THIEL
Model ViewPoint ®
®
Coherent Source
flat-panel video display speaker
OWNER INFORMATION
Download from Www.Somanuals.com. All Manuals Search And Download.
2) A speaker with a low efficiency of 84 dB/W-m will require twice the power of an average 87 dB/W-m speaker and one
with a high rating of 90 dB/W-m will require only half the power of an average speaker. Usually, high efficiency can be
obtained only by trading off sonic quality—there are very few speakers that provide a very high level of both. The ViewPoint
is just above average efficiency (88 dB) and therefore requires an average amount of power for average volume levels.
3) A small room will need less power for a given loudness level than a large room. A very small room of 1000 cu ft (11' x
11' with an 8' ceiling) will require about half the power of an average size room. A large room of 6000 cu ft (20' x 30' with a
10' ceiling) will require twice the average power. If the listening room is connected to another room by a large open area, the
required power will increase, but not by the amount of the combined room volume. If the room has a “dropped” ceiling with
light panels, the ceiling will be almost transparent acoustically and the space above the ceiling should be added. If the panels
are heavy they will act as a more normal ceiling.
With all this in mind, a person who doesn’t like to play music very loudly and has a small room can get quality sound with
the ViewPoint with as little as 50 watts whereas a person who sometimes likes to play loudly and has a large room may need
200 watts or more.
GRILLE
The ViewPoint’s grille can be removed by slightly bending the grille in towards its center and then springing it out of the
vertical mounting grooves that run along both sides of the front of the cabinet.
SERVICE
If your speaker system requires service, contact your authorized THIEL dealer. If you need to contact THIEL, service
information and technical support is available at (859) 254-9427, Monday-Friday, 8:30 a.m. - 5:00 p.m. Eastern Time, or via
VIEWPOINT WALL INSTALLATION INSTRUCTIONS
2) Set the speaker aside and drill 1⁄8"
holes at the marks through the wall
surface material. If a stud is encountered,
continue drilling a pilot hole. If there is no
stud, expand the 1⁄8" hole to 3⁄8" and
install the provided anchor.
3) Connect the speaker input wires and
screw the speaker to the wall using
either the wood screw or anchor screw.
Make final alignment adjustments
before tightening the mounting screws.
Install the grille as described above.
1) Hold the speaker against the wall,
against the plasma side, and in the
desired location. Then mark the
mounting hole locations by inserting a
#1 philips screwdriver or a pencil
through the mounting holes.
Download from Www.Somanuals.com. All Manuals Search And Download.
THIEL VIEWPOINT SPECIFICATIONS
Amplitude Response
60 Hz-20 kHz ±3 dB
Minimum ±10°
Phase Response
Sensitivity
88 [email protected] V-1m
4 ohms (3 ohms minimum)
50-400 watts
Impedance
Recommended Power
Size
8 " W x 5" D x Custom H
18 pounds
Weight
LIMITED 10 YEAR WARRANTY
THIEL warrants every THIEL ViewPoint system against defects in materials and workmanship to the original owner for
a period of ten years from the date of purchase. THIEL will, at no charge, replace any defective part and make any repairs
necessary to ensure its proper performance when the defective unit is returned to us postpaid.
This warranty does not cover damage due to accident or abuse and is void if the unit has been tampered with.
This warranty is automatic and no registration is required. This warranty gives you specific legal rights. You may also
have other rights which are particular to your state.
The following information is for your records.
Serial Numbers______________________________
Purchase Date_______________________________
Purchased From_____________________________
REGISTER YOUR WARRANTY ONLINE AT
THIEL
1026 Nandino Boulevard
Lexington, Kentucky 40511-1207
8/04
Download from Www.Somanuals.com. All Manuals Search And Download.
|