Listening to music from a paired
Listening to Music by
Wireless Connection with
a Bluetooth Device
Bluetooth device
Rear of the system
1 Turn on the system.
AUDIO IN jack
DC IN 5.2V jack
2 Make sure the (Bluetooth) indicator (blue) on
the system flashes.
You can enjoy music with the system wirelessly by using your
device’s Bluetooth function.
If the (Bluetooth) indicator (blue) is off, press the INPUT
For details on how to operate your device, refer to the operating
instructions supplied with the device.
button so that the (Bluetooth) indicator (blue) flashes.
3 Set the Bluetooth function of the Bluetooth
Check the following before operating the system.
Wireless Speaker System
device to on.
Both the system and the device are placed within 1 m (3 ft) of
each other.
The system is connected to a power source, or batteries are
installed into the system.
The operating instructions supplied with the device are kept
at hand.
Battery compartment (rear of the system)
Operating Instructions
4 Select “SRS-BTD70”shown in the display of the
Bluetooth device.
The Bluetooth connection is completed and the (Bluetooth)
indicator (blue) on the system stays on.
Note
Pairing with a Bluetooth device
This step may not be necessary for some devices.
and listening to music
5 Start playback on the Bluetooth device, then
POWER switch
Bluetooth devices need to be “paired”with each other
beforehand.
adjust the volume.
Set the volume of the Bluetooth device to a moderate level,
INPUT/ PAIRING button
and press the VOLUME –/+ buttons on the system.
1 Turn on the system.
4-430-852-11(1)
©2012 Sony Corporation Printed in Malaysia
Tips
VOLUME −/+ button
2 Set the Bluetooth function of the Bluetooth
You can adjust the volume of the system via a Bluetooth device
device to on.
supporting AVRCP (Audio/Video Remote Control Profile) VOLUME
UP/DOWN. For details, refer to the operating instructions supplied
with the device.
POWER indicator (green)
For details, refer to the operating instructions supplied with
the device.
(Bluetooth) indicator (blue)
SRS-BTD70
The volume of the system may not be controllable, depending on
the device.
3 Press and hold the PAIRING button on the
system until the (Bluetooth) indicator (blue)
begins to flash quickly.
Note
Function of Parts
Turning the System on/off
1 Connect the supplied AC adaptor.
More than one device can be paired with the system, but sound
will be heard from just one of those devices.
English
Wireless Speaker System
Precautions
POWER switch
Before operating the system, please read this guide thoroughly
and retain it for future reference.
Notes when using with a mobile phone
Turns the system on/off.
To finish listening
Do any of the following operations.
You cannot use this system to talk over the telephone, even if
a Bluetooth connection between this system and a mobile
phone is made.
INPUT/ PAIRING button
Press to use the Bluetooth connection or pair with a Bluetooth
Set the Bluetooth function of the Bluetooth device to off. For
details, refer to the operating instructions supplied with the
device.
WARNING
device.
For details on operation of your mobile phone when receiving
a telephone call while transmitting the sound using the
Bluetooth connection, refer to the operating instructions
supplied with the mobile phone.
Press also to listen to the sound from the device connected to
the AUDIO IN jack.
To reduce the risk of fire or electric shock, do not expose this
apparatus to rain or moisture.
Turn off the Bluetooth device.
Turn off the system.
VOLUME −/+ button
Adjusts the volume. The POWER indicator (green) flashes three
times when the volume is set to minimum or maximum.
To reduce the risk of electrical shock, do not open the cabinet.
Refer servicing to qualified personnel only.
To delete all pairing information from
the system
On safety
The nameplate indicating Sony trademark, model number and
electrical rating is located on the bottom exterior of this system.
(Bluetooth) indicator (blue)
To reduce the risk of fire, do not cover the ventilation opening of
the apparatus with newspapers, tablecloths, curtains, etc. Do not
place the naked flame sources such as lighted candles on the
apparatus.
Hold the VOLUME − button and press the INPUT/ PAIRING
Lights up or flashes depending on the communication status.
For details, see the following section, “Indications of the
Bluetooth function.”
Before operating the system, be sure that the operating
voltage of the system is identical with that of your local power
supply.
button for more than 5 seconds while the system is turned on.
The POWER indicator (green) lights up, and the (Bluetooth)
indicator (blue) flashes quickly. The system is reset to its default
and all pairing information is deleted.
POWER indicator (green)
Lights up when the system is turned on. Flashes during battery
operation if battery power is low.
To reduce the risk of fire or electric shock, do not expose this
apparatus to dripping or splashing, and do not place objects
filled with liquids, such as vases, on the apparatus.
Where purchased
Operating voltage
2 Turn the POWER switch to ON.
The indicator flashes quickly.
All countries/regions
100 V – 240 V AC, 50/60 Hz
The POWER indicator (green) lights up.
AUDIO IN jack
Connects to the headphone jack of a portable audio device,
computer, etc., using the supplied connecting cord.
4 Perform the pairing procedure on the Bluetooth
Do not install the appliance in a confined space, such as a
bookcase or built-in cabinet.
device to detect the system.
Listening to Music by
Wired Connection with a
Portable Audio Device,
etc.
Notes on the AC adaptor
If “SRS-BTD70”does not appear on the device’s display,
repeat from step 2.
When connecting or disconnecting the AC adaptor, turn off
the system beforehand. Otherwise, it may cause malfunction.
Use only the supplied AC adaptor. To avoid damaging the
system, do not use any other AC adaptor.
DC IN 5.2V jack
Connects the supplied AC adaptor.
As the main plug of the AC adaptor is used to disconnect the AC
adaptor from the mains, connect the system to an easily
accessible AC outlet. Should you notice an abnormality in the
system, disconnect the main plug from AC outlet immediately.
Note
Battery compartment
Insert three LR6 (size AA) batteries (not supplied).
Some devices cannot display a list of detected devices.
5 Select “SRS-BTD70”shown in the display of the
The system is not disconnected from the mains as long as it is
connected to the AC outlet, even if the system itself has been
turned off.
Bluetooth device.
Indications of the Bluetooth function
Status
1 Connect the device to the system.
Polarity of the plug
(Bluetooth) indicator (blue)
6 If Passcode* input is required on the display of
Plug the AC adaptor into a nearby wall outlet (mains). In the
case of a problem, unplug it from the wall outlet (mains)
immediately.
Do not install the AC adaptor in a confined space, such as a
bookcase or built-in cabinet.
To reduce the risk of fire or electric shock, do not expose the
AC adaptor to dripping or splashing, and do not place objects
filled with liquids, such as vases, on the AC adaptor.
On Copyrights and Licenses
the Bluetooth device, input “0000.”
Pairing with a device
Searching for a device
Connected to a device
AUDIO IN mode
Flashes quickly
Flashes
The Bluetooth® word mark and logos are owned by the Bluetooth
SIG, Inc. and any use of such marks by Sony Corporation is under
license.
The Bluetooth connection is completed and the (Bluetooth)
indicator (blue) on the system stays on.
Lights up
Off
* Passcode may be called “Passkey,”“PIN code,”“PIN number,”
or “Password.”
Other trademarks and trade names are those of their respective
owners.
The indicator lights up.
7 Start playback on the Bluetooth device, then
CAUTION
adjust the volume.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority to
operate this equipment.
To use with LR6 (size AA) batteries (not
supplied)
On placement
Set the volume of the Bluetooth device to a moderate level,
and press the VOLUME –/+ buttons on the system.
Connecting cord (supplied)
Do not set the speaker in an inclined position.
Do not leave the system in a location near heat sources, or in a
place subject to direct sunlight, excessive dust, moisture, rain
or mechanical shock.
1
Press and slide the cover.
Tip
To pair with other Bluetooth devices, repeat steps 2 to 6 for each
Do not expose the battery to excessive heat such as direct
sunlight, fire or the like.
device.
Notes
On operation
Pairing mode of the system is cancelled after about 5 minutes, and
Do not insert any small objects, etc., into the jacks or
the (Bluetooth) indicator (blue) turns off. If the pairing mode is
cancelled while performing this procedure, start over from step 3.
Passcode of the system is fixed as “0000.”The system cannot be
paired with a Bluetooth device whose Passcode is not “0000.”
Once Bluetooth devices are paired, there is no need to pair those
devices again. However, in the following cases, you will need to
perform the pairing procedure again.
ventilation hole on the rear of the system. The system may
short out or malfunction.
2 Turn on the system.
2
Install three LR6 (size AA) batteries (not supplied), then close
the cover.
On cleaning
3 Make sure the (Bluetooth) indicator (blue) on
Do not use alcohol, benzine, or thinner to clean the cabinet.
the system is off.
If the (Bluetooth) indicator (blue) is on or flashing, press
– Pairing information is deleted after repair, etc.
– The system is paired with 9 or more devices.
Others
the INPUT button to turn it off.
If you have any questions or problems concerning this system
that are not covered in this manual, please consult your
nearest Sony dealer.
The system can be paired with up to 8 Bluetooth devices. If a new
device is paired after 8 devices have been paired, the device
whose latest connection time is the oldest among the 8 paired
devices is replaced by the new one.
4 Start playback on the connected device, then
adjust the volume.
3
Turn the POWER switch to ON.
Set the volume of the connected device to a moderate level,
and press the VOLUME –/+ buttons on the system.
Tip
If the AC adaptor is used with the system, the power source
switches to power from the wall outlet (mains) automatically, even
if batteries are installed.
Download from Www.Somanuals.com. All Manuals Search And Download.
|