Sony CD Player ZS X1 User Manual

On operation  
Information  
Owner's Record  
English  
CD Player  
The CD does not play or “no dISC”  
lights in the display even when a CD  
is in place.  
• Place the CD with the label surface up.  
The model number is located at the bottom and  
the serial number is located in the battery  
compartment.  
If the player is brought directly from a  
cold to a warm location, or is placed in a  
very damp room, moisture may condense  
on the lenses inside the CD player section.  
Should this occur, the player will not  
operate properly. In this case, remove the  
CD and wait about an hour for the  
moisture to evaporate.  
Precautions  
On safety  
Specifications  
For customers in the USA  
This equipment has been tested and found to  
comply with the limits for a Class B digital  
device, pursuant to Part 15 of the FCC Rules.  
These limits are designed to provide reasonable  
protection against harmful interference in a  
residential installation. This equipment  
generates, uses and can radiate radio frequency  
energy and, if not installed and used in  
accordance with the instructions, may cause  
harmful interference to radio communications.  
However, there is no guarantee that interference  
will not occur in a particular installation. If this  
equipment does cause harmful interference to  
radio or television reception, which can be  
determined by turning the equipment off and on,  
the user is encouraged to try to correct the  
interference by one or more of the following  
measures:  
WARNING  
Record the serial number in the space provided  
below. Refer to them whenever you call upon  
your Sony dealer regarding this product.  
Model No. ZS-X1  
As the laser beam used in the CD player  
section is harmful to the eyes, do not  
attempt to disassemble the casing. Refer  
servicing to qualified personnel only.  
Should any solid object or liquid fall into  
the player, unplug the player, and have it  
checked by qualified personnel before  
operating it any further.  
Discs with non-standard shapes (e.g.,  
heart, square, star) cannot be played on  
this player. Attempting to do so may  
damage the player. Do not use such discs.  
AUDIO POWER SPECIFICATIONS  
POWER OUTPUT AND TOTAL  
HARMONIC DISTORTION  
With 3.2-ohm loads, both channels driven  
from 150 - 10 000 Hz; rated 1.8 W per  
channel-minimum RMS power, with no  
more than 10 % total harmonic distortion  
in AC operation.  
To prevent fire or shock hazard, do  
not expose the player to rain or  
moisture.  
• Clean the CD.  
• Take out the CD and leave the CD  
compartment open for about an hour to dry  
moisture condensation.  
• The CD-R/CD-RW was not finalized. Finalize  
the CD-R/CD-RW with the recording device.  
• There is a problem with the quality of the CD-  
R/CD-RW, recording device or application  
software.  
Serial No.  
Notes on CDs  
For customers in the USA  
Personal  
Audio  
Before playing, clean the CD with a  
cleaning cloth. Wipe the CD from the  
center out.  
Please register this product on line at  
Proper registration will enable us to send you  
periodic mailings about new product,  
services and other important announcements.  
Registering your product will also allow us to  
contact you in the unlikely event that the  
product needs adjustment or modification.  
Thank you.  
Other specifications  
• Replace all the batteries with new ones if they  
are weak.  
CD player section  
System  
Compact disc digital audio system  
Laser diode properties  
Material: GaAlAs  
Wave length: 780 nm  
Emission duration: Continuous  
Laser output: Less than 44.6 µW  
(This output is the value measured at a distance  
of about 200 mm from the objective lens surface  
on the optical pick-up block with 7 mm  
aperture.)  
Spindle speed  
200 r/min (rpm) to 500 r/min (rpm)  
(CLV)  
Number of channels  
2
Frequency response  
20 - 20 000 Hz +0/–1 dB  
Wow and flutter  
Below measurable limit  
System  
The sound drops out.  
• Reduce the volume.  
• Clean the CD, or replace it if the CD is badly  
damaged.  
• Place the player in a location free from  
vibration.  
• Clean the lens with a commercially available  
blower.  
• The sound may drop out or noise may be  
heard when using poor quality CD-Rs/CD-  
RWs or if there is a problem with the  
recording device or application software.  
Cleaning the cabinet  
Clean the cabinet, panel and controls with  
a soft cloth slightly moistened with a mild  
detergent solution. Do not use any type of  
abrasive pad, scouring powder, or solvent,  
such as alcohol or benzine.  
This symbol is intended to alert the  
user to the presence of uninsulated  
“dangerous voltage” within the  
product's enclosure that may be of  
sufficient magnitude to constitute a  
risk of electric shock to persons.  
— Reorient or relocate the receiving antenna.  
— Increase the separation between the  
equipment and receiver.  
— Connect the equipment into an outlet on a  
circuit different from that to which the  
receiver is connected.  
Operating Instructions  
Do not use solvents such as benzine,  
thinner, commercially available cleaners  
or anti-static spray intended for vinyl LPs.  
Do not expose the CD to direct sunlight or  
heat sources such as hot air ducts, nor  
leave it in a car parked in direct sunlight as  
there can be a considerable rise in  
On power sources  
— Consult the dealer or an experienced radio/  
TV technician for help.  
This symbol is intended to alert the  
user to the presence of important  
operating and maintenance  
(servicing) instructions in the  
literature accompanying the  
appliance.  
For AC operation,  
use the supplied  
AC power  
This class B digital device complies with part 15  
of the FCC rules. Operation is subject to the  
following two conditions: (1) This device may  
not cause harmful interference, and (2) this  
device must accept any interference received,  
including interference that may cause undesired  
operation.  
You are cautioned that any changes or  
modifications not expressly approved in this  
manual could void your authority to operate this  
equipment.  
Polarity of  
the plug  
You cannot open/close the lid of the  
CD compartment.  
• Place the player on a level surface and open/  
close the lid.  
adaptor; do not  
use any other type.  
temperature inside the car.  
The player is not disconnected from the  
AC power source (mains) as long as it is  
connected to the wall outlet, even if the  
player itself has been turned off.  
Unplug the player from the wall outlet  
when it is not to be used for an extended  
period of time.  
Do not stick paper or sticker on the CD,  
nor scratch the surface of the CD.  
After playing, store the CD in its case.  
CAUTION  
The use of optical instruments with this product  
will increase eye hazard.  
Lens  
If there is a scratch, dirt or fingerprints on the  
CD, it may cause tracking error.  
WARNING  
Radio section  
Frequency range  
FM: 87.5 - 108 MHz  
AM: 530 - 1 710 kHz  
Antennas  
FM: Telescopic antenna  
Do not install the appliance in a confined space,  
such as a bookcase or built-in cabinet.  
To prevent fire or shock hazard, do not place  
objects filled with liquids, such as vases, on the  
appliance.  
About CD-Rs/CD-RWs  
For battery operation, use six size D (R20)  
batteries.  
This player can play CD-Rs/CD-RWs  
recorded in the CD-DA format*, but  
playback capability may vary depending on  
the quality of the disc and the condition of  
the recording device.  
ZS-X1  
When the batteries are not to be used,  
remove them to avoid damage that can be  
caused by battery leakage or corrosion.  
The nameplate indicating operating  
voltage, etc. is located at the bottom.  
For customers in Canada  
To prevent electric shock, match wide blade of  
plug to wide slot, fully insert.  
AM: Built-in ferrite bar antenna  
©2003 Sony Corporation  
Printed in China  
* CD-DA is the abbreviation for Compact  
Disc Digital Audio. It is a recording  
standard used for Audio CDs.  
General  
Speaker  
3-251-191-11 (1)  
On placement  
Radio  
Full range: 10 cm dia., 3.2 ohms, cone type (2)  
Outputs  
Headphones jack (stereo minijack)  
For 16 - 64 ohms impedance headphones  
Power output  
2.3 W + 2.3 W (at 3.2 ohms, 10% harmonic  
distortion)  
Power requirements  
DC IN 9V jack accepts:  
Supplied AC power adaptor for use with 120V  
AC, 60 Hz  
9 V DC, 6 size D (R20) batteries  
Battery life  
For personal audio system:  
Do not leave the player in a location near  
heat sources, or in a place subject to direct  
sunlight, excessive dust or mechanical  
shock.  
Reception is poor.  
• Reorient the antenna to improve FM  
reception.  
Music discs encoded with copyright  
protection technologies  
This product is designed to play back discs  
that conform to the Compact Disc (CD)  
standard. Recently, various music discs  
encoded with copyright protection  
technologies are marketed by some record  
companies. Please be aware that among  
those discs, there are some that do not  
conform to the CD standard and may not be  
playable by this product.  
Do not place the player on an inclined or  
unstable place.  
Power Sources  
Do not place anything within 10 mm of  
the side of the cabinet. The ventilation  
holes must be unobstructed for the player  
to operate properly and prolong the life of  
its components.  
B
2 to a wall outlet  
• Reorient the player itself to improve AM  
reception.  
If the player is left in a car parked in the  
sun, be sure to choose a location in the car  
where the player will not be subjected to  
the direct rays of the sun.  
Since a strong magnet is used for the  
speakers, keep personal credit cards using  
magnetic coding or spring-wound watches  
away from the player to prevent possible  
damage from the magnet.  
CD playback  
If you have any questions or problems  
concerning your player, please consult your  
nearest Sony dealer.  
Sony R20P: approx. 7.5 h  
Sony alkaline LR20: approx. 14 h  
Radio play  
Sony R20P: approx. 11 h  
Sony alkaline LR20: approx. 24 h  
The audio is weak or has poor quality.  
• Replace all the batteries with new ones if they  
are weak.  
Troubleshooting  
General  
The power does not come on.  
• Make sure the batteries are inserted correctly.  
• Replace all the batteries with new ones if they  
are weak.  
Do not immerse in water  
This product is not meant to be immersed in  
water or come in continuous contact with  
water.  
A 1 to DC IN 9V  
Dimensions  
• Move the player away from the TV.  
Approx. 430 × 169 × 288 mm (w/h/d)  
The picture of your TV becomes  
unstable.  
• If you are listening to an FM program near the  
TV with an indoor antenna, move the player  
away from the TV.  
(17 × 6 3 4 × 11 38 inches) (incl. projecting parts)  
Mass  
Before opening or shutting the CD  
compartment or battery compartment lid,  
be sure to wipe off water, dust or sand on  
the outside of the player.  
Water in the headphones jack/DC IN jack  
may cause rusting. Cover the jacks with  
the attached rubber cap when the jacks are  
not used.  
If the player is splashed with salt water,  
wipe clean with a damp cloth, then dry  
with a soft dry cloth. Do not wash under  
running water; do not use soap or  
detergent; do not dry with an electric hair  
dryer.  
The supplied AC power adaptor is not  
water resistant. To prevent shock hazard,  
avoid using the player near water during  
AC operation.  
Approx. 3.5 kg (7 lb. 11 oz) (incl. batteries)  
Supplied accessory  
AC power adaptor(1)  
Connect the AC power adaptor A or insert six size D (R20) batteries (not supplied) into the  
battery compartment B.  
The power is not on, and "bAttErY"  
and “Error” are displayed alternately.  
• Make sure the batteries are inserted correctly.  
• Replace all the batteries with new ones if they  
are weak.  
After trying the above remedies, if you still have  
problems, unplug the AC adaptor and remove all  
the batteries. After all the indications in the  
display disappear, plug the power cord and  
insert the batteries again. If the problem persists,  
please consult your nearest Sony dealer.  
Design and specifications are subject to change  
without notice.  
Notes  
• Replace the batteries when the OPR/BATT indicator dims or when the player stops operating.  
Replace all the batteries with new ones.  
• To use the player on batteries, disconnect the AC power adaptor from the player.  
There is no audio.  
• Adjust the volume.  
• Unplug the headphones when listening  
through speakers.  
Optional accessories  
Sony MDR headphone series  
Noise is heard.  
• Someone is using a portable telephone or  
other equipment that emits radio waves near  
the player. tMove the portable telephone,  
etc., away from the player.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Sentry Industries CRT Television PT40 User Manual
Snell Acoustics Speaker AMC 2000 User Manual
Sony Digital Camera 116 User Manual
Sony Stereo Receiver BKMFW50 User Manual
Sony Stereo System CDP CE235 User Manual
Speco Technologies Home Security System CVC627VFSCS User Manual
Speco Technologies Security Camera CVC71HRB User Manual
Sunbeam Blender PB7600 User Manual
Sylvania Digital Photo Frame SDPF872 User Manual
Sylvania VCR C6240VE User Manual