Please read Owner’s Manual carefully
before operating the unit.
Download from Www.Somanuals.com. All Manuals Search And Download.
Use
RT-135 series air-condition have the capability of cooling / heating / ventilation and
dehumidification and contain the character of resisting shake attrition and high-dependability. It
can be used for applications such as RV units, trucks & vans, small-scale shipping vehicles & farm
equipment.
Structure and character
Structure
This air conditioning is in the top of structure
Main components include evaporator, condenser, compressor, throttling device, air blower
system, protection cover, tunnel and the control panel in main cabin.
Character
1) Instant cooling/adjustable temperature: It can reduce the environment temperature in a
short time in order of passenger’s demand.
2) Continuously running in adverse condition.
3) Lengthy continuously running time in acid and alkali condition.
4) The Width & Height capability : The appearance and assembly size keep the same with
present products on the market and helps keep air flow fluent.
5) Quiet operation: Improve comfortableness, low noise.level.
6) Delay start: With sudden loss of power and rapid reset, compressor is time delayed for 3
minutes for protection
Control panel
2
Download from Www.Somanuals.com. All Manuals Search And Download.
Remote device
Operation through the control panel or remote device
Through the control panel in the room, user can control all functions of the air-conditioner. The
parts of control contain the following functions:
1. Switch
The air-conditioner can be started or stopped by the button “ON/OFF”. The indicator lamp
“POWER” in the upper left corner is lighted when air-conditioner is running.
2. Choose button “MODE”
This button confirms the working status of the air-conditioner.
You can switch it in:”FAN” state, “COOL” state and “HEAT” state.
3. Temperature setting button “TEMP”
Through buttons “▲” and “▼”, you can increase and reduce the setting temperature in the
room.
4. Fan speed switch button “SPEED”
You can switch fan speed in “HIGH” or “LOW”.
5. Temperature showing “temperature”
In holding state, control panel shows present indoor temperature. The control panel shows
temperature in setting state. If you don’t press the “TEMP” key more than ten minutes, the
control panel will be back awaiting state and show present indoor temperature.
6． Push“SPEED+MODE”(in the control panel) or “SET”(in the remote device) into setting state
In this state you can set parameter with “▲” and “▼”.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
The scheme of refrigeration system
CONDENSER
EVAPORATOR
FAN
COMPRESSOR
THROTTLE
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Schematic circuit diagram
FU2
+5V
GND
A
B
com
on
C
G
DAT
CLK
REC
KEY
WAT1
WAT2
SENSOR1
SENSOR2
FU3
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Cautions
1. In any case the compressor will restart 3 minutes after power failure
2. The air-conditioner adopts three core plugs: Modification will void warranty
3. Working voltage of the air-conditioner must keep within the range of 115VAC±10. If the
voltage is too high or low will lead to damage of the compressor.
4. The normal working environment temperature of the air conditioner is: 0F to115F
Maintenance and Safeguard
It will keep at maximum performance ratings if you perform routine maintenance. After running
for 90 days, you must clean up dust around the fins of the heat exchanger in order to keep
refrigeration performance at optimum
TROUBLE SHOOT CHART
Problem
Possible Cause
Solution
Doesn’t cool / heat
1. The voltage of the power Adjust the voltage range into
is lower than 97V
2. You are using
normal demand.
an Do not use an extension cord.
extension cord for the unit
3. The system leaks Fluorine Call repair technician
4. Button “ON/OFF” failure
Replace button “ON/OFF”.
5. Set the temperature to the Refer to operation explanation.
abnormal position.
6. Compressor not working.
Turn off for ten minutes. Turn
back on
7. The sub cooling of Call repair technician
compressor is protected
and does not work
8. Capillary is blocked
Call repair technician
Inadequate cooling
1. The evaporator and/or Clean the evaporator and
condenser are blocked by condenser.
debis .
2. The doors and windows Reduce times that open the
have opened frequently.
3. Heat load is too high.
door.
Installation of larger unit.
4. Set temperature is in Adjust the set value.
improper position.
5. Capillary is blocked.
Call repair technician
6. The refrigeration system Call repair technician
has failed.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
No heat
1. Power is off.
Check the circuit
2. Set temperature is in Adjust the set value
improper position
3. Connector has fallen off.
4. Heater is defective
5. Fuse is open.
Tighten the plug.
Change the heater.
Change the fuse.
6. Control panel is not Change the circuit panel.
working.
The fan doesn’t operate
1. Control panel is faulty.
Change the panel.
2. The capacitor of fan Change the capacitor.
defective.
3. Fan defective.
Unusual sound or heavy 1. Installation
Change the fan.
the Check Installation.
too
of
shaking
air-conditioner
gradient.
2. Fan touches with other
hardware.
Adjust the fan position.
3. The connective pipelines Adjust the position between
collide with each other. the pipelines.
4. The part becomes flexible. Tighten screws.
Installation
1. Installation preparation
If you need to install the air-conditioner on already existing roof vent, the measure of vent
must reach 14×14 (in). If it is not enough of this measurement, you must extend this
measurement. If it is larger than this measurement, you must make a wood frame for the vent
to meet above measurement.
The gradient of install the platform must no more than 5°. If greater than 5° it can be
influenced that condensation water of the air conditioner could overflow.
You must avoid any wire and any pipeline before incision.
2. Please directly install the top of the air-conditioner on the placket and make windward face
toward the front of the vehicle, condenser toward the back of the vehicle. Put the seal
between air-conditioner and placket, and you can sight the four M10 install bores in the
air-conditioner bottom. To those irregular coarse roofs you must have sealant seal up all gaps
in order to prevent rainwater infiltrating into room.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
3. You must make mounting hole on indoor installation frame align with the hole on the top of
the air-conditioner and tightly connect with 4-M10 special screw.
4. Install canvas-pipe
You must make the flange of the canvas-pipe align with air outlet of the top of air-conditioner
and connect them with screw, gasket, spring gasket and nut.
8
Download from Www.Somanuals.com. All Manuals Search And Download.
5. Prepare installing of indoor equip: Disassemble the indoor equip.
6.
Install the indoor unit
a) You must install the main of indoor tunnel and installation frame with four ST4.2X16
screw.
Caution: It can be rotated from +90°to -90°.
b) Installing the canvas pipe underparts
You must put into metal flange from canvas pipe under part and tightly nip main vent-pipe
and connect with ST4.2X16 screw. The surplus part is cut out.
c) Install covers board of vent-pipe and indoor main cover board.
d) Connect indoor plastic and gold with two M4×10 screws, gasket and spring gasket.
9
Download from Www.Somanuals.com. All Manuals Search And Download.
Check
1. Check the complete installing manual to make sure unit is installed correctly and safe
2. Switch on the power, operate the air conditioner according to above methods. If it runs
improperly, for example abnormal noise, running current too high or no temperature, please check
owner’s manual.
10
Download from Www.Somanuals.com. All Manuals Search And Download.
3. Clean up the installing rubbish and restore decoration to original decor.
11
Download from Www.Somanuals.com. All Manuals Search And Download.
Warranty
LIMITED WARRANTY
Soleus International Inc. warrants the accompanying Soleus Air RT-135 Roof Top Air Conditioner to
be free of defects in material and workmanship for the applications specified in its operation
instruction for the period of labor and parts specified below.
PARTS
5 YEARS FOR COMPRESSOR
1 YEAR FOR OTHER COMPONENTS
This warranty shall not apply to broken or marred cabinets, accessories, knobs, filters or routine
maintenance. This warranty does not apply to uncrating, setup, installation, removal of the product
for repair or reinstallation of the product after repair..
This warranty does not apply to repairs or replacements necessitated by any cause beyond the control
of Soleus International including, but not limited to, any malfunction, defect or failure caused by or
resulting from unauthorized service or parts, improper maintenance, operation contrary to furnished
instructions, shipping or transit accidents, modification or repair by the user, abuse, misuse, neglect,
accident, incorrect power line voltage, fire, flood or other Acts of God, or normal wear and tear.
Warranty service must be performed by a qualified HVAC contractor. Soleus maintains a centralized
service network to provide parts and assist in resolving service problems if difficulties are encountered.
Soleus agrees to provide service information, sell repair parts and reimburse the dealer / service agent
for parts and services in accordance with Soleus International’s Policies and Procedures. All labor
charges must be pre approved in writing.
SOLEUS INTERNATIONAL MAINTAINS THAT ALL WARRANTIES, INCLUDING
IMPLIED WARRANTY OR MERCHANTABILITY ARE LIMITED TO THE TERMS AND
CONDITIONS SPECIFIED ABOVE. SOLEUS INTERNATIONAL DISCLAIMS ANY
LIBILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES AND IN NO EVENT
SHALL SOLEUS INTERNATIONAL INC.’S LIABILITY EXCEED THE RETAIL VALUE OF
THE AIR CONDITIONER.
FOR CUSTOMER SERVICES, WARRANTY CLAIM AND PARTS PURCHASING, CONTACT:
Soleus International Inc.
Tel: 1-888-8 Soleus
Monday through Friday, 9:00 AM to 5:00 PM, PST
Email:
12
Download from Www.Somanuals.com. All Manuals Search And Download.
|