SRCD5670 English (371 x 210mm) 17 July 2010 /L
Before using the unit, be sure to read all operating instructions
carefully. Please note that these are general precautions and may
not pertain to your unit. For example, this unit may not have the
capability to be connected to an outdoor antenna.
1. Read these instructions.
All the safety and operating instructions should be read before
the product is operated.
2. Keep these instructions.
The safety and operating instructions should be retained for
future reference.
3. Heed all warnings.
All warnings on the product and in the operating instructions
should be adhered to.
4. Follow all instructions.
14. Refer all servicing to qualified service personnel. Servicing
is required when the apparatus has been damaged in any
way, such as power-supply cord or plug is damaged, liquid
has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture does not
operate normally, or has been dropped.
24. Damage requiring service.
Unplug this product from the wall outlet and refer service to
qualified service personnel under the following conditions.
a) When the power-supply cord or plug is damaged.
b) If liquid has been spilled or objects have fallen into the
product.
c) If the product has been exposed to rain or water.
d) If the product does not operate normally by following the
operating instructions.
Adjust only those controls that are covered by the
operating instructions, as an adjustment of other controls
may result in damage and will and require extensive work
by a qualified technician to restore in the product to its
normal operation.
SAFETY INSTRUCTION
CAUTION
15. Power source.
RIKS OF ELECTRIC
SHOCK
This product should be operated only from the type of power
source indicated on the marking label. If you are not sure of the
type of power supply to your home, consult your appliance
dealer or local power company. For products intended to operate
from battery power, or other source, refer to the operation
instructions.
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
16. Power lines.
All operating and use instructions should be followed.
5. Do not use this apparatus near water.
An outside antenna system should not be located in the vicinity
of overhead power lines or other electric light or power circuits,
or where it can fall into such power lines or circuits. When
installing an outside antenna system, extreme care should be
taken to keep from touching such power lines or circuits as
contact with them might be fatal.
e) If the product has been dropped or the cabinet has been
damaged.
f) When the product exhibits a distinct change in
performance-this indicates a need for service.
25. Note to CATV system installer.
DANGEROUS VOLTAGE:
The lightning flash with arrowhead symbol, within
an equilateral triangle is intended to alert the user
to the presence of uninsulated dangerous voltage
within the product’s enclosure that may be of
sufficient magnitude to constitute a risk of electric
shock to persons.
Do not use this product near water and moisture, for example:
near a bathtub, washbowl, kitchen sink or laundry tub; in a wet
basement; or near a swimming pool.
6. Clean only with dry cloth.
Micro System CD Player
with Clock Radio
Unplug this product from the wall outlet before cleaning. Do
not use liquid cleaners or aerosol cleaners. Use a dry cloth for
cleaning.
17. Overloading.
This reminder is provided to call the CATV system
installer's attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the
grounding system of the building, as close to the point of
cable entry as practical.
Do not overload wall outlets and extension cords as this can
result in a risk of fire or electric shock.
18. Object and liquid entry.
ATTENTION:
The exclamation point within an equilateral triangle
is intended to alert the user to the presence of
important operating and maintenance (servicing)
instructions in the literature accompanying the
appliance.
7. Do not block any ventilation openings. Install in accordance
with the manufacturer's instructions.
Never push objects of any kind into this product through
openings as they may touch dangerous voltage points or short
out parts that could result in fire or electric shock. Never spill
or spray any type of liquid on the product.
MODEL: SRCD5670
Slots and openings in the cabinet and in the back or bottom are
provided for ventilation, to ensure reliable operation of the
product and to protect it from overheating. These openings must
not be blocked or covered. The openings should never be
blocked by placing the product on a bed, sofa, rug or other
similar surface. This product should never be placed near or over
a radiator or heat source. This product should not be placed in a
built-in installation such as a bookcase or rack unless proper
ventilation is provided or the manufacturer's instructions have
been adhered to.
DANGER:
NOTE: Refer all servicing to qualified service personnel.
Servicing is required when the unit has been damaged in any way
such as the following: the power-supply cored or plug has been
damaged, liquid has been spilled into the unit, the unit has been
exposed to rain or moisture, the unit has been dropped or the unit
does not operate normally.
19. Outdoor antenna grounding.
Invisible and hazardous laser radiation when open
and interlock failed or defeated. Avoid direct
exposure to beam.
If an outside antenna is connected to the product, be sure the
antenna system is grounded so as to provide some protection
against voltage surges and built up static charges. Section 810
of the National Electric Code ANSI/NFPA 70 provides
information with respect to proper to grounding of the mast and
supporting structure, grounding of the lead-in wire to an antenna
discharge product, size of grounding conductors, location of
antenna-discharge product, connection to grounding electrodes
and requirements for the grounding electrodes.
20. Service.
LASER SAFETY: This unit employs a laser. Only qualified service
personnel should attempt to service this device due to possible eye
injury.
CAUTION: USE OF CONTROLS, ADJUSTMENTS OR
PERFORMANCE PROCEDURE HEREIN MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE.
8. Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers)
that produce heat.
9. Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades with
one wider than the other. A grounding type plug has two
blades and a third grounding prong. The wide blade or the
third prong are provided for your safety. If the provided plug
does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched
particularly at plugs,
convenience receptacles, and the point where they exit from
the apparatus.
11. Only use attachments/accessories specified by the
manufacturer.
SURGE PROTECTORS:
Do not attempt to service
It is recommended to use a surge protector for AC connection.
Lightning and power surges ARE NOT covered under warranty
for this product.
ANTENNA LEAD IN WIRE
this product yourself as
GROUND CLAMP
opening or removing
ANTENNA DISCHARGE
UNIT
(NEC SECTION 810-20)
covers may expose you
ELECTRIC SERVICE
FCC WARNING:
EQUIPMENT
to dangerous voltage or
GROUNDING CONDUCTOR
This equipment may generate or use radio frequency energy. Changes
or modifications to this equipment may cause harmful interference
unless the modifications are expressly approved in the instruction
manual. The user could lose the authority to operate this equipment
if an unauthorized change or modification is made.
(NEC SECTION 810-21)
other hazards. Refer all
servicing to qualified
GROUND CLAMPS
POWER SERVICE GROUNDING
service personnel.
ELECTRODE SYSTEM
(NEC ART 250, PART H)
21. Replacement parts.
When replacement parts aEreXAreMqPuNLiAErTeOIdOF,NAbANeLTEsENuLNEreCATtGRhRIeCOAsUeLNrCDvOIiNcDGeEAS PER
technician uses replacement parts specified by the manufacturer
or those that have the same characteristics as the original parts.
Unauthorized substitutions may result in fire or electric shock
or other hazards.
INFORMATION:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
PORTABLE CART WARNING
(symbol provided by RETAC)
12. Use only with the cart, stand, tripod,
bracket, or table specified by the
manufacturer, or sold with the apparatus.
When a cart is used, use caution when
moving the cart/ apparatus combination
22. Safety check.
Upon completion of any service or repairs to this product, ask
the service technician to perform safety checks to determine
that the product is in proper operation condition.
23. Wall or ceiling mounting.
INSTRUCTION MANUAL
Operating Instructions
to avoid injury from tip-over
An appliance and cart combination should be
moved with care. Quick stops, excessive force and uneven
surfaces may cause the appliance and cart combination to
overturn.
The product should be mounted to a wall or ceiling only as
recommended by the manufacturer.
• Reorient or relocate the receiving antenna.
13. Unplug this apparatus during lightning storms or when
unused for long periods of time. To protect your product from
a lightning storm, or when it is left unattended and unused for
long periods of time, unplug it from the wall outlet and
disconnect the antenna or cable system. This will prevent
damage to the product due to lightning and power-line surges.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
READ THIS INSTRUCTION MANUAL BEFORE
CONNECTING OR OPERATING THIS
APPLIANCE. SAVE THIS INSTRUCTION
MANUAL FOR FUTURE REFERENCE.
Download from Www.Somanuals.com. All Manuals Search And Download.
|