Distributed by:
Airpure International
Toll Free: 1-800-858-2932
Instruction Manual
Portable Air Conditioner / Heater
For modelWA-7500M
Your Guarantee
P O R T A B L E
Air Conditioner
If this product is found to be faulty as a result of faulty materials
or workmanship within one year from date of purchase, it will
be repaired or replaced free of charge.
This guarantee is subject to the following terms:
SUNPENTOWN, must be notified of the fault.
Proof of purchase must be presented to SUNPENTOWN’s nominated representative.
The warranty will be void if the product is modified,
misused or repaired by an unauthorized person.
The guarantee after repair or replacement will not be
extended beyond the original one year period.
All replacement parts or units will be new or reconditioned.
Parts or units, which are replaced, become the
property of SUNPENTOWN.
The warranty applies to the use of this product in the United States.
Warranty does not include freight charges.
This GUARANTEE is in addition to your Statutory Rights.
It is important that you read
these instructions before using
your new purchase and we
strongly recommend that you
keep them in a safe place for
future reference.
Dear Customer: Please keep this warranty for your record. DO NOT return it.
14
Download from Www.Somanuals.com. All Manuals Search And Download.
Drainage
Specifications
During the process of cooling, some water will be extracted
from the air into the unit. Most of this water is used to cool
the unit and make it run more efficiently. This is a feature not
found in most Portable Air Conditioners. If the unit is operated
inVERY HUMID air, water will collect in the container inside the
unit. If the water container is full, the compressor will stop, but
the fan will continue to circulate the air. The POWER indicator
will blink to inform you to empty the internal container.To make
the cooling function work again, please empty the water by one
of the following methods:
Water Hole
Model Number
Cooling Capacity
Power Consumption
Humidity Removal Capacity
Recommended Room Size*
Power Supply
WA-7500M
7,500 BTU/hr
620W/6A
46 Pts./day
Rubber Plug
Drain Knob
200 sq. ft.
By the Draining into a Container
Use a Shallow Container or Dish
1. Turn off the unit.
120V / 60Hz / 1 Phase
Rotary
Compressor
2. Position a flat container or dish under the drain hole.
Do not allow the water to drip continuously into the container,
as it might easily overflow.
Rubber Plug
Drain Knob
Refrigerant
R-22
3. Remove the drain knob & rubber plug from the drain hole.
The condensed water will drain out automatically.
Fan Speed
2
Timer
WA-7500M: 1- 8 hours
64°F - 90°F
66 lbs.
4. When the container is almost full, replace the rubber plug
into the drain hole to stop the water. Empty the container.
Drain Pipe
Thermostat
5. Repeat steps 2,3 & 4 until all the condensed water is emptied.
6. Once all the condensed water has been removed,
replace the rubber plug into the drain hole firmly.
The FullWater indicator should be off now.
NetWeight
Dimensions
16"W x 16"D x 30"H
Cooling 64°F to 110°F
7. Replace the drain knob.
WorkingTemperature
Original
WaterTube
ByWater Tube (Continuous Drainage)
1. Remove the drain knob and rubber plug and keep them
for future use.
REMARKS:
Extended
WaterTube
(OD:3/4")
1. The data may vary, please refer to the rating label on the back of the unit.
2. Connect a suitable water tube
(of 3/4" internal diameter - supplied) to the water hole.
The condensed water will drain out automatically.
2. The above conditions are measured at:
Cooling - Indoor: RT 81°F, RH 60%
3. If you want to extend the water tube you can connect
it with another tube (outside diameter 3/4").
* Uninsulated rooms such as sunrooms, garages, or attics should be less than 200 sq. ft.
10
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Parts
Operation - Mechanical Models
WA-7500M
1. Power indicator
2. Fan operating indicator
3. Cooling operating indicator
4. Full water indicator
5. Thermostat
6. Speed switch with options for - LOW FAN,
HIGH FAN, LOW COOL, HIGH COOL
7. Timer (1-8 hours) as well as ON/OFF switch
1. Control Panel
2. Cooling Air Outlet
3. Handle
5. Air Filter
6. Air Inlet
7. Exhaust Air Outlet
8. Cord Hanger
4. Castors
Turning ON/OFF
9. Water Stopper (Rubber Plug inside)
SetTIMER to ON for continuous operation
(the unit will operate as long as it is not turned off).
Power indicator comes on.
Accessories
10. Adaptor - for insertion over the
hose and into the back of the
air conditioner
13
To turn off the unit, turn theTIMER to the OFF position
10
12
11. Exhaust Hose
SPEED
12. Foam Strip - for filling the open
window space and with a hole for
connection to the exhaust hose
11
14
15
Setting Function /Ventilation Speed
High Cool
Low Fan
WA-7500M
13. Foam Strip - for filling the open
window space
Turn the speed switch to select the required setting:
LOW FAN, HIGH FAN, LOW COOL, HIGH COOL
SPEED OFF
14. Round Connector - to be used
between hose and window kit or
between hose and wall
Low Cool
High Fan
15. Cap - for round connector
5
8
Download from Www.Somanuals.com. All Manuals Search And Download.
Installation
Installation
Mounting the unit
Mounting the exhaust pipe
This unit is a portable air conditioner. It can be moved from room to room so that the cooling
can follow you anywhere. Fitting the exhaust hose is easy, through a window or wall.
Please refer to either of the following ways:
• The supplied exhaust hose can be
extended from 1 foot to 5 feet
for mounting. It is recommended that
you use the shortest possible length of hose.
1. Using the foam strips
• Take care to prevent any kink or
bend in the middle of the exhaust
hose, as this will trap hot exhaust air,
which will radiate back into the room.
• Connect the supplied foam strips with the exhaust pipe, let the hot air flow to the outside.
WARNING!
The length of the exhaust pipe is specially designed
according to the specification of this product.
• Should the foam strip(s) be too large, cut off the extra part to fit the window.
Do not replace or extend it with your own hose
as this could cause the unit to malfunction.
2. Using the through theWall Connection
Installation of the Carbon Filter
1. Remove the filter frame from the unit.
2. Separate the filter from the filter frame.
3. Remove the active carbon filter
from its plastic bag.
4. Insert the active carbon filter
into the filter frame.
5. Fix the filter by reassembling
the fixer onto the filter frame.
• Make a hole (43/8" in diameter) in the wall to fit the supplied round connector.
• Fit the hose directly to the round connector.
6. Re-fit the filter frame
inside the unit.
7. It is recommended to replace the
carbon filter every 3 to 6 months.
• When the hole is not in use, use the cap for the round connector to cover the hole.
6
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Operation - Mechanical Models
Before Use
Setting theTemperature
Turn theTHERMOSTAT to regulate the temperature you desire: range 64°F to 90°F.
Important!
• Transport the unit in an upright position only, or leave it in
an upright position for at least 2 hours before first use.
• Always place the unit on an even surface (Figure 1).
Setting theTimer
Turn theTIMER to the desired operating time (1 to 8 hours).
When the set time has elapsed, the machine will shut off automatically.
• Make sure the unit is connected to a correctly grounded power supply
(refer to the rating label located at the back of the unit).
• An opening in a window or wall is required to accommodate
the exhaust hose (kit supplied) to expel the warm air.
Regulating the Airflow Direction
Turn the roller on the air vent to control
the airflow direction from the vertical louvres.
• Do not cover or obstruct the appliance inlet or
outlet grilles (Figure 2).
Fig. 1
• To avoid the risk of shock, the product should never be used
in bathrooms, shower rooms or in any other steamy or wet areas.
• The unit will cool when the room temperature is between
64°F and 110°F depending on the thermostat setting.
• Do not sit or place objects on the unit.
• Do not touch the unit with wet/damp hands or
when standing barefoot.
NOTICE!
• Avoid all contact with chemical based materials.
• The compressor will start approximately 3 minutes after the unit is turned on
(this will help prolong the life of the compressor). After switching the unit off,
please wait at least 3 minutes before turning the unit back on.
• The filter must be used with the product at all times. When removing
for cleaning, always disconnect the unit from the mains first.
• The cooling system will switch off if the room temperature is lower than set.The fan, however,
keeps working at the set level. If the ambient temperature rises above the chosen level +5°,
the cooling will resume.
• Turn off the appliance when not in use.
• At the end of each season all water must be drained and the unit
and filters cleaned before storage.
• Drainage of the water container is required before moving
the unit or putting it into storage.
• If the electric socket is different from the plug provided, have a
professionally qualified electrician replace the plug with a suitable one.
Avoid the use of adaptor plugs, multiple sockets and/or extension leads;
if their use is necessary, ensure that they conform to the
current safety regulations.
Fig. 2
• Do not pull the supply cable or place it near a source of heat;
always unroll it completely to avoid the possibility of dangerous overheating.
• If the supply cord is damaged, it must be replaced by the
service agent or a similarly qualified person.
THE MANUFACTURER DISCLAIMS ANY RESPONSIBILITY IFTHE
ABOVE INSTRUCTIONS ARE NOT FOLLOWED.
4
9
Download from Www.Somanuals.com. All Manuals Search And Download.
Thank You!
Maintenance
Always unplug the unit from the mains before beginning the cleaning.
Cleaning the Housing
Use a soft, damp cloth to wipe the body clean.
Thank you for choosing the portable air conditioner from SUNPENTOWN, a leading
brand in indoor air treatment. We would like you to enjoy the many benefits this unit
offers, so please take the time to read this manual carefully and take full advantage of the
many advanced features that your SUNPENTOWN Air Conditioner offers you.
Never use strong chemicals, oil-based products, detergents, chemically treated cloths or
other cleaning solutions.These could possibly damage the cabinet.
SUNPENTOWN has specialized in complete indoor environment control, manufacturing
world-class air conditioners, dehumidifiers and air purifiers with innovative technology.
Cleaning the Filter
Use a vacuum cleaner or tap the filter lightly to remove loose dust and dirt from the filters
and then rinse them thoroughly under running water (no hotter than 104°F). Dry thoroughly
before replacing.
In designing these advanced products, we have listened carefully to our customers and
have passed their views on to our research and development laboratories.
We wish you many years of enjoyable use.
Do not wet the activated carbon filter, remove from frame before rinsing.
After reading this manual, please keep it in a safe place for future reference.
Notice! Never operate the unit without the filters.
End of Season Storage
Unplug the unit.
Energy SavingTips
• Please use the unit in the recommended room size. (Refer to SPECIFICATIONS).
Drain the condensed water COMPLETELY (please refer to page 10).
Clean or change the filter.
• Do not locate the air conditioner where furniture or other objects can obstruct
the airflow.
On a warm day, turn the unit to fan mode for a couple of hours so that the inside can dry out completely.
It is recommended that the unit be put back into its original carton for storage.
Do not stack heavy objects on top of the unit.
• Keep blinds/curtains closed during the sunniest part of the day.
• Close the fireplace damper and floor or wall grills so that cool air does not escape
through the chimney or ductwork.
• Keep the filters clean.
StoringThe Power Cord
When the unit is not in use, please store the power cord away as shown in Figure 3.
Set the unit to maximum cooling and high speed fan initially, then adjust the unit to a
comfortable setting.
NOTE: It is recommended to turn on the air conditioner when the room temperature
is around 75°F. Do not wait until the room is excessively hot.
Fig. 3
2
11
Download from Www.Somanuals.com. All Manuals Search And Download.
Defective Notice
If this product is defective or not working properly
Please DO NOT return to your retail store
Please contact us directly with any Service orTechnical Assistance
Contact us toll free at:
1-800-330-0388
13
Download from Www.Somanuals.com. All Manuals Search And Download.
|