Download from Www.Somanuals.com. All Manuals Search And Download.
THE DIGITAL TUNING CLOCK RADIO
MAINS CONNECTIONS
(FOR UNITED KINGDOM ONLY)
Se t t in g t im e
CAUTION:
WAKE/
Press SET
Press
until
and
show
Do NOT under any circumstances plug the
severed plug into any mains socket as this
could result in electric shock.
1
2
3
CLOCK
Connect the
230V ~50Hz
power cord into
a mains power
socket
to set minute
to set hour
+
Digital Tuning Radio
M3/M8 M4/M9
M5/M10
MEMO
M1/M6
ET
M2/M7
-
Press
ALARM/
CLOCK
Do NOT make any connection to the terminal
in the plug which is marked by the letter E r
by the earth symbol
and yellow.
1
4
HOUR ADJ MINUTE
[TUNING]
WAKE/
CLOCK
Press SET
to complete the setting
4
SNOOZE
or coloured green
3
2
-
+
or
• Press and hold
to skip fast
A fuse plug must be fitted with a 3A fuse
approved by ASTA or BSI to BS 1362 and fuse
covers must always be securely replaced. If
your RR-200PLL/RR-200PLM does not work,
the fuse may be blown.
A d ju st in g d isp la y b r igh t n e ss
You may slideHI DISPLAY LO at the back of the unit to vary the LCD
display brightness.
USEFUL ADVICE
.Do not use your set immediately after transport from a cold
place to a warm place: there may be condensation problems.
. This set uses a laser beam. To prevent any accident due to this
type of beam, the set should only be opened by properly-
trained personnel.
List e n in g t o r a d io
RADIO on•off
Press
Press
to turn on the radio
to select FM/LW
1
ALARM stop
4
1
BAND
2
VOLUME
. Make sure that you keep your set away from water and high
temperatures.
Digital Tuning Radio
M2/M7
M3/M8 M4/M9
M1/M6
SET
M5/M10
MEMO
W
AKE
1
W
AKE
2
min
max
(RR-200PLL) or FM/MW (RR-200PLM)
ALARM/
CLOCK
NAP
SLEEP
HOUR ADJ MINUTE
[TUNING]
BAND
RADIO on•off
ALARM off
INTRO-SCAN
SNOOZE
. If you do not use your set on battery power for more than one
month, we advise you to take out all the batteries.
. To prevent personal injury, do not reverse any battery and do
not mix battery types.
Press
station
or
to your desired
-
3
4
+
2
3
1
2VOLUME
Adjustmin
listening level
to your desired
max
ECOLOGY
• To improve reception, you may try and reposition the unit or
extend the FM aerial wire
. Help protect the environment - we recommend that you dispose
of used batteries by putting them into specially designed
receptacles.
-
• Press and hold
+
or
for 2 sec to tune automatically
• If stations are in memory (Sseetet in“g m em o r y” for refer-
2
3
ence), you may sip
and
above and press the memory
MAINTENANCE
buttons to access the corresponding memorised stations directly
. Clean the unit with a soft cloth, or a damp chamois leather.
Never use solvents.
RADIO on•off
• To turn off the radio, press
again
ALARM stop
Untitled-3
2
7/17/01, 5:21 PM
Download from Www.Somanuals.com. All Manuals Search And Download.
THE DIGITAL TUNING CLOCK RADIO
THE DIGITAL TUNING CLOCK RADIO
Se t t in g N A P
GB
Usin g IN TRO-SCA N
The NAP alarm allows you to take a nap for a period of 15
minutes up to 2 hours. After the set time period lapses, the
NAP alarm will sound to wake you up.
Intro-scan function allows you to listen to each tuned channel for a play
period of up to 10 seconds.
NAP
Digital Tuning Radio
M1/M6
M2/M7
M3/M8
M4/M9
M5/M10
W
AKE
1
W
AKE
2
Press and hold
(and
will
WAKE
1
WAKE
2
Follow1
rad io ” above
List e n ionfg t “o
2
nd
min
max
ALARM/
CLOCK
SET
MEMO
NAP
SLEEP
min
max
1
ALARM/
CLOCK
SET
MEMO
HOUR ADJ MINUTE
[TUNING]
NAP
SLEEP
1
BAND
1
HOUR ADJ MINUTE
[TUNING]
light) to set the desired time interval
after which the buzzer will sound
BAND
RADIO on•off
ALARM off
INTRO-SCAN
RADIO on•off
ALARM off
SNOOZE
INTRO-SCAN
SNOOZE
2
INTRO-SCAN
Press
to start scanning
2
• While in NAP mode, pressesNoAnP will show
the remaining time before the alarm sounds.
RADIO on•off
• During the play period, you may:
• To stop NAP buzzer from sounding, press
ALARM stop
-
-- Press
scanning direction
-- Press to set memory (see “Setting Memory” for
or
+
to keep scanning or change
• To turn off the NAP cycle, press aNnAdP hold
goes off
until
MEMO
details)
Sle e p t o r a d io
• During the scanning or play period,
INTRO-SCAN
-- Press
to exit the intro scan function
You can drift off to sleep to radio knowing that the unit will turn itself
off automatically. If alarm is set, the unit will turn on again as pro-
grammed.
Se t t in g m e m o r y
SLEEP
Press and hold
time from 2 hours to 15 minutes
and will light
to set the
1
2
You may preset up to 10 radio channels
Digital Tuni
M2/M7
M3/M
M1/M6
SET
WAKE
NAP
1
WAKE
2
ALARM/
CLOCK
SLEEP
HOUR ADJ
[TUNIN
1
Tune to your desired station
RADIO on•off
ALARM off
SNOO
2
Tune to your preferred station
MEMO
Press
blinking
andstarts
2
3
Digital Tuning Radio
M3/M8 M4/M9
M5/M10
MEMO
M1/M6
SET
M2/M7
ALARM/
CLOCK
M1/M6
M5/M10
R ADJ MINUTE
[TUNING]
3
S N O O Z E
• If you decide to turn off the unit sooner, press
and this will shut off the sleep cycle.
• When sleep mode is active, subsequent presses on
or
Press
......
RADIO on•off
ALARM stop
2
SNOOZE
to designate memory location
SLEEP
will show
1. Press the memory buttons once to select M1...M5, twice to
the remaining time before the unit goes off.
select M6...M10
2. To exit from memory setting, press
and the location number go off
• This unit allows you to “Sleep to one radio station and wake to
MEMO
until
another”(seeSe“t t in g a la r m w it h m u sic” for setting alarm(s))
• If desired radio station is not selected, the unit will sleep to the
last receiving station.
Untitled-3
3
7/17/01, 5:21 PM
Download from Www.Somanuals.com. All Manuals Search And Download.
|