Parts and Controls
Initial Settings
How to Install the Supplied Software
What You Can Do with Your “WALKMAN”
(Including Help guide)
To enjoy music/videos/photos
1 Use the supplied USB cable to connect your
Walkman to a running computer and charge the
Walkman.
1 Connect your Walkman to a running computer
Quick Start Guide
using the supplied USB cable. Plug in the USB
cable with
facing upward, making sure the
How to Install the Supplied Software
How to Use Your “WALKMAN”
Your Walkman turns on.
connection is secure.
Note
If a large battery symbol is displayed while you
You can transfer music from CDs and transfer videos and photos to your Walkman using
a computer.
are charging your Walkman, the remaining
charge is still too low for your Walkman to
operate. The Walkman will start automatically
after being charged for about 10 minutes.
To enjoy FM radio
You can listen to FM radio using the supplied headphones.
2 If the USB connected screen appears, tap the
(Back) button to quit the screen, and then
proceed to the initial settings.
NWZ-F804/F805/F806
To enjoy Internet
©2012 Sony Corporation Printed in Malaysia
(Menu) button
(Home) button
(Back) button
The language selection screen* appears.
Hint
Wi-Fi
You must accept the terms of the End User License Agreement when you use
your Walkman for the first time. To read them again later, tap the (Menu)
button - [System settings] - [ About device] - [Legal information] - [Sony
EULA].
If [USB connected] appears on the screen, tap [Turn on USB storage] to connect
*
Depending on where you purchased your Walkman, the language selection
screen may not appear.
your Walkman.
If the following screen does not appear, swipe the status bar on the top of the
screen and tap [Turn on USB storage] on the notification panel.
3 Select the desired language to be used to display
Headphone jack
WM-PORT jack
the End User License Agreement.
Status bar
About the manuals
In addition to this Quick Start Guide, this model is accompanied by a Help
guide (HTML document) that gives detailed operating instructions.
To view on your “WALKMAN” screen:
See “How to Use the Help guide on Your “WALKMAN”.”
To view on a computer screen:
You can browse the Internet and download applications by connecting to a Wi-Fi
network.
Connect the USB cable (supplied), or other accessories that support WM-PORT
(not supplied).
4 Make sure that you understand the terms of the
license agreement then tap [Agree].
The initial setup screen appears.
Hint
Speaker
For details about this function or usage, refer to the Help guide (HTML document).
Strap hole
See “How to Install the Supplied Software (Including Help guide).”
5 Tap .
Built-in microphone
Built-in antenna
Wi-Fi, Bluetooth, and GPS antennas are built-in.
Screen (touch screen)
Touch (tap) icons, items, control buttons, etc., on the screen to operate your
Walkman.
4-432-452-11(1)
VOL (Volume) +/– button
(Double-u Dot) button
You can access your Walkman from the computer.
2 Select your Walkman on the computer.
This is used to directly display the W.control.
Contents
Click [Start] - [Computer] or [My Computer] - [WALKMAN].
RESET button
Please check the items in the package.
“WALKMAN” (1)
Headphones (1)
Earbuds (Size S, L) (1)
At purchase, M size earbuds are installed.
USB cable (1)
Attachment (1)
Use when connecting your Walkman to a peripheral device, such as a cradle
(not supplied).
Quick Start Guide (this manual)
Software
The software is stored in the built-in flash memory of your Walkman, and
includes the following items. For details on how to install, see “How to Install
the Supplied Software (Including Help guide).”
Media Go
WALKMAN Guide
Help guide, etc.
3 Double-click [Setup.exe].
Press the RESET button with a small pin, etc., to reset your Walkman.
The install wizard appears.
(Power) button
Hold down: Turns the power on/off.
Press: Turns the screen on/off.
Hint
6 Select the desired language.
7 Tap to begin using your Walkman.
When you execute [Setup.exe], the [Setup.exe] file stored in the [WALKMAN]
folder of your Walkman is copied to your computer for backup, and the
WALKMAN Guide and Media Go are installed to your computer.
If you changed the type of USB connection to a setting other than MSC mode,
change mode back to MSC mode again by tapping [Connected as USB Storage] on
the notification panel.
About volume operation (Only for
countries/areas complying with European
Directives)
If [Setup.exe] does not start, copy the [Setup.exe] file to your desktop, then
double-click it.
An alarm (beep)* and warning [Check the volume level] are meant to protect your
ears when you raise the volume setting beyond a specific level for the first time. You
can cancel the alarm and warning by tapping [OK] button on the alert dialog.
4 Follow the on-screen instructions.
After the install wizard finishes, the
(WALKMAN Guide) icon
appears on the desktop of your computer. You can view the Help
* The alarm (beep) does not sound when connecting a Bluetooth audio device.
guide by double-clicking the
clicking on the Help guide.
(WALKMAN Guide) icon and
Note
You can turn up the volume beyond the specific level after canceling the alarm and
warning.
5 Start Media Go.
After the initial warning, the alarm and warning repeat for every 20 cumulative hours
that the volume is set beyond the specific level; when this happens, the volume is
changed to the initial setting automatically.
About Windows Operating System
You can transfer content stored on your computer to your Walkman.
For details on transferring music, etc., refer to the Help guide.
Make sure that the OS is Windows XP (Service Pack 3 or later), Windows Vista*
(Service Pack 2 or later) or Windows 7* (Service Pack 1 or later).
If the volume is set beyond the specific level and you turn off your Walkman, the
volume returns to the specific level automatically.
Hint
*
[Compatibility mode] for Windows XP is not supported.
You can start the WALKMAN Guide and Media Go from the [Start] menu (displayed by
clicking [Start]).
8 Set the Wi-Fi connection, Google account and
date/time, etc., following the instructions shown
on the screen.
You can install the supplied software on another computer through the following
procedure even if you delete the [Setup.exe] file by formatting the built-in flash memory
of your Walkman. Copy the [Setup.exe] file and the [Install] folder from the [Backup]
folder of your computer to the Walkman. Then, connect the Walkman to another
computer on which you want to install the software and follow the above procedure
from step 2.
Hint
Wi-Fi connection and Google account can also be set afterwards.
The [Backup] folder can be found at
C:\Program Files\Sony\WALKMAN Guide\NWZ-F800\Backup
([Program Files(x86)] may be displayed depending on the computer OS.)
Download from Www.Somanuals.com. All Manuals Search And Download.
|