HEARTH PRODUCTS
KITS AND ACCESSORIES
750,195M
Rev. NC, 03/2006
CHARCOAL CANOPY HOOD KITS
INSTALLATION INSTRUCTIONS FOR CANOPY HOOD KITS
FOR USE WITH UVF-36, UVFRC-3628, UVFRC-3628-H
UVFRC-4228 & UVFRC-4228-H UNIVERSAL VENTFREE FIREBOXES
GENERAL INFORMATION
KIT CONTENTS:
1 ea. Charcoal Canopy Hood
3 ea. Screws
These canopy hood kits are design to be fitted to the face of the appliance
directlyabovethefireboxopening. Inadditiontoprovidinganaesthetically
pleasing appearance to your appliance installation, the canopy reduces
heat effects to decorative mantels and finish materials located directly
above the fireplace and reduces the Mantel / Trim clearances (see Figure
4 in the Installation and Operation Manual).
1 ea. Instruction Sheet
Charcoal Canopy Hood Kits
CAT. NO.
H1989
MODEL NO.
WHERE USED
NOTE: A canopy hood is a standard part for model UVF-36. This
UVF-36, UVFRC-3628,
UVFRC-3628-H (UVF-36 standard part)
model requires a canopy hood on all installations.
FC36
FC42
The manufacturer recommends that the installation and Operation Manual
provided with the appliance be read completely and understood thoroughly
before proceeding with the installation of these kits. ALL WARNINGS AND
PRECAUTIONS IN THAT DOCUMENT APPLY TO THESE INSTRUCTIONS.
H1990
UVFRC-4228 & UVFRC-4228-H
Table 1
TOOLS NEEDED:
INSTALLATION INSTRUCTIONS
5/16" Nut Driver or Socket
The factory-supplied canopy must be installed on the firebox for safe
operation for model UVF-36 (this part is optional for other models).
Step 1. Remove screen and rod assemblies as shown in Figure 1.
Step 2. Align the canopy with the holes in the side frames.
Step 3. Install three screws as shown in Figure 2.
INSTALL ONLY WHEN APPLIANCE IS OFF AND COLD!
Step 4. Make sure canopy is level and secure.
Step 5. Reinstall screen and rod assemblies (see Figure 1)
Removing Screens & Rods:
Remove screws (see dotted
lines). Pull out rods from
locatingholesonsideoffirebox
opening.
Reinstalling Screens & Rods:
Insert rods into corresponding
locatingholesonsidesoffirebox
opening, then reinstall screws
as shown.
Canopy
Figure 2
Figure 1
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
LHP reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and the discontinuance of colors, styles and products. Consult your local
distributor for fireplace code information.
LHP
Printed in U.S.A. © 2006 by LHP
1110 West Taft Avenue
Orange, CA 92865
P/N 750,195M REV. NC 03/2006
Page 1 of 1
Download from Www.Somanuals.com. All Manuals Search And Download.
|