swisherinc.com
Owners
Manual
MODEL NO.
11730
TRUCK SPREADER
IMPORTANT
Read and follow all
Safety Precautions
and Instructions
before operating this
equipment.
Assembly
Replacement Parts
REV 08-086
1602 CORPORATE DRIVE, P.O. BOX 67, WARRENSBURG, MISSOURI 64093
PHONE 660-747-8183 FAX 660-747-8650
Made In The
Manufacturing quality lawn care equipment since 1945
USA
12000
Download from Www.Somanuals.com. All Manuals Search And Download.
Item #
Part #
10113
Description
Deflector - Spreader
Bolt - 5/16-18 X 1 1/2 HCC GR5 ZY
Washer - USS Flat, 5/16 ZY
Washer - Fender, 5/16 X 1 1/4 OD ZY
Bushing - Lift Bar
1
2
3
4
5
6
7
8
9
NB505
NB556
NB579
7825Z
10051
NB555
10112TK
10111TK
NB181
10192
Spring - Gate, 12V ATV Spreader
Washer - USS Flat, 1/2 ZY
Gate - Hopper
Bracket - Motor Support, Upper
Nut - Nyloc 5/16-18 ZY
10
18
20
Washer - Nylon Retainer 5/16"
Tank - Truck Spreader
10975
Step 1:
Assemble the components as shown.
Use the Nylon Retainer Washer (18)
to hold the parts together.
Step 2:
Attach the assembly
made in Step 1 to the
tank (20) by sliding the
bolts (2) up through the
tank and placing a
fender washer (4) over
each bolt. Thread a nut
(10) over each bolt and
tighten securely.
NOTE: To change the amount of material being spread,
adjust the hopper gate by pulling on the handle
until the desired flow is attained. A scale of one
to four has been provided with one being the
least amount, and four being the most. Zero
will seal the material from being distributed.
Download from Www.Somanuals.com. All Manuals Search And Download.
Item #
9
11
12
13
Part #
10111TK
10114TK
10197
10117TK
3844
Description
Bracket - Motor Support, Upper
Bracket - Motor Support, Lower
Bolt - Carriage 5/16-18 X 1 GR5
Shield - Spreader
14
Knob - T, 5/16-18
15
16
15118
10118
Motor - Spreader 12 VDC CW 2.5"
Spinner - Distributor, Spreader
Step 3:
Remove the nuts and snap ring from
the motor and place the Lower Motor
Support Bracket (11) over the Motor (15).
Thread the nuts onto the motor studs and
tighten. Slide the Spinner/Distributor (16)
over the motor shaft and replace roll pin.
Step 4:
Insert the 5/16” Carriage Bolts (12)
into the Lower Motor Bracket (11),
through the Upper Motor Bracket (9),
and through the Spreader Shield (13).
Place the T-Knobs (14) on the bolts (12)
and tighten. (The guide of the
Lower Bracket will slide up
through the slot in the Upper
Bracket).
NOTE: To change the radius of
material being spread, simply
loosen the T-Knobs and slide
the mechanism up (smaller
radii) or down (larger radii).
Download from Www.Somanuals.com. All Manuals Search And Download.
Item #
3
Part #
NB556
Description
Washer - USS Flat, 5/16 ZY
10
NB181
Nut - Nyloc 5/16-18 ZY
21
22
24
25
10976TK
10979TK
NB501
Support - Weldment, LH; Truck Spreader
Support - Weldment RH; Truck Spreader
Bolt - 5/16-18 X 1 HCC GR5 ZY
Washer - Fender, 5/16 X 1 1/4 OD ZY GR2
NB579
Step 5:
Attach the Support Tube Weldments
(21 & 22) to the tank by inserting the
bolts (24) through the Washers (25) and
the Weldments (21 & 22), and into the
holes on the side of the tank as shown.
Place a washer (3) over each bolt (24) on
the inside of the tank and thread the nuts
(10) onto the bolts (24) and tighten securely.
Download from Www.Somanuals.com. All Manuals Search And Download.
Item #
10
23
25
26
Part #
NB181
10981TK
NB579
9855
Description
Nut - Nyloc 5/16-18 ZY
Mount - Weldment; Truck Spreader
Washer - Fender, 5/16 X 1 1/4 OD ZY GR2
Bolt - U, Sq 3/8-16 x 1 5/8" x 2 1/2"
Support - Weldment; Truck Spreader
Lid - Tank
27
11728TK
10176
10531
Adapter - Kit, 12 Volt
Step 6:
Attach the Mounting Weldment (23) to the Spreader Assembly by
putting the U-Bolts (26) over the Mounting Tubes (21 & 22) and into
the holes on the Mounting Weldment (23). Mount the Support
Weldment (27) onto the rear of the Mount Weldment (23) and place
the Washers (27) onto the Bolts (26) as shown and thread the Nuts (10)
in place. Making sure that the support tubes are resting on the lip
provided, tighten the nuts, securing the Mounting Weldment (23) and
Support Weldment (27) to the Spreader Assembly.
Download from Www.Somanuals.com. All Manuals Search And Download.
Download from Www.Somanuals.com. All Manuals Search And Download.
MANUFACTURING QUALITY LAWN CARE EQUIPMENT SINCE 1945
Owner’s
Manual
Model Numbers
Truck
Spreader
11730
WHEN ORDERING PARTS, PLEASE HAVE THE
FOLLOWING INFORMATION AVAILABLE:
* PRODUCT – ________________
* SERIAL NUMBER - _______________
* MODEL NUMBER - _______________
TYPE - _______________
* PART NUMBER WITH PAINT CODE
* PART DESCRIPTION
TELEPHONE - 1-800-222-8183
FAX - 1-660-747-8650
SWISHER MOWER & MACHINE CO. INC.
1602 CORPORATE DRIVE
P.O. BOX 67
IMPORTANT
Read and follow all
Safety Precautions
and Instructions
Before Operating this
Equipment.
WARRENSBURG, MO 64093
swisherinc.com
Download from Www.Somanuals.com. All Manuals Search And Download.
|