3-810-695-13(1)
Pla yin g Ca sse t t e
Op e ra t in g t h e Ca sse t t e Pla ye r
To wind the tape
Press 0or ).
To adjust the volume
Turn the VOLUME
control.
Ca sse t t e Pla ye r
To stop
Press pSTOP.
2
VOLUME
WM-EX122
No t e s o n p la yin g ca sse t t e s
• Do not use cassettes longer than 90 minutes except for long
continuous playback.
• If the tape is playing but no sound comes out, the batteries may be
weak. Replace all batteries with new ones.
NORM CrO2/
METAL
Op e ra t in g In st ru ct io n s
WALKMAN is a registered trademark of Sony Corporation.
Printed in Malaysia
Sony Corporation © 1996
• If your Walkman has not been used for a long time, run the
Walkman for a few minutes before inserting a cassette.
• Do not open the cassette holder while the tape is running.
• Do not wind the headphones cord around the Walkman. The
buttons may be kept pressed, causing unnecessary battery usage.
pSTOP
0 )
9PLAY
OWNER’S RECORD
The model number is located at the rear and the
serial number is located inside the cassette holder.
Record the serial number in the space provided
below. Refer to them whenever you call upon your
Sony dealer regarding this product.
Usin g MEGA BASS
Set the MEGA BASS switch to ON to produce deep and
powerful sound.
Cassette holder
MEGA BASS
Model No. WM-EX122
Serial No.
ON
OFF
Ge t t in g St a rt e d
1
In se rt a ca sse t t e .
Wh e n u sin g MEGA BASS
If the AVLS switch is set to LIMIT, the MEGA BASS effect is reduced.
Usin g w it h Ba t t e rie s
Insert two AA (R6) batteries in correct polarity.
AA (R6) x 2
2
3
Se le ct t h e NORM o r
CrO2/METAL m o d e t o
m a t ch t h e t a p e t yp e .
DC IN 3V
No t e s
• When you are not going to use your Walkman for a long time,
remove the batteries to prevent damage from battery leakage and
corrosion.
• When the batteries become weak, the sound will be unstable or can
not be heard. In such a case, replace both batteries.
• Concerning the battery life, see “Specifications”.
NORM CrO2
/
METAL
Pre ss t h e 9PLAY.
PLAY
Usin g Ext e rn a l Po w e r So u rce s
You can connect the following external power sources
through the DC IN 3 V jack located on the bottom.
(When you plug a cord into the DC IN 3 V jack, the
internal batteries are automatically bypassed.)
• House current using an AC-E30HG AC power adaptor
No t e
Use only the recommended
AC-E30HG AC power adaptor (not
supplied). Do not use any other AC
power adaptor.
Polarity of the plug
Download from Www.Somanuals.com. All Manuals Search And Download.
|