Z
CD-RW880
Quick-Start Recording Guide
This Guide provides you with the simplest way to use this equipment for recording.
Of course, we strongly suggest that you consult the Owner’s Manual for complete details and important safety information.
Connections
This is the simplest connection to enjoy CD recording.
1
Connect the CD-RW880 to your Amplifier, for listening to CD-Rs and
CD-RWs, and for checking recording.
Make sure to connect:
white plug q white jack (L: left channel)
red plug q red jack (R: right channel)
2
3
Connect the CD-RW880 to your CD Player or MD Deck using an
optical digital cable.
When using the DIGITAL IN terminal, remove the cap from the terminal.
R
L
R
L
DIGITAL OUT
REC PLAY
AC Outlet
Finally, connect the power cord.
CD Player, MD Deck, etc.
Amplifier
Recording
When the POWER button is pressed, the unit returns to the factory settings.
About CD-R/CD-RW discs
You must use CD-R and CD-RW discs bearing the
“DIGITAL AUDIO” logo. This unit CANNOT RECORD CD-
R and CD-RW discs designed for computer systems.
1
As this guide is based on the factory settings, be sure to start from step
.
Manual track division
5
4
Play the source to be recorded.
Press the RECORD button.
It is possible to divide the recording into tracks while
recording.
The unit will start synchronous recording.
The unit enters record pause mode.
While the recording is taking place, press the TRACK
INCREMENT button. The current track number will be
incremented by one.
< During digital synchronous recording, if
the input signal stops for 5 seconds,
recording will stop automatically.
< Press the STOP button to stop the
recording manually.
Finalizing
Although audio data may be written on a CD-R or CD-
RW disc, a standard CD player will not be able to play
back the audio until a final table of contents (TOC) has
been written at the start of the disc.
The process of writing this table of contents is known as
“finalizing”. Once this has been done, no further data
can be written to the disk.
1
Press the FINALIZE button in the stop mode.
“FINALIZE” appears on the display.
2
Press the PLAY (y) button to start finalizing.
1
2
3
Press the POWER switch.
Load a recordable CD-R or CD-
RW disc into the unit.
Select “SYNC ALL” using
the SYNC 1/ALL button.
The unit enters standby
mode, and “STAND-BY”
lights on the display.
Press the OPEN/CLOSE button (L),
place a disc on the disc tray with the
printed label side up, and then press
the OPEN/CLOSE button (L) to close
the disc tray.
“TOC” and the “REC” indicator blink, and the
remaining time for the finalizing operation appears
in the display.
When the operation has been finished, the display
returns to the track/time display.
< Pressing the OPEN/CLOSE button in
the standby mode turns the unit on.
< Although finalized CD-R discs may be played on
most ordinary CD players, remember that some
finalized CD-RW discs may not play on older CD
players.
.
TEAC CORPORATION 0705 MA-0992A
9A10350200
Download from Www.Somanuals.com. All Manuals Search And Download.
|