Sony Stereo System 377 User Manual

The audio is weak or has poor  
quality.  
• Replace all the batteries with new ones if they  
are weak.  
• Move the player away from the TV.  
• If you are using the remote while listening to  
AM radio, noise may be heard. This is  
unavoidable.  
Notes on CDs  
Information  
Owner's Record  
English  
The model number is located at the bottom and  
the serial number is located in the battery  
compartment.  
Before playing, clean the CD with a  
cleaning cloth. Wipe the CD from the  
center out.  
Precautions  
On safety  
Troubleshooting  
General  
The power does not come on.  
• Connect the AC power cord to the wall outlet  
securely.  
• Make sure the batteries are inserted correctly.  
• Replace all the batteries with new ones if they  
are weak.  
Specifications  
AUDIO POWER SPECIFICATIONS  
POWER OUTPUT AND TOTAL  
HARMONIC DISTORTION  
With 3.2-ohm loads, both channels driven  
from 100 - 10,000 Hz; rated 1.7 W per  
channel-minimum RMS power, with no  
more than 10 % total harmonic distortion  
in AC operation.  
For customers in the USA  
This equipment has been tested and found to  
comply with the limits for a Class B digital  
device, pursuant to Part 15 of the FCC Rules.  
These limits are designed to provide reasonable  
protection against harmful interference in a  
residential installation. This equipment  
generates, uses and can radiate radio frequency  
energy and, if not installed and used in  
accordance with the instructions, may cause  
harmful interference to radio communications.  
However, there is no guarantee that interference  
will not occur in a particular installation. If this  
equipment does cause harmful interference to  
radio or television reception, which can be  
determined by turning the equipment off and on,  
the user is encouraged to try to correct the  
interference by one or more of the following  
measures:  
WARNING  
Record the serial number in the space provided  
below. Refer to them whenever you call upon  
your Sony dealer regarding this product.  
Model No. ZS-Y3  
As the laser beam used in the CD player  
section is harmful to the eyes, do not  
attempt to disassemble the casing. Refer  
servicing to qualified personnel only.  
Should any solid object or liquid fall into  
the player, unplug the player, and have it  
checked by qualified personnel before  
operating it any further.  
Discs with non-standard shapes (e.g.,  
heart, square, star) cannot be played on  
this player. Attempting to do so may  
damage the player. Do not use such discs.  
To prevent fire or shock hazard, do  
not expose the player to rain or  
moisture.  
Serial No.  
The picture of your TV becomes  
unstable.  
• If you are listening to an FM program near  
the TV with an indoor aerial, move the player  
away from the TV.  
For customers in the USA  
Please register this product on line at  
Personal  
Audio  
• You cannot turn on the player with the remote  
when you operate the player on batteries.  
Other specifications  
productregistration.  
There is no audio.  
Do not use solvents such as benzine,  
thinner, commercially available cleaners  
or anti-static spray intended for vinyl LPs.  
Do not expose the CD to direct sunlight or  
heat sources such as hot air ducts, nor  
leave it in a car parked in direct sunlight as  
there can be a considerable rise in  
Remote  
CD player section  
System  
Compact disc digital audio system  
Laser diode properties  
Material: GaAlAs  
Wave length: 780 nm  
Emission duration: Continuous  
Laser output: Less than 44.6 µW  
(This output is the value measured at a distance  
of about 200 mm from the objective lens surface  
on the optical pick-up block with 7 mm aperture.)  
Spindle speed  
200 r/min (rpm) to 500 r/min (rpm)  
(CLV)  
Number of channels  
2
Frequency response  
20 - 20 000 Hz +1/–2 dB  
Wow and flutter  
Below measurable limit  
Proper registration will enable us to send  
you periodic mailings about new product,  
services and other important  
announcements. Registering your product  
will also allow us to contact you in the  
unlikely event that the product needs  
adjustment or modification. Thank you.  
• Make sure the function you want to use  
appears in the display window.  
• Adjust the volume.  
The remote does not function.  
• Replace all the batteries in the remote with  
new ones if they are weak.  
• Make sure that you are pointing the remote at  
the remote sensor on the player.  
• Remove any obstacles in the path of the  
remote and the player.  
• Make sure the remote sensor is not exposed to  
strong light such as direct sunlight or  
fluorescent lamp light.  
• Move closer to the player when using the  
remote.  
System  
• Unplug the headphones when listening  
through speakers.  
Cleaning the cabinet  
Clean the cabinet, panel and controls with  
a soft cloth slightly moistened with a mild  
detergent solution. Do not use any type of  
abrasive pad, scouring powder, or solvent,  
such as alcohol or benzine.  
This symbol is intended to alert the  
user to the presence of uninsulated  
“dangerous voltage” within the  
product's enclosure that may be of  
sufficient magnitude to constitute a  
risk of electric shock to persons.  
— Reorient or relocate the receiving antenna.  
— Increase the separation between the  
equipment and receiver.  
— Connect the equipment into an outlet on a  
circuit different from that to which the  
receiver is connected.  
Operating Instructions  
Noise is heard.  
• Someone is using a portable telephone or  
other equipment that emits radio waves near  
the player. tMove the portable telephone,  
etc., away from the player.  
temperature inside the car.  
Do not stick paper or sticker on the CD,  
nor scratch the surface of the CD.  
After playing, store the CD in its case.  
On power sources  
CD Player  
The CD does not play or “no dISC”  
lights in the display even when a CD  
— Consult the dealer or an experienced radio/  
TV technician for help.  
If there is a scratch, dirt or fingerprints on the  
CD, it may cause tracking error.  
This symbol is intended to alert the  
user to the presence of important  
operating and maintenance  
(servicing) instructions in the  
literature accompanying the  
appliance.  
For AC operation, use the supplied AC  
power cord; do not use any other type.  
The player is not disconnected from the  
AC power source (mains) as long as it is  
connected to the wall outlet, even if the  
player itself has been turned off.  
This class B digital device complies with part 15  
of the FCC rules. Operation is subject to the  
following two conditions: (1) This device may  
not cause harmful interference, and (2) this  
device must accept any interference received,  
including interference that may cause undesired  
operation.  
You are cautioned that any changes or  
modifications not expressly approved in this  
manual could void your authority to operate this  
equipment.  
After trying the above remedies, if you still  
have problems, unplug the AC power cord and  
remove all the batteries. After all the indications  
in the display disappear, plug the power cord  
and insert the batteries again. If the problem  
persists, please consult your nearest Sony  
dealer.  
About CD-Rs/CD-RWs  
is in place.  
This player can play CD-Rs/CD-RWs  
recorded in the CD-DA format*, but  
playback capability may vary depending on  
the quality of the disc and the condition of  
the recording device.  
• Place the CD with the label surface up.  
• Make sure that the CD compartment is closed.  
• Clean the CD.  
For battery operation, use six R14 (size C)  
batteries.  
CAUTION  
• Take out the CD and leave the CD  
compartment open for about an hour to dry  
moisture condensation.  
• Make sure “Cd” appears in the display.  
• The CD-R/CD-RW was not finalized. Finalize  
the CD-R/CD-RW with the recording device.  
• There is a problem with the quality of the CD-  
R/CD-RW, recording device or application  
software.  
The use of optical instruments with this product  
will increase eye hazard.  
When the batteries are not to be used,  
remove them to avoid damage that can be  
caused by battery leakage or corrosion.  
The nameplate indicating operating  
voltage, etc. is located at the rear.  
Radio section  
Frequency range  
FM: 87.5 - 108 MHz  
AM: 530 - 1 710 kHz  
Antennas  
* CD-DA is the abbreviation for Compact  
Disc Digital Audio. It is a recording  
standard used for Audio CDs.  
WARNING  
Do not install the appliance in a confined space,  
such as a bookcase or built-in cabinet.  
To prevent fire or shock hazard, do not place  
objects filled with liquids, such as vases, on the  
appliance.  
Music discs encoded with copyright  
protection technologies  
FM: Telescopic antenna  
AM: Built-in ferrite bar antenna  
ZS-Y3  
On placement  
This product is designed to play back discs  
that conform to the Compact Disc (CD)  
standard. Recently, various music discs  
encoded with copyright protection  
technologies are marketed by some record  
companies. Please be aware that among  
those discs, there are some that do not  
conform to the CD standard and may not by  
playable by this product.  
Do not leave the player in a location near  
heat sources, or in a place subject to direct  
sunlight, excessive dust or mechanical  
shock.  
• Replace all the batteries with new ones if they  
are weak.  
General  
Speaker  
©2004 Sony Corporation  
The CD compartment will not open.  
• The batteries are weak. Replace all the  
batteries with new ones.  
If you need to open the CD compartment  
before you replace the batteries, slide the CD  
LID OPEN switch on the bottom of the player  
with a sharp instrument or tool.  
Main speaker: 8 cm ( 3 1  
cone type (2)  
in.) dia., 3.2 ohms,  
4
Do not place the player on an inclined or  
unstable place.  
2-548-175-92 (1)  
Outputs  
Headphones jack (stereo minijack)  
For 16 - 64 ohms impedance headphones  
Power output  
2.3 W + 2.3 W (at 3.2 ohms, 10% harmonic  
distortion)  
Power requirements  
For player:  
120V AC, 60 Hz  
9 V DC, 6 size C (R14) batteries  
For remote control:  
3 V DC, 2 size AAA (R03) batteries  
Power consumption  
16 W  
Battery life  
For player:  
Do not place anything within 10 mm of  
the side of the cabinet. The ventilation  
holes must be unobstructed for the player  
to operate properly and prolong the life of  
its components.  
The sound drops out.  
Noise is heard.  
• Reduce the volume.  
If you have any questions or problems  
concerning your player, please consult your  
nearest Sony dealer.  
If the player is left in a car parked in the  
sun, be sure to choose a location in the car  
where the player will not be subjected to  
the direct rays of the sun.  
Since a strong magnet is used for the  
speakers, keep personal credit cards using  
magnetic coding or spring-wound watches  
away from the player to prevent possible  
damage from the magnet.  
Power Sources  
• Clean the CD, or replace it if the CD is badly  
damaged.  
• Place the player in a location free from  
vibration.  
• Clean the lens with a commercially available  
blower.  
• The sound may drop out or noise may be  
heard when using poor quality CD-Rs/CD-  
RWs or if there is a problem with the  
recording device or application software.  
C
B
CD playback  
On operation  
Lens  
Sony R14P: approx. 1.5 h  
Sony alkaline LR14: approx. 8 h  
Radio reception  
If the player is brought directly from a  
cold to a warm location, or is placed in a  
very damp room, moisture may condense  
on the lenses inside the CD player section.  
Should this occur, the player will not  
operate properly. In this case, remove the  
CD and wait about an hour for the  
moisture to evaporate.  
A
2 to a wall outlet  
1 to AC IN  
Sony R14P: approx. 6 h  
Sony alkaline LR14: approx. 20 h  
Dimensions  
Approx. 455 × 214 × 180 mm (w/h/d)  
Connect the AC power cord A or insert six size C (R14) batteries (not supplied) into the battery  
(18 × 8 1 2 × 7 1  
/ /8 inches)(incl. projecting parts)  
compartment B .  
Mass  
Approx. 3.5 kg (7 lb. 11 oz) (incl. batteries)  
Supplied accessory  
AC power cord (1)  
Notes  
Radio  
Reception is poor.  
• Replace the batteries when the OPR/BATT indicator dims or when the player stops operating. Replace  
all the batteries with new ones. Before you replace the batteries, be sure to take out the CD from the  
player.  
Remote control (1)  
• Reorient the aerial to improve FM reception.  
• To use the player on batteries, disconnect the AC power cord from the player.  
• When you operate the player on batteries, you cannot turn on the player using the remote.  
Design and specifications are subject to change  
without notice.  
Preparing the remote C  
Insert two size AAA (R03) batteries (not supplied).  
Optional accessories  
Sony MDR headphone series  
Replacing battery  
With normal use, the batteries should last for about six months. When the remote no longer  
operates the player, replace all the batteries with new ones.  
• Reorient the player itself to improve AM  
reception.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Sharp Cell Phone SGH J700V User Manual
Sharp CRT Television Cx68n5 User Manual
Sony Bluetooth Headset BDV E2100 User Manual
Sony Laptop PCG C1XS User Manual
Sony Speaker System SS CNX7 CNX7S User Manual
Soundstream Technologies Speaker System Exact 62 User Manual
Spirit Musical Instrument FOLIO SX mixer User Manual
Sunrise Medical Mobility Aid Quickie P120 User Manual
SV Sound Car Speaker STA 1000D User Manual
Tamron Camera Lens AFB016C700 User Manual