Indoor/Outdoor Electric Patio Heater
Model No: HP2-15-50
Operating Instructions
3098007
HP2-15-50
© 2007 Soleus Air International
Download from Www.Somanuals.com. All Manuals Search And Download.
14. To avoid fire or shock hazard, plug the unit directly into a 120 V AC electrical outlet.
15. To disconnect heater, turn controls to OFF, then remove plug from outlet. Pull firmly on the plug, DO NOT unplug by
pulling on the cord.
16. Always unplug the unit before moving or cleaning, or whenever the heater is not in use.
17. Use only for intended household use as described in this manual. Any other use not recommended by the manufacturer
may cause fire, electric shock, or injury to persons. The use of attachments not recommended or sold by unauthorized
dealers may cause hazards.
18. Always use on a dry, level surface. Use on floor only.
19. WARNING: To reduce the risk of fire or electric shock, DO NOT use this unit with any solid-state speed control de-
vice.
20. DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void your war-
ranty. The inside of the unit contains no user serviceable parts. Qualified personnel should perform all servicing only.
21. Connect to properly grounded outlets only.
22.SAVE THESE INSTRUCTIONS.
WARNING: This heater has a voltage rating of 120
volts. The cord has a plug as shown in A. An adapter as
shown in C is available for connecting three-blade
grounding-type plugs to two-slot receptacles. The
grounding lug extending from the adapter must be con-
nected to a permanent ground such as a properly
grounded outlet box. The adapter should not be used if
a three-slot grounded receptacle is available.
DO NOT DEFEAT THE SAFETY PURPOSE OF
THE GROUNDED PLUG.
SPECIFICATIONS
Voltage Rating
Power Consumption
Unit Size
120 V (60Hz)
700/800/1500W
24 in. (W) x 24 in. (D) x 36 in. (H)
19 lbs
Unit Weight
3
Download from Www.Somanuals.com. All Manuals Search And Download.
PRODUCT DIAGRAM
Heater Head
Control Switches
Base Pole
Decorative Cone
Weighted Base
4
Download from Www.Somanuals.com. All Manuals Search And Download.
ASSEMBLY
PARTS
Remove all contents from the packaging.
The packaging includes the following items:
A
A) 1 Heater head
B) 1 Weighted Base
C) 1 Decorative Cone
E
D) 1 Base Pole
E) 2 Heater Head Connector Screws
F) 3 Base Bolts
C
G) 3 Nuts for the base bolts
H) 1 Assembly Wrench (Not Pictured)
I) 1 Allen Wrench (Not Pictured)
D
F
NOTE: The screws, bolts, assembly wrench,
and Allen wrench are wrapped in a plastic bag
and placed on the underside of the Styrofoam
next to the weighted base.
B
G
5
Download from Www.Somanuals.com. All Manuals Search And Download.
BASIC ASSEMBLY
To properly assemble this heater you need the supplied assembly wrench and Allen wrench (or one of your
own). Refer to the parts diagram on page 5 while assembling the heater.
PLEASE NOTE: The design of the base in the images below will slightly differ from the base provided with
the heater.
1) First, attach the base pole (D) to the weighted base (B) using the 3 base bolts (F) and 3 nuts (G). Once you
secure the base pole (D) to the weighted base (B), place the decorative cone (C) over the base pole (D) to
cover the bolts on the base.
2) Next, place the power cord attached to the heater head (A) through the middle of the base pole (D). Pull
the power cord through the bottom of the base as far as it will go.
3) Next, connect the heater head to the base pole. To do this, align the small screw holes on top of the base
pole (D) with the holes on the bottom of the heater head (A). Use the small heater head connector screws
(E) to secure the heater head (A) to the base pole (D).
6
Download from Www.Somanuals.com. All Manuals Search And Download.
BASIC ASSEMBLY (CONTINUED)
4) Before using the heater, align the power cord with the cutout on the weighted base and secure using the
attached fasteners on the bottom of the weighted base. There is one fastener located near the middle of the
weighted base, and another fastener located near the cutout at the end of the base. Place the cord through
each fastener and tighten to secure the cord to the base. After securing the power cord to the fasteners,
place the rubber ring located around the power cord in the cutout on the weighted base. Properly attaching
the power cord to the weighted bases will allow the heater to be moved easily and prevent damage to the
power cord.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
OPERATING INSTRUCTIONS
Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet. Only operate the
heater when it is in the upright position and the base is attached. Refer to the diagram below.
The HP2-15-50 Electric Patio Heater is equipped with three heat settings; Low, Medium, and High.
• To operate the heater on low, press the red switch on the right. This switch will have a single white dot
near the top. Once the low switch is pressed, the smaller bottom heating element will glow and radiate
heat.
• To operate the heater on medium, press the red switch on the left. This switch will have two white dots
near the top. Once the medium switch is pressed, the larger top heating element will glow and radiate heat.
• To operate the heater on high, press both the low and medium red switches. This will cause both the
bottom and top heating elements to glow and radiate heat.
HEATER CONTROLS
8
Download from Www.Somanuals.com. All Manuals Search And Download.
MAINTENANCE
Unplug the unit and let it cool completely.
• To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a
mild detergent if necessary. After cleaning, dry the unit with a soft cloth.
• DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the
heater. This may cause damage or deterioration to the surface of the heater.
• Although this heater is outdoor approved, DO NOT immerse the heater in water for your safety.
Wait until the unit is completely dry before use.
WHEN THE HEATER IS NOT IN USE
When not using the heater for an extended period of time, place the electrical cord inside the decorative cone
that covers the bottom part of the pole. To do so, simply lift the cone and wrap the electrical cord around the
bottom pole. When the cord is completely wrapped around the pole, slide the cone back down covering the
cord and bottom of the pole.
STORAGE
If the heater will not be used for a long period of time, store it in a cool, dry location when not in use. To
prevent dust and dirt build-up, use the original packaging to repack the unit.
TROUBLESHOOTING
If the heater will not operate, please check the following before seeking repair of service:
• Check if the power cord is plugged into an electrical outlet, if not, plug in.
• Check if electricity to the main fuse is working.
• Make certain the power switches are turned on. If not, choose a setting.
9
Download from Www.Somanuals.com. All Manuals Search And Download.
WARRANTY
One Year Limited Warranty
Soleus International Inc. warrants the accompanying Soleus Air HP2-15-50 Electric Patio Heater to be free of defects
in material and workmanship for the applications specified in its operation instruction for a period of ONE (1) year
from the date of original retail purchase in the United States.
If the unit exhibits a defect in normal use, Soleus International Inc. will, at its option, either repair or replace it, free of
charge within a reasonable time after the unit is returned during the warranty period.
As a condition to any warranty service obligation, the consumer must present this Warranty Certificate along with a
copy of the original purchase invoice.
THIS WARRANTY DOES NOT COVER:
•
Damage, accidental or otherwise, to the unit while in the possession of a consumer not caused by a defect in
material or workmanship.
•
Damage caused by consumer misuse, tampering, or failure to follow the care and special handling provisions
in the instructions. This includes dents, accidental or otherwise, to the base and head of the unit.
•
•
Damage to the finish of the case, or other appearance parts caused by wear.
Damage caused by repairs or alterations of the unit by anyone other than those authorized by Soleus Interna-
tional Inc.
•
Freight and Insurance cost for the warranty service.
ALL WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANT ABILITY ARE LIMITED TO
ONE-YEAR DURATION OF THIS EXPRESS LIMITED WARRANTY. SOLEUS INTERNATIONAL INC.
DISCLAIMS ANY LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES AND IN NO EVENT
SHALL SOLEUS INTERNATIONAL INC’S LIABILITY EXCEED THE RETAIL VALUE OF THE UNIT FOR
BREACH OF ANY WRITTEN OR IMPLIED WARRANTY WITH RESPECT TO THIS UNIT.
This warranty covers only new products purchased from our authorized dealers or retailers. It does not cover used, sal-
vaged, or refurbished products.
As some states do not allow the limitation or exclusion of incidental or consequential damages, or do not allow
limitation on implied warranties, the above limitations and exclusions may not apply to you. This warranty gives you
specific legal rights, and you may also have other rights that vary from state to state.
For Technical Support or Warranty Service
Please Call (888) 876-5387
Or Write To:
Soleus International Inc.
9451 Telstar Ave.
El Monte, CA 91731 USA
10
Download from Www.Somanuals.com. All Manuals Search And Download.
|