9
10
11
12
13
14
1
Pedometer Back Side
The preset goals are:
CAUTION - Safety Battery Information
• Non-rechargeable batteries are not to be recharged
• Rechargeable batteries must be removed
before recharging
• Rechargeable batteries only to be recharged under
adult supervision
• Do not mix alkaline, standard (carbon-zinc), or rechargeable
(nickel-cadmium) batteries
• Do not mix old and new batteries
other than an authorized EB Sport Group personnel, or damage that is
attributable to acts of God.
Please note: Before using your
pedometer, remove battery
insulation strip. (Insulation strip
designed to preserve battery power)
1. Press tab to slide out.
FUNCTION
Number of Steps
Distance
Calories
Total Time
To turn this feature off, simply hold the AUTO button again. It
will say, "Auto Report is off."
VOICE ANNOUNCEMENT
Every 1000 steps
Every 0.5 miles or 0.5 km’s
Every 50 calories
Limits & Exclusions
LIMITED WARRANTY
There are no express warranties except as listed above.
EB SPORT GROUP SHALL NOT BE LIABLE FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS
PRODUCT, OR ARISING OUT OF ANY BREACH OF THIS WARRANTY. ALL
EXPRESS AND IMPLIED WARRANTIES, INCLUDING THE WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE
LIMITED TO THE APPLICABLE WARRANTY PERIOD SET FORTH ABOVE.
For products purchased in the United States:
2. Insert thin sharp tool, such as a small
screwdriver or thumb finger nail, at
location shown to straighten the
compartment so it is parallel to the
edge of unit. (Pull battery door straight
out from center direction as shown to
pull out insulation tab.)
EB Sport Group (referred to as the "Warrantor"), will repair or replace
this product with new or refurbished parts or product, at Warrantor’s
sole option, free of charge, in the U.S.A. in the event of a defect in
materials or workmanship for one (1) year from the date of original
purchase.
Every 10 minutes
• Exhausted batteries to be removed
• Do not dispose of battery in fire; battery may explode
or leak
RESETTING THE PEDOMETER:
To obtain warranty service on your product or a replacement, you may
return it to: EB Sport Group Customer Service, 4 Executive Plaza,
Yonkers, NY, 10701, USA.
This limited warranty gives you specific legal rights and you may also
have other rights, which vary from state to state in the USA.
When your pedometer appears to be functioning abnormally
(for example, the display reading looks strange or appears to
be frozen or a button isn’t functioning properly), you need to
reinitialize your pedometer. To do this use a thin, pointed
object such as a paper clip to press the RESET button on the
back of the pedometer. You will then need to reenter your
stride length and weight.
343 Talking
Calorie Counter
Pedometer
• Do not dispose of product in fire; battery may explode or leak
3. Remove the old battery and install a
new CR2032 battery as indicated by the
polarity symbols (+ and -) marked in
the battery compartment.
For product purchased in the UK:
IF THE UNIT IS RETURNED FOR SERVICING, ENCLOSE $7.50 FOR
POSTAGE AND HANDLING. SEND YOUR UNIT INSURED TO OUR
SERVICE DEPARTMENT.
Should you experience problems with this item, please return it to the
point of purchase. This will not affect your statutory rights.
Alternatively return it to the address shown below for a
repair/replacement: StarCase (UK) Ltd, Berkeley Business Park,
Wainwright Road, Worcester WR4 9FA.
This warranty does not cover damage which occurs in shipment or
failures which are caused by other products not supplied by EB Sport
Group, or failures which result from normal wear, accident misuse,
abuse, neglect, mishandling, misapplication, alteration, modification,
overloading the product beyond its rated capacity, using the product
with an improper accessory or adjustments/repairs/service by anyone
Sportline® is a trademark of SPORTLINE, a division
of EB Sport Group, Yonkers, NY 10701
Distributed in the UK by
4. Put the battery drawer back in place.
TO REPLACE BATTERIES:
Note: You will need to reenter your stride
length and weight after replacing the
batteries.
If the sound weakens or the display dims or distorts, you need
to replace the battery. This pedometer uses one CR2032
battery. To install the new one:
StarCase (UK) Ltd., Worcester, WR4 9FA
All Rights Reserved. ©2008
#3482
©2008 Sportline
WV3482ISO1SPT
steps, distance, calories and time. (See below). If you hold the
AUTO button down when the Auto Report function is turned
on, you will then hear "Auto report is off" and the (((.))) symbol
will disappear from your screen. Then it will no longer
automatically announce the preset goals until you turn
it on again.
MODE – The MODE button has two functions. Each time you
press the mode button once it will take you to the next mode
in sequence from Step, Distance, Calories, and Time. Your
Pedometer will announce the mode you’re in each time you
press it. The MODE button also is used to set your step length
and weight into the pedometer when holding it down. You
will hear "Enter your step length" when held down the first
time. You will then hear "Enter your weight" when held down
the second time. (See below for details on entering your step
length and your weight.)
▲– Allows you to increase step length from 10 inches to 80
inches or 10 centimeters to 120 centimeters when entering
your personal data. It also allows you to increase
weight from 40 pounds to 300 pounds or 20 kilograms to 150
kilograms when inputting your weight.
▼– Allows you to decrease step length from 80 inches to 10
inches or 120 centimeters to 10 centimeters. It also allows you
to decrease weight from 300 pounds to 40 pounds or 150
kilograms to 20 kilograms when inputting your weight.
8. When you reach your stride length press the MODE button
again to set it into your pedometer.
9. When pressing the MODE button in #8 to set your
stride length, your pedometer will then announce
"Enter your Weight".
10. The display will flash the previous weight input you set into
your pedometer in either pounds or kilograms.
11. If you do not need to change the weight, press the MODE
button again to keep the same weight set.
12. If you do need to change the weight, press either the
▲ button or the ▼button until you reach your actual
weight information. You can rapidly increase or decrease
the weight by holding down the ▲and/or ▼.
13. Once you’ve reached the correct weight, press the MODE
button again to set it.
343 TALKING CALORIE COUNTER PEDOMETER
DISPLAY OPTIONS AVAILABLE:
This pedometer can measure and calculate in four modes:
Step, Distance, Calories and Time.
Step Mode shows the number of steps taken from
0 to 99999.
Distance Mode shows the distance you have walked or jogged
in either miles or km’s from 0 to 999.99 MI/
999.99 km.
Calories Mode shows the amount of calories burned from 0 to
99999 kcal.
Time Mode shows the amount of time you’ve exercised from 0
minutes to 999 hours and 59 minutes.
1. Walk 10 steps.
2. Measure the distance that you walked either from
heel-to-heel or toe-to-toe.
3. Divide by the distance covered to arrive at your
stride length.
4. Example: If measured distance equals 360 inches and the
number of steps taken was 10, your stride length equals 36
inches.
IMPORTANT: Please remember that the length of your stride
while walking is different than the length of your stride while
running. If you plan to use this pedometer for both types of
exercise, you will have to reprogram your stride length when
you go from one to the other.
5. Hold the MODE button down starting from any mode until
you hear "Enter your step length". The display will flash
previous stride input in inches or centimeters.
6. If you do not need to change the stride, press the MODE
button again. Then skip to # 1 below.
7. To change your stride length press either the ▲button or
the ▼ button until you reach your actual stride length. You
can rapidly increase or decrease the stride length by
holding down the ▲and/or ▼.
PEDOMETER FEATURES:
RESET
MODE
TALK
TO SET UP YOUR PEDOMETER:
1. First decide whether you want your pedometer to report
your distance in miles or kilometers.
The Talking Calorie Counting Pedometer
has many features to enhance your
walking or jogging experience:
TO START YOUR EXERCISE:
1. Press the CLEAR button (CL) to clear out all data recorded
previously. All readings will go to (0) and you will hear ALL
CLEAR.
2. Press the MODE button until you reach the desired mode
you want to be in. It will display/announce the mode. If you
keep pressing the button, it will announce the data in
sequence.
2. Determine whether your pedometer is currently reporting
data in the Imperial (Miles) system or Metric (Kilometers)
system. If already in desired system, you can skip to ‘Input
Your Stride Length".
3. If you need to switch, press the MODE button to distance
mode, then press the CLEAR (CL) button. Hold the CLEAR
button for 5 seconds. You will hear two beeps signifying
that the system has changed from "KM" to "MI" or vice
versa.
1. Records steps, distance, calories burned
and time with the special feature of
having this information announced to
you at the press of a button.
2. Auto Voice automatically reports
steps, distance, calories burned and
time when the preset goal function is turned on.
3. The ‘smart timer’function can detect false steps so that only
deliberate steps are counted.
(Step, Distance, Calories and Time) simultaneously while
the information is being displayed.
BUTTONS ON YOUR PEDOMETER:
TALK – When pressed once will announce the information
pertaining to the mode currently showing on the display.
When held it will announce step, distance, calories and time in
sequence starting from the mode currently displayed.
CLEAR – When pressed and held it will announce "All Clear"
and reset all data to "O".
AUTO – Hold AUTO button down until you hear "Auto report is
on" and you see (((.))) appear on the screen. When the auto
report is on, your pedometer will automatically announce your
AUTOMATIC VOICE ANNOUNCEMENT:
INPUT YOUR STRIDE LENGTH (ranges from 10 inches to 80
inches or 10 centimeters to 120 centimeters):
TO POSITION THE PEDOMETER:
1. Clip the unit to your belt or to the top of your shorts, trousers or
shorts as close as possible to the crease line.
2. The pedometer must always be horizontal and parallel to
the ground. If you attached it sideways or at an angle, false
readings will occur.
Your pedometer has been programmed with preset goals. If
you want to use this feature simply hold the AUTO button
until you hear "Auto Report Is On" and AUTOTALK will be
displayed on your screen.
TO OPERATE YOUR NEW PEDOMETER:
1. Remove the plastic film from the LCD display on the front of
the pedometer.
2. Open up the battery compartment to remove the battery
protector tab to activate your pedometer. See instructions
on replacing battery to open the battery door.
10
8
6
4
2
0
9
7
5
3
1
Step Distance
Ideal Distance
2
3
4
5
6
7
8
WV3482IS01SPT
06/18/08
Download from Www.Somanuals.com. All Manuals Search And Download.
|