VMS-2
4” Color LCD Service Monitor Kits
User’s Manual
Download from Www.Somanuals.com. All Manuals Search And Download.
I. CONTENTS :
1. 4” LCD monitor
2. Carry Bag and Belts
3. 1000mA Rechargeable Ni-H Battery
4. Three velcos , two for monitor and one for battery.
5. 30 cm power cord.
6. 15V DC Charger. This Charger should only be used to
charge the battery NOT to supply the unit. If used on the
unit Serious damage may occur which will not be covered
by the warranty.
7. RCA to BNC adapter 4 pcs.
8. Spacer Protector
II . Power Operating and Connections
1. Please charge the Ni-H Battery for one and half hours
before using it for the first time.
2. Please stick two velcos to the rear of monitor. Then place
the monitor in the correct position in the bag. This will then
fasten the monitor to the bag will restrict any movement
when the bag lid is open.
3. Connect the battery to monitor via the DC power cord
(Supplied).
Download from Www.Somanuals.com. All Manuals Search And Download.
III. LCD Monitor Operation and Connections :
Controls and Connectors on LCD monitor:
1. Brightness control
2. Contrast Control
3. Volume control for headphones
4. Audio output for headphones
5. Main Power switch
6. Video Left-Right Reverse Switch
7. Audio input
8. Video output
9. Video 1Input
10. Video 2 Input
11. Video Input 1or 2 Switch
12. 12V DC Power Input
1) Switch on the monitor using the Main Power switch (5).
2) Adjust the brightness control (1) and Contrast (2) in order
to obtain an image as clear and sharp as possible.
3) Adjust the volume control of the headphones
Download from Www.Somanuals.com. All Manuals Search And Download.
iii.. Connections
1) Connect the video source to the Video input 1(9) or
Video 2(10) Inputs.
2) Select the correct Video input using the Video Input
switch (11).
3) Connect the Audio source to the audio input (7).
4) Connect an electronically regulated 12V power supply
The positive pole must be connected to the center
contact.
5) Connect headphones to the Audio Output if required.
i
Operation
1) Switch on the monitor using the Main Power switch (5).
2) Adjust the brightness control (1) and Contrast (2) in order
to obtain an image as clear and sharp as possible.
3) Adjust the volume control of the headphones to the
desired level.
4) Select the correct Video Input.
Download from Www.Somanuals.com. All Manuals Search And Download.
vi. Technical Data
LCD technology: TFT active matrix
Display size: 4”
Active area : 82.1 x 61.8 mm
Color system: NTSC or PAL
Sync. :.Horizontal :15, 625 Hz, Vertical : 50 Hz.
Resolution: 480 x 234 , 112,320 Pixels
Audio level: 1V/10k
Video Input : 1Vpp 75 £[
Dimensions ( Bag ) :190.0 (W) x 130.0 (H) x 60 (D) mm
Weight : 1.2 Kg
CAUTION: When using headphones do not adjust the vol-
ume to a high position.
Start at the lowest setting and gradually raise it so it can be
heard. The human ear gets accustom to the volume setting,
so do not further increase the volume after getting used to it.
Permanent high volumes can seriously damage your
hearing.
Download from Www.Somanuals.com. All Manuals Search And Download.
|