5. When finished, press the end button or del/conf/intercom button on either
handset to deactivate the intercom.
Installing the Handset Battery
Important Information
Introduction
De-Registration
Battery Safety Precautions
Quick Set-Up Guide
NOTE: You must connect the handset battery before use.
NOTICE: This product meets the applicable Industry Canada technical specifications.
CAUTION: When using telephone equipment, there are basic
• Do not burn, disassemble, mutilate, or puncture. Like other batteries of this
type, toxic materials could be released which can cause injury.
De-registration cancels registration. During the de-registration
process, keep the handset near the base.
NOTE: The system is expandable up to 6 handsets (by purchase
of optional Model 28106 handset with recharge cradle). When
6 handsets are registered, the system can handle 2 separate
intercom operations at once, for example, 1st handset intercoms
with 2nd handset while 3rd handset intercoms with 4th handset.
Operation is subject to the following two conditions: (1) This device may not cause
interference, and (2) This device must accept any interference, including interference that
may cause undesired operation of the device.
The equipment must be installed using an acceptable method of connection. The
customer should be aware that compliance with the above conditions may not prevent
degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance
facility designated by the supplier. Any repairs or alterations made by the user to this
equipment, or equipment malfunctions, may give the telecommunications company
cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of
the power utility, telephone lines and internal metallic water pipe systems, if present, are
connected together. This precaution may be particularly important in rural areas.
safety instructions that should always be followed. Refer to
the IMPORTANT SAFETY INSTRUCTIONS provided with this
product and save them for future reference.
CAUTION: To reduce the risk of fire or personal injury, use
only the Thomson Inc. approved Lithium battery model 5-
2770 or 5-2762, which is compatible with this unit.
for Optional/Additional
Model 28106 Slim DECT 6.0
Cordless Handset
• To reduce the risk of fire or personal injury, use only the Lithium battery
listed in the User’s Guide.
• Keep batteries out of the reach of children.
• Remove batteries if storing over 30 days.
From the Handset Setup Menu:
1. Press the vol/CID ( 6 or 5) button to scroll to the DEREGISTRATION sub-menu.
2. Press the menu ok/mute button to enter the menu. DEREGISTRATION 1YES
42NO shows in the display The default setting is 2NO.
3. Use the touch-tone pad to select 1 for YES or 2 for NO. Or use the vol/CID
( 6 or 5) button to scroll to 1YES or 2NO.
WARNING: It is not recommended that a handset be de-registered
unless absolutely necessary because once a handset is de-
registered, that handset’s telephone features cannot be used until
the handset is re-registered.
IMPORTANT: Because cordless phones operate on electricity, you
should have at least one phone in your home that isn’t cordless,
in case the power in your home goes out.
1. Locate battery and battery door which are packaged together inside a plastic
bag and are separate from the handset.
2. Locate the battery compartment on the back of the handset.
3. Plug the battery pack cord into the jack inside the compartment.
NOTE: To ensure proper battery installation, the connector is
keyed and can be inserted only one way.
Receiving an Intercom Call
When you receive an intercom call, your handset beeps. To answer the call
press the del/conf/intercom button, talk or speaker button.
If you have purchased an extra handset apart from your original
purchased unit you may find a detailed description of its functions
in the User’s Guide provided with your original purchased unit.
NOTE: The RBRC seal on the battery used in your Thomson Inc. product
indicates that we are participating in a program to collect and recycle the
rechargeable battery (or batteries).
or call 1-800-8-BATTERY or contact a local recycling center.
Advanced Intercom Features
If you have purchased an extra handset that is not of the same
type as your original handset you may still use the original User’s
Guide to help explain the new handsets basic functions and
options.
Receiving an Incoming Call During an Intercom
Call
CAUTION: Users should not attempt to make such connections themselves, but should
contact the appropriate electric inspection authority, or electrician, as appropriate.
NOTES: This equipment may not be used on coin service provided by the telephone
company.
4. Select NO, if you do not want to de-register.
5. If you select YES, press the menu ok/mute button and MOVE NEAR TO BASE
displays for 2 seconds, then CONFIRM? 1YES 2NO appears in the display.
6. Press the touch-tone pad to select 1 for YES or 2 for NO, or use the vol/CID (
6 or 5) button to scroll to 1YES or 2NO.
7. If you select YES, press the menu ok/mute button to confirm. DE-REGISTER...
shows in the display. You will hear a confirmation tone. Then HANDSET X
DEREGISTERED shows in the display to confirm the handset is deregistered.
NOTE: When you complete the de-registration process, HANDSET
NEEDS REGISTRATION shows in the display. To use the handset,
you MUST re-register the handset using the Registration process.
If you receive a telephone call during an intercom call, the intercom call is
immediately terminated and both handsets ring. Either handset user may press
the talk or speaker button to answer the call.
Service
Thomson Digital Technologies Ltd., warrants to the purchaser or gift recipient
that if any manufacturing defect becomes apparent in this product within
1 year from the original date of purchase, it will be replaced free of charge,
including return transportation.
Using Intercom with External Telephone Calls
Interference Information
During a telephone call, you may use the intercom/paging function to page
another handset and have an off line, private (two-way) intercom conversation.
You may also have a three-way conversation between the external caller
and the handsets, or you may transfer the external telephone call to another
handset.
This equipment generates and uses radio frequency energy which may interfere
with residential radio and television reception if not properly installed and used in
accordance with instructions contained in this manual. Reasonable protection against
such interference is ensured, although there is no guarantee this will not occur in a
given installation. If interference is suspected and verified by switching this equipment
on and off, the user is encouraged to try to correct the interference by one or more of
the following measures: Reorient the radio/television receiver’s antenna, relocate the
equipment with respect to the receiver, plug the equipment and receiver into separate
circuit outlets. The user may also wish to consult a qualified radio/television technician
for additional suggestions. This equipment has been fully tested and complies with all
limits for Class B computing devices pursuant to part 15 FCC Rules and Regulations.
This warranty does not include damage to the product resulting from accidents,
misuse or leaking batteries.
Should your product not perform properly during the warranty period, either:
NOTE: Before you intercom/page another handset, you must
decide whether you want to create a two-way or a three-way
conversation.
1. Return it to the selling dealer with proof of purchase for replacement,
OR
2. Remove the batteries (where applicable), and pack product complete with
accessories in the original carton (or equivalent).
Global De-registration
4. Insert the battery pack.
5. Close the battery compartment by pushing the door up until it snaps into
place.
If one or more handsets becomes lost, you should de-register all handsets
to ensure proper system operation. Follow the steps below to de-register all
handsets at the same time.
Two-Way Calling
— Mail prepaid (with proof of purchase) and insured to:
1. During an external call, press the del/conf/intercom button, and use the
touch-tone pad to enter the handset number you want to call.
for use with Systems
28115 and 28118 Series
Thomson Digital Technologies Ltd.
6200 Edwards Boulevard
Mississauga, Ontario
Hearing Aid Compatibility (HAC)
Extra Charging Cradle
WARNING: It is not recommended that a handset be de-registered
unless absolutely necessary because once a handset is de-
registered, that handset’s telephone features cannot be used until
the handset is re-registered.
NOTE: The receiving handset presses the del/conf/intercom
button to answer the intercom call. Both intercom users may
speak privately. The external caller will not hear the intercom
conversation.
This telephone system meets FCC/Industry Canada standards for Hearing Aid
Compatibility.
1. Plug the AC power converter of the extra charging cradle into the electrical
outlet.
Canada L5T 2V7
Parts Checklist
NOTE: This power adaptor is intended to be correctly orientated
in a vertical or floor mount position.
The provisions of this written warranty are in addition to and not a modification
of or subtraction from the statutory warranties and other rights and remedies
contained in any applicable legislation, and to the extent that any such
provisions purport to disclaim, exclude or limit any such statutory warranties
and other rights and remedies, such provisions shall be deemed to be
amended to the extent necessary to comply therewith.
FCC RF Radiation Exposure Statement
Make sure your package includes the items shown here.
1. Disconnect power from the base by pulling the plug out of the back of the
unit.
2. Press and hold the page button and while holding the page button reconnect
the power.
3. Continue to hold the page button until the in use indicator flashes rapidly.
4. Release the page button.
5. Press and release the page button on the base once. All handsets are de-
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20 centimeters between the radiator and your body. This
transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.”
2. When finished, press the end button to end the intercom call, return to the
talk mode, and resume your original telephone conversation.
2. Place the handset in the extra charging cradle. The charge indicator turns on,
verifying the battery is charging.
3. Allow the phone to charge for 12 hours prior to first use.
Three-Way Calling
1. During an external call, press the del/conf/intercom button. LINE ON HOLD
Registration
If you are unable to find a qualified servicer for out of warranty service, you
may write to:
EXTENSION? shows in the display.
YOU MUST REGISTER THE HANDSET TO THE MAIN BASE BEFORE USE!
2. Use the touch-tone pad to select Handset #. You will hear a paging tone and
PAGING shows in the originating handset’s display.
NOTE: PAGING FROM... shows in the display on the receiving
handset, and the receiving handset presses the del/conf/
intercom or talk button to answer the intercom.
Thomson Digital Technologies Ltd.
c/o Thomson Inc.
P.O. Box 0944
After the optional handset has charged for 12 hours on the extra charger,
HANDSET NEEDS REGISTRATION shows in the display.
registered and HANDSET NEEDS REGISTRATION shows in the display.
Intercom Operation
1. Press the menu ok/mute button. HOLD BASE PAGE FOR 5 SECONDS, THEN
PRESS HANDSET MENU OK shows in the display. (Your handset should be
held near the base during registration process.)
2. Press and hold the page button on the base unit until the in use indicator
flashes. Press the handset the menu ok/mute button. REGISTERING shows in
the display. HANDSET X REGISTERED shows in the handset display, where X is
the handset number. You may now rename your handset.
Charge
Handset
Cradle
Indianapolis, Indiana, U.S.A., 46206-0944
battery
pack
The intercom feature allows you to have a conversation with another registered
handset without tying up the telephone line, allowing you to still receive
incoming calls.
Attach your sales receipt to this booklet for future reference. This information is
required if service is needed during the warranty period.
PURCHASE DATE ____________________________________________
NAME OF STORE ____________________________________________
3. When the receiving handset connects, press the del/conf/intercom button
on the originating handset to conference with the receiving handset and
the external caller. CONFERENCE shows in the display on the originating and
receiving handsets.
NOTE: A handset can enter conference mode directly by pressing
talk or speaker on the second handset during a call.
Making an Intercom Call
Battery
1. Make sure the handset is OFF (not in talk mode).
compartment
cover
Handset
2. Press the del/conf/intercom button on the handset.
3. Use the touch-tone pad to select the handset you want to page.
Naming the Handset
1. Use the touch-tone pad to enter a name (up to 15 characters).
NOTE: To cancel page, press the del/conf/intercom button again
or the end button on the sending handset.
4. Wait for the person at the receiving handset to press the del/conf/intercom
button.
NOTE: If the receiving handset does not answer within two
minutes, the intercom call is automatically canceled. The
originating handset displays NO ANSWER.
NOTE: If you make a mistake, use the del/conf/intercom button to
backspace and delete one character at a time.
CAUTION:
RISKOFELECTRICSHOCK
DONOTOPEN
THE EXCLAMATION
THE LIGHTNING
CAUTION: TO REDUCE THE
2. Press the menu ok/mute button to save your name. You will hear a
confirmation tone and the handset name shows in the display.
POINT WITHIN THE
TRIANGLE IS A
WARNING SIGN
ALERTING YOU OF
IMPORTANT
FLASH AND ARROW RISK OF ELECTRIC SHOCK, DO
WARNING:TO
HEAD WITHIN THE NOT REMOVE COVER (OR
PREVENT FIRE OR
ELECTRICAL SHOCK
HAZARD, DO NOT
EXPOSETHIS
TRIANGLE IS A
WARNING SIGN
ALERTING YOU OF
“DANGEROUS
VOLTAGE” INSIDE
THE PRODUCT.
BACK). NO USER
SERVICEABLE PARTS INSIDE.
REFER SERVICING TO
QUALIFIED SERVICE
PERSONNEL.
INSTRUCTIONS
ACCOMPANYING
THE PRODUCT.
Thomson Digital Technologies Ltd.
© 2007 Thomson Digital Technologies Ltd.
Trademark(s) ® Registered
Model 28106
00019387 (Rev. 0 CAN E/F)
07-15
PRODUCT TO RAIN
OR MOISTURE.
SEE MARKING ON BOTTOM / BACK OF PRODUCT
Marque(s) ® déposée(s)
Printed in China
Download from Www.Somanuals.com. All Manuals Search And Download.
|