameter hole in the firewall. Use the grommet provided on each cable to seal the firewall.
M25 (2 front modules) M45 (3 front modules)
(1 rear module)
M45 (4 front modules)
Rated #1, 360 Degree, High Performance, PRS1-STi-360™ Prowler Remote™ System
PROWLER Remote, PRS1-STi-360, PRS1-V-360, PRS2-V, PRS2-STi, PRS3-V, PRS3-STi, PRS4-V, PRS4-STi, Got Performance are trademarks of Tiger Lily Products. All rights reserved. Copyright 1999-2008.
Got Performance™
Download from Www.Somanuals.com. All Manuals Search And Download.
Tiger Lily Products
TLP, Blinder, Bel, Escort, Valentine
PO Box 549
Tel
303-678-9101
303-678-9103
Cel: 720-635-3931
Cel: 720-298-0557
Niwot, CO, USA 80544
Fax
Email [email protected]
WWW.1-Radar-Laser-Jammers-Detectors.com
Best-in-Test
Radar, Laser & Photo
Countermeasures
Part 2 of 2: V1 Install Instructions, V1 & Valentine 1 Programming, November 2007
Call us at 303-678-9101 if you want help in changing your Valentine 1 modes of operation.
1. Use J Hooks hardware to install Remote Kit behind grille of vehicle, on top of Ski Rack, or just under the
bumper, or in the bumper (if a fiberglass bumper is available). The higher the better the performance. Drill
holes on the outer flanges of the aluminum enclosure, left and right sides, use J Hooks to hold package to
desired surface. A bracket is provided.
2. If your vehicle is an SUV or pickup truck or larger, you can install under the bumper. If the install location is
good (typically just under the height of the bumper and approximately 18” back), the V1 will detect radar to
the front with excellent sensitivity and to the rear with reasonable sensitivity. Do not install too low due to
potential road damage to the V1 Remote, when parking or going over parking lot bumps.
3. The cable protruding from the Remote Kit is the rear of the kit facing the engine compartment.
4. If installed behind the grille, rear radar detection will be significantly reduced. Ensure no metal is in front of
the V1 Remote, and ensure V1 Remote is kept away from radiator to prevent heat damage. If installed
inside a front, foam core bumper, ensure no metal is in front of the V1 Remote.
5. Run the 14 foot cable into the cockpit and hook up according to electrical layout highlighted below. If the
cabling is ran differently than shown above, there will be no display on the Remote Concealed Display.
6. Call TLP on any questions you have or to order remote electronic display, audio control and cabling. The
Valentine One inside is a die-cast Magnesium enclosure, surrounded by a very sturdy Aluminum outer
enclosure.
Rated #1, 360 Degree, High Performance, PRS1-V™ Prowler Remote™ System
3
PROWLER Remote, PRS1-V, PRS1-STi, PRS2-V, PRS2-STi, PRS3-V, PRS3-STi, PRS4-V, PRS4-STi, Got Performance are trademarks of Tiger Lily Products. All rights reserved. Copyright 1999-2008.
Got Performance™
Download from Www.Somanuals.com. All Manuals Search And Download.
Tiger Lily Products
TLP, Blinder, Bel, Escort, Valentine
PO Box 549
Tel
303-678-9101
303-678-9103
Cel: 720-635-3931
Cel: 720-298-0557
Niwot, CO, USA 80544
Fax
Email [email protected]
WWW.1-Radar-Laser-Jammers-Detectors.com
Best-in-Test
Radar, Laser & Photo
Countermeasures
How To Change V1 Remote and Valentine One Programming.
Call us at 303-678-9101 if you want help in changing your V1 modes of operation. Change Modes at your own risk!
I. How to enter the Programming Mode.
Starting with the Control Knob in the "off" position, Press and hold-in Knob and at the same time turn the Knob “on;”
continue holding in the Knob until all front-panel lights are on (takes about 5 seconds).
Release the Control Knob.
II. How to determine your software version.
Press and immediately release the Control Knob (shown at right) to display software version. The
software-version number is four digits that display one digit at a time in the Bogey Counter-example:
2.869.
Note your software number, then see the tables on the following pages on features programmable in your unit.
Press and immediately release the Control Knob to exit software-version display and go to Step 1 programming.
III. How to program your desired features.
The feature character is indicated in the "Bogey Counter" (1, 2, 3, 4, 5, 6, 7, 8, A, b, C, d, E, F, G, H, J, or u).
To select the next Feature Character in the sequence, press and immediately release the Control Knob.
The Feature State is indicated by direction arrows on the Radar Locator. The Feature State is changed by pressing and
holding the Control Knob until the arrow switches to the opposite direction (takes about 3 seconds). NOTE: If you need
to return to an earlier Character in the sequence above, we recommend you switch off the power momentarily, then
restart at step I above. The numerical program modes of interest are as follows:
US/Canadian/HK Frequency: #1 (X band ON =
OFF =
) Don’t change any other mode on US/Canada!
EUROPE / AU Frequency #1 (X band OFF =
)
EUROPE / AU Frequency #2 (K = 24.125GHz : ON =
)
EUROPE / AU Frequency #3 (Ka band ON =
)
EUROPE / AU Band #4 (Laser ON =
)
EUROPE / AU Frequency #4 #H (Ku ON
)
EUROPE / AU Frequency #J (POP3 ON =
)
EUROPE / AU Frequency #U (Euro Ka = 34.2GHz, Narrowband Ka ON =
)
Do not change any other mode!
Rated #1, 360 Degree, High Performance, PRS1-V™ Prowler Remote™ System
4
PROWLER Remote, PRS1-V, PRS1-STi, PRS2-V, PRS2-STi, PRS3-V, PRS3-STi, PRS4-V, PRS4-STi, Got Performance are trademarks of Tiger Lily Products. All rights reserved. Copyright 1999-2008.
Got Performance™
Download from Www.Somanuals.com. All Manuals Search And Download.
Tiger Lily Products
TLP, Blinder, Bel, Escort, Valentine
PO Box 549
Tel
303-678-9101
303-678-9103
Cel: 720-635-3931
Cel: 720-298-0557
Niwot, CO, USA 80544
Fax
Email [email protected]
WWW.1-Radar-Laser-Jammers-Detectors.com
Best-in-Test
Radar, Laser & Photo
Countermeasures
IV. How to exit the Programming Mode.
Switch power off, or unplug. The changes you programmed will be retained in memory.
V. How to tell if V1 has been changed from factory settings.
If the unit has been changed, P will appear briefly in the Bogey Counter soon after V1 is switched on
(after the lamps-on test, but before the Mode indicator appears.)
On V1s with serial numbers ending in 0600 or higher, a flashing red LED just to the right of the Bogey
Counter during the sequence above indicates that Ku coverage has been activated.
Rated #1, 360 Degree, High Performance, PRS1-V™ Prowler Remote™ System
5
PROWLER Remote, PRS1-V, PRS1-STi, PRS2-V, PRS2-STi, PRS3-V, PRS3-STi, PRS4-V, PRS4-STi, Got Performance are trademarks of Tiger Lily Products. All rights reserved. Copyright 1999-2008.
Got Performance™
Download from Www.Somanuals.com. All Manuals Search And Download.
Tiger Lily Products
TLP, Blinder, Bel, Escort, Valentine
PO Box 549
Tel
303-678-9101
303-678-9103
Cel: 720-635-3931
Cel: 720-298-0557
Niwot, CO, USA 80544
Fax
Email [email protected]
WWW.1-Radar-Laser-Jammers-Detectors.com
Best-in-Test
Radar, Laser & Photo
Countermeasures
Euro K band is at 24.125GHz. Wideband Ka is turned off when Euro Ka is turned on. Ku is used in UK,
Netherlands, Northern France, Taiwan, Belgium, but not in the USA as of Jan07.
The Euro Mode and Ku band are separate features and require separate activation. Euro Mode is a
narrowband Ka used in Europe and Australia on photo speed traps.
When Euro Mode has been activated, upon
power up you will see the sequence "E," "u,"
"r" appear in the Bogey Counter. When the
power-up sequence is complete, the Bogey
Counter will show either "U" or "u." Pressing
the Control Knob will toggle between them.
Select "U" to enable both K and narrowband
Ka (Photo) bands. Select "u" to enable only
narrow Ka band.
Euro Ka (Big U) mode detects:
Ka POPIII 33.8GHz
KA Narrowband 33.97GHz to 34.65GHz
after July 2006 (Rev 3.8.5.1 and later
KA Narrowband 34.2GHz to 34.45GHz
before July 2006
K 24.125GHz and K POPIII radar
X turned off
Euro Ka (little u) mode detects:
Ka POP 33.8GHz
KA Narrowband 33.97GHz to 34.65GHz
after July 2006 (Rev 3.8.5.1 and later
KA Narrowband 34.2GHz to 34.45GHz
before July 2006
All K turned off
All X turned off
Euro Ku: 13.45 GHz
Rated #1, 360 Degree, High Performance, PRS1-V™ Prowler Remote™ System
6
PROWLER Remote, PRS1-V, PRS1-STi, PRS2-V, PRS2-STi, PRS3-V, PRS3-STi, PRS4-V, PRS4-STi, Got Performance are trademarks of Tiger Lily Products. All rights reserved. Copyright 1999-2008.
Got Performance™
Download from Www.Somanuals.com. All Manuals Search And Download.
|