Sony Clock Radio FX483 User Manual

FX487  
3-861-494-13(1)  
z Ge t t in g St a rt e d  
Pre p a rin g a Po w e r So u rce  
Dry Ba t t e ry  
z Op e ra t in g t h e Wa lkm a n  
Ho u se Cu rre n t  
List e n in g t o t h e Ra d io  
REW  
FF  
FF  
œ
p
REW  
HOLD  
Pla yin g a Ta p e  
FX487  
Ra d io Ca sse t t e Pla ye r  
œ
p
VOL  
Operating Instructions  
TUNING +/–  
FX485/FX483  
RADIO ON  
/BAND  
Connect the AC power adaptor AC-E30HG (not  
supplied) to the DC IN 3 V jack and to the mains. Do not  
use any other AC power adaptor.  
Specifications for AC-E30HG varies for each area. Check  
your local voltage and the shape of plug before  
purchasing.  
OPEN  
WALKMAN is a registered trademark of Sony Corporation.  
pRADIO OFF  
œ
p
1
Open the cassette holder and insert a cassette.  
WM-FX487/FX485/FX483  
Sony Corporation 1998 Printed in Malaysia  
HOLD  
FX485/FX483  
FX487  
HOLD  
VOL  
FF  
REW  
p• RADIO OFF  
Polarity of  
the plug  
VOL  
œ
TUNING +/–  
To  
Press  
Open the battery compartment lid, and insert two size  
AA (R6) dry batteries with correct polarity.  
TAPE  
Fo r t h e cu st o m e rs in t h e U.S.A.  
OWNER' S RECORD  
play the other side  
stop playback  
fast forward  
rewind  
œ
(play) during playback  
HOLD  
VOL  
SET  
p
RADIO ON/BAND  
If t h e b a t t e ry co m p a rt m e n t lid co m e s o ff  
œ
The model number is located at the bottom and the serial  
number is located inside the cassette holder. Record the model  
and serial numbers in the spaces provided below. Refer to these  
numbers whenever you call upon your Sony dealer regarding  
this product.  
FF during stop  
MENU  
To u se t h e b e lt clip  
2
1 Make sure the HOLD function is turned off.  
REW during stop  
REW during playback  
If it is on, slide the HOLD switch to turn it off.  
With the supplied belt clip, you can wear your Walkman  
on a belt for convenient use.  
play the same side from the  
beginning (Rewind Auto  
Play function)  
1
FX485/FX483  
2 Press RADIO ON/ BAND to turn on the radio.  
HOLD  
VOL  
Model No. _________________ Serial No.___________________  
To re m o ve t h e b e lt clip  
play the other side from the  
beginning (Skip Reverse  
function)  
FF during playback  
3 Press RADIO ON/ BAND repeatedly to select FM1,  
INFORMATION  
FM2, FM3 or AM.  
TAPE  
This equipment has been tested and found to comply with the  
limits for a Class B digital device, pursuant to Part 15 of the FCC  
Rules. These limits are designed to provide reasonable  
protection against harmful interference in a residential  
installation. This equipment generates, uses, and can radiate  
radio frequency energy and, if not installed and used in  
accordance with the instructions, may cause harmful  
interference to radio communications. However, there is no  
guarantee that interference will not occur in a particular  
installation. If this equipment does cause harmful interference to  
radio or television reception, which can be determined by  
turning the equipment off and on, the user is encouraged to try  
to correct the interference by one or more of the following  
measures:  
Wh e n t o re p la ce t h e b a t t e rie s  
Replace the batteries when “n” flashes in the display.  
The battery remainder mark has 3 steps to show the  
remaining battery power.  
4 Press TUNING+/ – to tune in to the desired station.  
If you keep pressing TUNING+/ – for a few seconds,  
the Walkman will start tuning to the stations  
automatically.  
SET  
FX487  
FX485  
FX483  
MENU  
œ
The battery power is full.  
MODE  
aNR  
MODE  
aNR  
MODE  
To t u rn o ff t h e ra d io  
Press p• RADIO OFF .  
2
3
Make sure the HOLD function is turned off.  
If it is on, slide the HOLD switch to turn it off.  
To a t t a ch t h e b e lt clip  
The battery power is decreasing.  
The batteries are exhausted.  
Replace them with new ones.  
Press MENU repeatedly to set the cursor to TAPE in  
the display.  
SET  
SET  
MENU  
MENU  
Then press SET to select the tape type.  
No message: normal (TYPE I)  
METAL: CrO2 (TYPE II) or metal (TYPE IV)  
– Reorient or relocate the receiving antenna.  
– Increase the separation between the equipment and receiver.  
– Connect the equipment into an outlet on a circuit different from  
that to which the receiver is connected.  
– Consult the dealer or an experienced radio/ TV technician for  
help.  
To se le ct p la yb a ck m o d e  
Press MENU repeatedly to set the cursor to MODE in the  
display. Then press SET to select the desired mode.  
Notes  
• The battery remainder mark may temporarily show a lower  
level during fast forwarding or rewinding or use in extremely  
low temperatures.  
• When replacing batteries, replace both batteries within 30  
seconds; otherwise all the memories including the preset radio  
stations will be canceled.  
4
Press œ (play) to start playing then adjust the  
volume.  
Co n n e ct in g t h e He a d p h o n e s/  
Ea rp h o n e s  
To play  
Select  
This device complies with Part 15 of the FCC Rules. Operation  
is subject to the following two conditions:  
(1) This device may not cause harmful interference, and  
(2) this device must accept any interference received, including  
interference that may cause undesired operation.  
Both sides repeatedly  
a
When adjusting the volume on the Walkman (FX487  
only)  
Both sides once from the side  
facing the cassette holder  
Å
FX487  
FX485/FX483  
Battery life (Approx. hours)  
(EIAJ*)  
Set the VOL control on the remote control at maximum.  
2
2
Tape playback Radio reception  
To p la y a t a p e re co rd e d w it h Do lb y* NR syst e m  
(FX487/FX485 o n ly)  
Press MENU repeatedly to set the cursor to a NR  
(Dolby noise reduction) in the display. Then press SET to  
show “ON”.  
When adjusting the volume on the remote control  
(FX487 only)  
You are cautioned that any changes or modifications not  
expressly approved in this manual could void your authority to  
operate this equipment.  
Sony alkaline LR6 (SG)  
Sony R6P (SR)  
24  
38  
14  
Set the VOL control on the Walkman slightly above the  
7.5  
appropriate level.  
* Measured value by the standard of EIAJ (Electronic Industries  
Association of Japan). (Using a Sony HF series cassette tape)  
Note on the cassette holder  
Ab o u t Th is Ma n u a l  
* Dolby noise reduction manufactured under license from Dolby  
Laboratories Licensing Corporation.  
“DOLBYand the double-D symbol a are trademarks of  
Dolby Laboratories Licensing Corporation.  
When opening the cassette holder, press the p (stop) button and  
make sure the tape is stopped by checking through the cassette  
window, then slide the OPEN switch.  
If the cassette holder is opened before the tape is stopped, the  
tape may loosen and be damaged.  
Note  
1
2
Connect the headphones/ earphones to 2.  
• The battery life may shorten depending on the operation of the  
unit.  
The instructions in this manual are for WM-FX487, WM-  
FX485 and WM-FX483. Before you start reading, check  
your model number. WM-FX487 is the model used for  
illustration purposes. Any differ2ences in operation are  
clearly indicated in the text, for example, “FX487 only”.  
Wear the “L” marked side to the left ear and the “R”  
marked side to the right ear.  
For maximum performance we recommend that you use  
alkaline batteries.  
If the earphones do not fit to your ears or the sound is  
unbalalnced, turn round the earphones a little to fit to  
your ears firmly.  
turn over m  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Sennheiser Stereo Receiver RI 150 User Manual
Shark Vacuum Cleaner NV356Q User Manual
Silicon Laboratories Radio SI4730 User Manual
Soehnle Scale body fat monitor User Manual
Sony Camcorder XR200VE User Manual
Sony DVD Recorder RDR GX350 User Manual
Southwestern Bell Telephone FM2552PX User Manual
Sunbeam Blood Pressure Monitor 7655 10 User Manual
Sunbeam Scale 78411 04 User Manual
Swann DVR DVR16 NET PLUS User Manual